Question about 2003 Hyundai Tiburon

1 Answer

I have a Tiburon gk 2.7 and it was running just fine but I pulled in to a parking lot and it die. I tested for the codes and it came up with po340 as that is the camshaft position sensor. So I put in a new one and it still will not start up at all. Need Happy

Posted by on

  • thepatchman1 Aug 05, 2010

    Thanks I will give that a try in the morning and let you know. I know I can tell if it is hitting the sensor but how you tell how much to have it away from the cam ? As I did clear the code and waited 30 then try to start But didn't work.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,016 Answers

Hi,

You need to ensure that the camshaft sensor is installed correctly.
Make sure that it has not bottomed out or is to far from the indicator on the camshaft.

If all this is ok, then you need to clear the fault code from the ECM and then turn engine off for 30 sec. once this is done then you will need to see if the same fault code returns.

Try these and let me know.

Thanks

Jason

Posted on Aug 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 03 Hyundai Tiburon it want fire the battery went dead I replaced it it turns over fine but it want start no fire what could be the problem


assuming a lot , try some things
look up the crank sensor it all starts there.
how to test it depends on even more ,
try simple things 1st
open gas cap to release pressure
put in new gas
smell the exhaust , does it have any gas smell
smell the oil an look at it , has gas or water in it or very dirty.
smell the transmission fluid for burning smell , <just for info
see that it has spark , listen to them on the am radio static or pull one an let it spark to ground. use a screwdriver. stick you finger up it replaced battery means it might have died in a zap. check the fuses.
check for aux power wire fuses .
open the air filter and spray in 1oz fuel only to see if it changes at all ,not to start it ..

Apr 24, 2015 | 2003 Hyundai Tiburon

2 Answers

Why does my 93 Honda Accord run fine and then dies going down the road and will start again and die again?


There is a black fuel relay way up under the top left driver side dash that breaks its main wire solder connections on the circuit board under over-heat conditions. Resolder that relay. Starting fluid will show that you have lost fuel delivery under no start conditions. You can use the breather hose from the valve cover for this test.

May 12, 2014 | 1993 Honda Accord

1 Answer

Car stalls, starts up then stalls again, starts up and stalls again


This could have several problems. #1 Fuel pressure due freezing water in fuel lines add thermal aid or rubbing alcohol . If you have access to a pressure gauge there is a service fitting on fuel rail that you can test pressure while driving and see if the pressure is gone when car dies this could lead to fuel pump electrical or more restricted lines. #2 intermittent sensor failure Mopar uses 2 sensors to control spark and fuel lose one could lose spark lose the other lose injection with a scanner they call it C/C sync ok (cam/crank) if no then check for each parameters for display.# 3 relay controls ASD and FUEL pump for voltage drops.

Apr 18, 2014 | 1997 Dodge Stratus

1 Answer

Vacuum diagram for a 2004 tiburon


There is only 4 vacuum lines on that engine

1- brake booster line

2- purge line to purge solenoid (top center of throttle body)

3- PCV hose. run straight from PCV to side of intake at base of throttle body

4- fuel pressure regulator line (short small diameter hose runs from #6 intake runner to fuel pressure regulator

5- tube that connects front cam cover to rear cam cover to improve vapor venting

http://www.hyundai-forums.com/attachments/gk-tiburon-coupe-s111-2003-2008/38204d1276396353-vacuum-lines-2004-tiberon-pict0001.jpg

Jun 25, 2012 | Hyundai Tiburon Cars & Trucks

1 Answer

I recently bought a 1991 Ford Bronco to fix up. I got it running, and shortly after it died while I was pulling into a parking lot at work. It wasn't starting. Had the battery tested and it was fine....


That sounds like a bad ignition switch, which is located in the steering column on the right hand side, hope this helps, should fix both problems.

Jan 29, 2011 | 1991 Ford Bronco

1 Answer

01' A/T tiburon won't back up, it will drive but not reverse.


its a operating solonoid and its inside the gearbox on the control panel ,but the parts are not sold by the dealer only an exchange gearbox complete ,the only parts sold by the dealer are some of the rubber hoses .

Mar 15, 2010 | 2001 Hyundai Tiburon

2 Answers

99 Tiburon wont start.


first check to see if you have spark if you do try the cam sensor that tells you injectors when to work

Aug 20, 2009 | 2004 Hyundai Tiburon

1 Answer

Lumina Starting/Dying Problem


this could be one of the two things that I am thinking it is...it is either the throttle position sensor or it si the fuel pump getting too hot and cooling off slightly enough to restart the engine. Both are related but separate systems. The throttle position sensor is on the side of the throttle body and it merely tells the computer where the throttle plate is in the throttle body to create the proper fuel mixture for the injectors. The fule pump ios loccated insid eof the fuel tank it either runs or it doesnt usually. If it gets hot it is about to go completely out all together.

Aug 08, 2008 | 1991 Chevrolet Lumina

Not finding what you are looking for?
2003 Hyundai Tiburon Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...