Question about 1995 Honda Accord

1 Answer

I have a 1995 honda accord it has 210,000 miles on it i replaced,spark plugs,wires,dist. cap,rotor,thermostat,valve gasket and alternator since ive had it for 4 months,prior to doing this the car has ran fine..ive since replaced the heater hose as it was leaking coolant through there and eventually had hole busted through it after doing all this i washed the engine with engine bright and a few days after that the oil light has started to come on after driving it for about 3 miles or so,can it be that it is lighting up cause i washed the engine? or something else? like the oil pressure switch? prior to fixing the heater hose i was losing alot of coolant now i add some maybe every 3 weeks or so..any help will be greatly appreciated..thanks

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 90 Answers

The oil pressure sensor is locatred on the back side of the engine above the oil filter kinda by the fire wall and under the intake manifold. check for a lose wire. but they do go out from time to time so you might need to replace it

Posted on Aug 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

High Idle


Replace plugs and wires.

May 25, 2013 | 1992 Honda Accord

2 Answers

Not getting any spark out of my plug wires already replaced coil, main relay,and ignition module. could it bemy rotar or distrbut


The Honda system uses a coil that mounts inside the dist, right ?
If you can check voltage output at the coil tower with the cap off you can find out if the coil is firing. If it is, then yes the rotor could be the problem. The voltage has to go thru the cap to the center of the rotor then to each plug terminal. The spark can jump thru the rotor and ground thru the dist shaft.

Jun 23, 2012 | 1991 Honda Accord

1 Answer

My dodge 3500 van cranks but will not start


Check to make sure your fuel pump is pumping by having somebody turn the key to the acc on position not starting the vehicle, this should make a buzz sound, or check fuel pressure. If you are getting fuel, make sure you have spark. Could be the fuel pump or just a coil. Make sure all ground wires are tight. This would be a good time for a tune up. When my truck did this it was just a ground wire. The second time it was the connector to the coil. I replaced the spark plugs, wires, dist cap and rotor, coil, and pcv valve. Now everything is good. 1994 Dodge Ram 1500 with 210,000 miles.

Dec 28, 2011 | Cars & Trucks

1 Answer

Crv shut down oil cap lefted off and oil all over engine and truck shutn down checked and found oil fill the spark channel and boots so replace the gasket and plugs and cleaned off the wires and now have...


have you put a new set of plug wires on it. use a spark plug tester, and put it between plug wire and dist, cap. if it is sparking you will see it. if yes and not to plugs put on new plug wires. good-day ! if above checks out. remove dist, cap and see if shaft of dist, is turning. some of the hondas have a plastic type drive gear on bottom of dist, shaft. that goes bad.

Sep 21, 2011 | 2000 Honda CR-V

1 Answer

I have a 1995 honda accord 209,000 miles,my car leaks antifreeze out of the muffler whenever i refill it,but i dont see any white smoke or have had any problems with it overheating..i recently changed the...


There is NO way water can get inside the muffler / exhaust pipe without evaporating, and causing a white smoke at the tailpipe. Additionally, in order to get inside, you would get major power and idling problems. I would look at the cooling circuits near the firewall ( cooling hoses to the internal heater, for example) because one of them must be dripping water externally onto the exhaust pipe or muffler. If the car never overheats, there is a possibility that you are simply overfilling the cooling water bottle. The full mark for accord bottles, is waaay down, it looks as if the bottle was empty. As soon as the engine heats up, it will send excess water overboard.

Apr 19, 2010 | 2002 Honda Accord

1 Answer

Code P0420 - what does that mean? The car is an


Code P0420 probable cause, 1. Secondary HO2S (Sensor 2) or 2.Three Way Catalytic converter.

Aug 15, 2009 | 1997 Honda Accord

2 Answers

94 Honda Accord


sounds like the Ignition Control Module is bad, it's in the dist. I had the same problem with my honda

Jun 16, 2009 | 1992 Honda Accord

1 Answer

Honda Misses.


Pin point the dead hole and check that injector.

Dec 23, 2008 | 1995 Honda Accord

Not finding what you are looking for?
1995 Honda Accord Logo

242 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...