Question about 2005 Ford Ranger

1 Answer

It all started when I went off the road to avoid deer and it took a real bumpy beating, the engine light started flashing ang the a/c went out changed relay for the a/c pump and the a/c started working again. changed plugs and wires and it still had a missfire changed the coil pack and it ran good for 1500 miles then the same thing is happening all ver again.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,374 Answers

You have to determine which cylinder has the miss. This is done by a cylinder leakage test, injector balance test , compresson test and scope testing..
Unless you have the equiptment to conduct these test I suggest you take it to a repair shop and have then perform these test this way you know which cylinder is missing and why its missing(eg vacuum leak,injector failure,spark failure etc)

Posted on Aug 04, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2004 sienna hit bumpy corner express road at 45mph, seconds later the whole van shakes like I'm driving on 4 flat tires then vsc and check engine light comes on. The van refuse to move as if I


Hello


The Engine and Automatic Transmission (not applicable to manual transmissions) in this vehicles drive train are fully electronically controlled by a computer called the PCM and TCM (Power Train Control Module, Transmission Control Module). When a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always check fuel pressure for correct spec for your make and engine type.


Sep 20, 2012 | 2004 Toyota Sienna

1 Answer

2005 Nissan Xterra Shaking Problems.HELP?


each one of the cylinders have there own seperate coil, if cylinder 5 is misfiring then the coil is bad. One cylinder not firing will cause the vehicle to run really rough hope this is helpful

Jul 06, 2012 | 2005 Nissan Xterra

1 Answer

1996 318 i se battery went flat, replaced it now it wont start, got ignition lights but wont turn over


This is not a sloution but i had a similar problem about 6months ago. I left the lights on which drained the battery, road assistant came to booost start it, there was power but no turn over, not even a clunk of the engine trying ( all electrics are working and lights in the dash are live), tried a new battery same situation,
I took it to BMW independant specialist who put it down to a ECU fault , i was duped into having a new key made as i had no spare as it was believed the immobilizer had locked the car up so to speak, this didnt work , so the mech ordered a new ecu, and had it reprogrammed and it turned over first time, It was bumpy idling at cold start cos i had my original dead battery but after a day it ran like it used to sweet as a nut.
it was expensive 500 quid to put right, but then you may have better luck with your mechanic.

Jun 07, 2009 | 1996 BMW 318

1 Answer

Check engine light


probably injectors fit new fuel filter and add cleaner to system.

Feb 21, 2009 | 2001 Pontiac Montana

1 Answer

VSC and engine light on


The Trac light comes on automatically, in conjuction with the Check Engine Light. You need your vehicle scanned for DTC codes.

Aug 11, 2008 | 2008 Toyota Sienna

Not finding what you are looking for?
2005 Ford Ranger Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...