Question about 2000 Buick LeSabre
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
The heater core is located under the dash, in the center. The container holding the core looks like a black plastic box. Remove the ash tray for easier access. You may have to also remove some other covers under the dash. You must first drain the radiator then you have to disconnect the hoses. There are two hoses connected to nipples of the heater core that go thru the center of the firewall. Remove the screws that hold on the cover to the heater core. Then you should be able to get the old one out. There might be a couple of other minor steps but I'm sure you can figure them out. For re-installation just go in reverse order to put it all back together.
Posted on May 25, 2009
I have a 1995 and 1999 LeSabre and the radio removal is the same on both.
1. Carefully remove the AC vents from the dash.
2. In each of the AC openings are screws that hold the top of the dash trim in place.
3. Starting from the passenger door gently pry off the "wood" trim piece, It is held in place with metal clips and velcro.
4. Do the same as 3 from the driver side (short piece).
5. Remove the remaing screws from the bottem of the dash.
6. Move the Shift knob (requires key) all the way down.
7. Starting at each end of the dash slowly pry/pull each clip along the top of the dash from its mounting hole. Be careful not to crack the silver trim piece on the top of the dash (especially on top of the passenger airbag).
8. When the dash is free tilt the top in towards the car and wiggle it loose around the bottom (over the steering column) and the whole piece should come free.
This gives access to the radio, heater controls, speedo etc.
For the radio - three screws - antenna cable pop out. The harness needs a little more work. If your radio has a security feature (blinking light when car is off) make sure you know the security unlock code. Test the code before pulling the power to the radio.
Turn the radio over and carefully unlock the blue clip at the bottom of the plug. Then work the harness loose.
This sounds much worse than it is - it should take 15-30 minutes depending if you have all the tools close by. BTW those AC vents have a top and bottom - the larger hole goes on the bottom and they snap back in place.
Posted on Jul 25, 2009
the bolts you are looking to remove are located on the top of the light housing. It only takes 2 of them to remove the housing. One is about 6 to 8 inches long, and the other one is much shorter than that. Just unscrew and remove them, and pull the housing straight out.
Posted on Aug 31, 2009
Testimonial: "Thanks a bunch!"
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls
Posted on Sep 23, 2009
Yes it's on the right side othe transmission just above the passenger side cv axle. You most likley need to send the cluster off and have it checked. Model Electronics in NY.
Posted on Oct 09, 2009
Tips for a great answer:
Mar 06, 2015 | 2004 Buick LeSabre
Nov 08, 2014 | 2001 Buick LeSabre
Sep 22, 2014 | 2001 Buick LeSabre
Feb 15, 2013 | 2001 Buick LeSabre
Sep 23, 2011 | 2003 Buick LeSabre
Dec 13, 2010 | 1986 Buick LeSabre
Mar 10, 2010 | 1989 Buick LeSabre
Jan 22, 2010 | 2001 Buick LeSabre
Jun 18, 2009 | 1994 Buick LeSabre
May 25, 2009 | 1994 Buick LeSabre
Aug 09, 2018 | 2000 Buick LeSabre
324 people viewed this question
Usually answered in minutes!