Question about GMC Envoy
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I am having the exact same problem with my 2001 Hyundai Elantra. I was told that the engine code that comes up when the sensor is on is called "Absolute Pressure In The Manifold". I was told by a "Hyundai Specialist" that when that code comes up it usually means that the seal on the manifold is Fuct. When my mechanic checked that out for me he had noticed that my manifold had 4 cracks in it(can varify cause he showed me). He replaced the manifold and gasket. The car ran fine for about 2-3 days and since then the problem has since come back and my check engine light will no longer go on/off it only stays on. Because of the check engine light always staying on I have noticed that on many occasions my car will hiccup many times in a row. The only way to stop the hiccup I have noticed is to take my foot right of the gas for approx. 2-3 sec then car will continue without hiccup(till it happends all over again). All in all I have been having this problem now for approx. 1 year and if there is somehow someway it could be repaired I would appretiate it.
Posted on Nov 06, 2009
I have a 1999 intrepid hat stalls out when i am driving mostly when driving slow would that be a crank position sensor?If not what could it be
Posted on Dec 07, 2009
It is a wiring fault, but they are looking on the wrong end. You will need to have a VW dealer "repin" the electrical connector at the throttle body. What this means is, the dealer will take apart the connector, cut off the old pins and crimp on new ones and reassemble the connector. This is a common problem on drive by wire VW's. The dealer has a bulletin on the problem and I don't know why they missed it. They will probably have to order the connector kit however. Good luck!
Posted on Sep 11, 2010
SOURCE: Stabilitrak remains on once I
stabilitrak system is controlled by the abs module. Its job is to maintain
vehicle stability in situations where you may normally lose control by
activating the abs system and/or changing the valving in the shock absorbers.
When the message is displayed there is a problem in the system, could be an
issue with a sensor or wiring. There are a couple of common problems with the
system that require reprogramming the engine control module and the abs module.
This must be performed at the dealer. The only way to know exactly what the
issue is would be to have the abs computer scanned for trouble
GM issued a couple of tech bulletins in regards to owners having this problem.
I hope this helps.
Posted on Jul 27, 2011
Tips for a great answer:
Apr 02, 2016 | 2008 GMC Envoy
Jan 05, 2016 | 2007 Chevrolet Equinox LS
Apr 29, 2015 | Cars & Trucks
Jul 25, 2014 | 2008 Pontiac Torrent
Sep 21, 2013 | Cars & Trucks
Jan 16, 2013 | 2008 Pontiac Torrent
Jan 08, 2011 | 2008 Chevrolet Suburban
Feb 25, 2010 | 2008 Chevrolet Suburban
Apr 28, 2009 | 2003 GMC Envoy
381 people viewed this question
Usually answered in minutes!