Question about 2004 Pontiac Grand Prix

Open Question

My Service ABS, Service Stability Control, Service Traction Control, and Service Brake system all came up at the same time. Any suggestions?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: stability system

the service stability light as well as the abs light is all conected to the wheel sensor. To fix it is simple if you kn,w how to do a brake job,it is all conected to the hub assembly. I replaced both front wheel sensors due to that problem. you can by the hub assembly for around 100.00 dollars at auto zone. the wire that connects to the wheel always breaks and these codes come up.

Posted on Dec 29, 2008

Ad
  • 1 Answer

SOURCE: How do you reset service stability control & ABS

please send $100 to me and ill send you solution.. I was interested in your service until i heard some of your answers like requires expert must take to pro??? gee thanks for $15 advice

Posted on Sep 26, 2008

  • 1 Answer

SOURCE: service traction light comes on abs off and brake light come on on the dash

I had the same problem. I took off the tires and look at the wires, and both of the wires to the hub were broke. 10 min and some tape and problem was fixed.

Posted on Apr 02, 2009

wyatt1582
  • 453 Answers

SOURCE: abs and traction control light faults after a brake job. 2005 Pontiac grand prix

You have a bad sensor at one of the tires that need replacing that operates ABS and traction control. If you take it in to a shop it will run $130 but they can find which sensor is causing the problem. But if you do it you might have to replace all 4 sensors to make sure you got the right one. Every hard to diagnoses. Its better for the shop cause they can get electrical read outs for each sensor.

Posted on May 21, 2009

  • 1 Answer

SOURCE: abs light/traction control light

You can check out what the trouble code is by pushing and holding the information button and the up arrow (right side of instrument cluster above the radio) until all the instrument clusters light. Press the information button (last) to enter test mode. I've had an error C1234, meaning Left rear wheel sensor fault. I found the problem to be a corroded connector under the chasis just under the rear left door about 2 feet in. I had to by-pass (replace 1 wire due to corrosion at the connector.

Posted on Sep 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2006 Cadillac STS is braking by itself with all these lights on..stabilize stability system brake assist..etc what is going on could someone help


problem usually narrows down to abs system problem or hub failing causing problem with abs --have vehicle scanned for the trouble code it will assist you as where to start in repairing problem most auto stores offer this service for free --in the mean time pull the abs fuse so brakes can revert to a normal non abs system till repairs can be made

Jun 04, 2017 | Cadillac Cars & Trucks

1 Answer

Can you help with multiple electrical issues??


This vehicle is equipped with the BOSCH 5.3 antilock braking system.
The vehicle is equipped with the following braking systems:
• Antilock Brake System (ABS)
• Dynamic Rear Proportioning (DRP)
• Traction Control System (ETS) (w/NW7)
• Traction Control System (TCS) (w/NW9)
• Vehicle stability enhancement system (VSES) You need to have vehicle checked for DTC'S diagnostic trouble codes , do you know what they are ? The traction control , ABS an stability control are all a function of the electronic brake control system .It also seams the power steering is controlled by the Antilock brake system.The Magnasteer® is controlled through the ABS module and varies the torque by adjusting the current flow through the actuator.
Your best place to start would be to have ABS module scanned for DTC'S . Codes would point you in right diagnostic direction .
The following components are involved in the operation of the above systems:
• Electronic Brake Control Module (EBCM), The EBCM controls the system functions and detects failures.
The EBCM contains the following components:
- System Relay, The system relay is energized when the ignition is ON and no ABS DTCs are present. It supplies battery positive voltage to the solenoid valves and pump motor.
- Vent Tube, The vent tube, located in the EBCM, is an opening to the internal cavity of the EBCM. It allows ventilation of the EBCM internals.
• Brake Pressure Modulator Valve (BPMV), The BPMV contains the hydraulic valves and pump motor that are controlled electrically by the EBCM. The BPMV uses a 4 circuit configuration with a diagonal split. The BPMV directs fluid from the reservoir of the master cylinder to the left front and right rear wheels and fluid from the other reservoir to the right front and left rear wheels. The diagonal circuits are hydraulically isolated so that a leak or malfunction in one circuit will allow continued braking ability on the other.

Mar 01, 2016 | 2005 Pontiac Grand Prix

1 Answer

Trac control light on & anti lock lite came on same time stays on


That means there is a problem with the ABS , has DTC'S - diagnostic trouble codes in the EBCM - electronic brake control module . You need to have diagnostics run on it !
Traction Control/ Stabilitrak Off: Refer to ABS Description and Operation in Antilock Brake Systems
This vehicle is equipped with the BOSCH 5.3 antilock braking system.
The vehicle is equipped with the following braking systems:
?€¢
Antilock Brake System (ABS)


?€¢
Dynamic Rear Proportioning (DRP)


?€¢
Traction Control System (ETS) (w/NW7)


?€¢
Traction Control System (TCS) (w/NW9)


?€¢
Vehicle stability enhancement system (VSES)

Oct 04, 2015 | 2004 Pontiac Grand Prix GTP

1 Answer

6 mont a go


Is the ABS light on also?
Traction control systems use the anti-lock brake system to achieve stability. If the ABS system is not functioning correctly, it will render the stability control system useless, since they are, essentially, the same system.

Apr 26, 2014 | 2004 Ford Freestar

2 Answers

ABS/ Traction control light/BAS & brake light on in 2008 dodge grand caravan


It is safe to drive. You need a scan tool to get a code out of it. Could be as simple as a wheel speed sensor going bad. All of these lights will work together normally. The traction control uses the ABS to gain traction, and the Brake Assist System is part of the stability control. Also uses the ABS.

Oct 03, 2012 | 2008 Dodge Grand Caravan

1 Answer

ABS pump and relay


First of all, make sure that your brake fluid level is correct. The brake, traction, and ABS systems on these cars all work together and if one thing goes wrong in any one part of the system, all of those lights will come on at the same time. Check your brake fluid level and be sure to use the correct DOT 3 brake fluid. DO NOT SUBSTITUTE with any other fluid. Let me know if your brake fluid level is ok and we'll go from there.

Aug 15, 2012 | 2001 Oldsmobile Aurora

1 Answer

Leaking brake fluid from modulator valve


The brake pressure modulator valve is the heart of the abs and traction control systems. A fault in this part would cause the abs and traction control lights to come on as well as the service stability system. If this valve fails, the wheels could possibly lock up. If you were to experience the wheels locking up, you should pump the brakes to regain control over the vehicle.

Dec 21, 2011 | 1989 Ford Ranger

3 Answers

Servicing stability system


probably a reprogram at gm dealer.

Feb 24, 2010 | 2004 Buick Park Avenue

Not finding what you are looking for?
2004 Pontiac Grand Prix Logo

Related Topics:

470 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...