Question about 1997 Chevrolet K1500

1 Answer

1997 chevy silverado when i push on brake there is an air sound from under the dash

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Leaking vacuum booster

Posted on Aug 04, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i turn my stop lights off on my chevy Silverado that won't turn off?


Replace the brake switch. Located at the brake pedal arm, under the dash.

Mar 14, 2015 | Chevrolet Silverado Cars & Trucks

2 Answers

I have a 1994 Chevy Silverado and every time I turn on the ignition, the knocking noise begins from under the dash somewhere. If I remove the fuse to the a/c/heater it doesn't make a sound when I


Try starting the truck so it makes the noise.
Then switch the air control to "fresh".
If noise stops, it is probably the motor that closes flap to recycle the cab air.
It would be found under the dash, under the glove box, & would need to be replaced.

Sep 20, 2012 | Cars & Trucks

1 Answer

I have a 1997 CK3500 chevy silverado ,extended cab,4x4 1 ton dually...when I have my foot on the brake while I turn the truck off and take the key out of the ignition the truck continues to run until I...


The only thing I can think of is you have a short between the brake wire going to the brakes and the ignition wire that is designated for run. Melted wires touching each other. This would be the only explianation. Because these two wires are only close to each other in the harness. And ofcourse these two wires run under the dash and in the engine compartment. Time to start splitting the harness. I would probbly start under the dash, get the hard part out of the way. Good luck.
Randy

Aug 24, 2011 | 1997 Chevrolet C/K 3500

1 Answer

2003 Chevy Silverado SS brake lights aren't working but top cab brake lights are. Bulbs in brake lights are working, and light up when headlights are turned on, but do not get brighter when brake pedal is...


Sounds like the turn signal flasher module has gone bad. It controls the brake lights and turn signals. It is located under the drivers side of the dash. If is a rectangular black box with a grey connector and 8 or so wires connected to it.

Oct 05, 2010 | 2003 Chevrolet Silverado 1500

1 Answer

1999 Silverado 1500: does my chevy 99 1500 come with trailer brakes...


if its set up for trailers with brakes, it should have small black box under the dash above the pedals; if there is one you can adjust the brake timing to syncronize the trailers brakes with the trucks; if there is not one you can purchase one and mount it and run a few wires

May 17, 2010 | 1999 Chevrolet Silverado 1500

2 Answers

1999 Chevy Silverado - 3rd Brake Light Inop


if you can trace the wires and look for a loose jack or broken wire

Sep 16, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

Brake push rod


You will need to remove the the retainer clip and remove the brake switch and the rod will then slide off the pedal pin.

Jul 19, 2009 | 1997 Chevrolet C1500

1 Answer

No tail lights on 1991 Chevy Silverado. fuse is good


sounds like a broken wire in the harness. look around the bumper area,sometimes along the frame. may have to peel back some tape covering. also if you have a trailer harness look closely at those.

Jun 04, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

Brake lights dont work but the other tail lights do


Check the brake light switch under the dash attached to the brake peadal arm. It is wher the break booster push rod attaches. Sometimes that switch works loose.

May 18, 2009 | 1996 Chevrolet K1500

1 Answer

What does 1997 Chevy Silverado Shift Actuator do ?


the first thing i would try is to chg the neutral safety switch located under the dash on the steering column.

Apr 21, 2009 | 1999 Chevrolet Silverado 1500

Not finding what you are looking for?
1997 Chevrolet K1500 Logo

Related Topics:

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...