Question about 1999 GMC Yukon

Open Question

HOW TO REPLACE THE BULBS IN THE RADIO PRESET BUTTONS ON A 1999 GMC YUKON STOCK RADIO

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1596 Answers

SOURCE: Oil Pan Gasket Replacement - How to - GMC Yukon 2000








Removal Procedure

Important: The original oil pan gasket is retained and aligned to the oil pan by rivets. When installing a new gasket, it is not necessary to install new rivets.
DO NOT reuse the oil pan gasket. When installing the oil pan, install a NEW oil pan gasket.

Caution: Refer to Battery Disconnect Caution in Service Precautions.

  • Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure
  • Remove the front differential if equipped with four wheel drive. Refer to Differential Carrier Assembly Replacement in Front Axle.
  • Remove the under body shield from the vehicle
  • Remove the oil pan underbody shield.
  • Remove the cross brace if equipped.
  • Drain the engine oil and remove the engine oil filter. Refer to Engine Oil and Oil Filter Change
  • Remove the lower transmission-to-oil pan bolts
  • Disconnect the oil level sensor electrical connector.
  • Remove two front wiring harness retainer bolts.


10. Remove the engine wiring harness retainer bolts from the engine oil pan.
11. Remove the engine oil cooler pipe to oil pan bolt.
12. Remove the transmission oil cooler pipe retainer and the bolt from the oil pan.
13. Remove the starter motor. Refer to Starter Motor Replacement.
14. Remove the left closeout cover and bolt.
15. Remove the engine oil pan. Refer to Oil Pan Removal.

Installation Procedure

Important: The alignment of the structural oil pan is critical. The rear bolt hole locations of the oil pan provide mounting points for the transmission bellhousing. To ensure the rigidity of the powertrain and correct transmission alignment, it is important that the rear of the block and the rear of the oil pan must NEVER protrude beyond the engine block and transmission bellhousing plane.

Will Send Remainder in another this place dont take kindly to larg files Your Email Address would realy be Better Then I could send Pictures Also up to YOU

Posted on Jan 27, 2009

Ad
  • 366 Answers

SOURCE: what is the code to unlock the radio on a 2004 gmc yukon?

look in owners manual ! if u dont have 1 go see dealers service dept.

Posted on Apr 08, 2009

  • 102 Answers

SOURCE: Need color codes for radio in 2002 gmc yukon denali

2002 GMC Yukon Car Stereo Wiring Guide
Car Radio Battery Constant 12v+ Wire: Orange
Car Radio Accessory Switched 12v+ Wire: Yellow
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Brown
Car Stereo Dimmer Wire: Gray
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue

Posted on May 24, 2009

  • 7353 Answers

SOURCE: Replace headlamps 2007 GMC Yukon

It should be pretty easy, thats why there no "directions" Lift up the hood, now at the headlights there should be 2 rods, lift these rods and the lights should lift out, to access the bulbs.

Posted on Nov 06, 2009

  • 541 Answers

SOURCE: replace front left wheel berring on 2002 GMC Yukon

do not replace only the bearing. replace hub assembly. remove rim/tire , remove caliper, mounting plate, rotor. . un bolt hub assembly, unplug abs. remove front axle nut if 4x4. you may need to rent the axle nut remove kit and hub puller. pull out hub. drive axle reward out of hub. install new part. do not torque hub over 90lbs. check with parts sell for spec

Posted on Jan 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My brake lights are not working on a 1999 gmc Yukon I have replaced the brake light switch, bulbs, and fuse what else could keep my brake lights from not working


check your Head Light Fuses I know for some reason that Happen to me and I had to replace my head light fuses. I would also check the circurt line out and make sure its getting power to it.

Sep 28, 2014 | 1999 GMC Yukon

1 Answer

Instruction on how to change headlight bulbs on 99 gmc yukon?


You may have to get to them from under the hood behind the light unit.

Mar 18, 2013 | 1999 GMC Yukon

1 Answer

Security system will not disengage 1999 gmc tahoe


In order to get the radio code for your 4 door 1999 Saturn, press the preset buttons 2 and 3 down. It should be something like 6892.------------------------------------------------------------------------
tacho pro

Nov 29, 2012 | 1999 Chevrolet Tahoe

1 Answer

Some of my dashboard lights are out... ie; radio preset numbers, radio controls on the steering wheel, etc. Are there fuses I should be checking?


no they just go out they are little single L E Ds inside radio and controls on the steering wheel. As for the dashboard some of the light can be replaced with bulbs but there is also LEDs in there as well. Hope it helps

Jul 27, 2008 | 1999 GMC Sierra

Not finding what you are looking for?
1999 GMC Yukon Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...