Question about 2005 Hyundai Tucson

1 Answer

Squeak on clutch pedal - 2005 Hyundai Tucson

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 4,793 Answers

Fitted as standard.....spray with silicon.

Posted on Aug 04, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Bled the clutch, happens lots of city driving, squeaks, then clutch pedal loses pressure, then comes back, fluid stays at same level.

If fluid level is full and there are no leaks, the most likely problem would be an internal clutch master cylinder issue. The internal seals of this cylinder may be causing a by-pass of the fluid causing a pedal/no pedal operation

Aug 29, 2015 | Cars & Trucks

1 Answer

Clutch pedal noise

This may be from a dry pivot bush or spring squeak. It can also be from a failing clutch master cylinder or a failing clutch cable

Apr 09, 2014 | Hyundai Motor 1995 Accent

1 Answer

Why does my clutch squeak when depressed

spring above the pedal might be dried as long as gears are engaging ok. nothing to worry about.
also check the clutch cable as well..

Mar 30, 2014 | 2006 Citroen Xsara Kombi

1 Answer

Squeaky clutch pedal

This is a common problem. Your clutch pedal has a return spring on it, each end of which can squeak when dry.
Look under the dash, and locate this. Dab a bit of grease at each end of the spring where it hooks around. Work the pedal up and down a few times and the squeak should go the way of the Honda Element.

Nov 28, 2011 | 2003 Honda CR-V

1 Answer

When pressing in the clutch and releasing it there is a squeaking/whining noise that is being made. it shifts fine and i am not dropping out of gear, but I am worried about the noise. do you have any ideas...

start by spraying some WD-40 on the hinges of the clutch pedal. this will eliminate if the squeak is coming from the pedal and not the clutch. now assuming that it does not eliminate the squeak then here's the next thing.the throw-out bearing is beat. you can replace that on its own but if you are going to go through the trouble of replacing the bearing you might as well do the clutch too....

Apr 18, 2011 | Nissan Pathfinder Cars & Trucks

1 Answer

1994 S 10 Clutch problem

up under the dash where your peddle is mounted there is a bushing try a little spray lube to quiet the problem

Aug 23, 2009 | Chevrolet Blazer Cars & Trucks

2 Answers

Inside hood latch broke, so how do i get under the hood of my 1995 chevy blazer

I would assume that the plastic handle broke from the cable? If so, try grabbing on the end of the cable with a pair of locking pliers. Latch onto the cable and hold the casing, then pull really hard. It should pop the hood. After you get the hood open, replace that cable, or if possible, leave the vice grips on it until you can get it to a shop to get it replaced.

Aug 05, 2009 | Chevrolet Blazer Cars & Trucks

2 Answers

When i step on the clutch pedal all the way in,it gets stuck, why?.... the tranny is good!


Jul 18, 2009 | 1991 Toyota Celica

3 Answers

I have a 1999 Saturn SL 5 speed manual transmission. When I press on the clutch is squeaks. In the past I put some grease on the shaft above the clutch petal, it worked - now it doesn't. It also seems to...

check for leaks on master cylinder if you haft to add brake fluid its definately leaking,throw out bearing maybe going out?may of glazed pressure plate? good luck!!

Jun 21, 2009 | 1999 Saturn SL

Not finding what you are looking for?
2005 Hyundai Tucson Logo

Related Topics:

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

81285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides