Question about 2001 Jeep Wrangler

Open Question

Need to replace a clutch kit in a 2001 jeep wrangler sahara. Detailed how to request.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
ford_67
  • 34 Answers

SOURCE: just replaced the water pump,

Check to see if the thermostat is installed correctly there is a certain way it goes the cooling system. Since you have had a lot of parts replaced could have air trapped in system this can cause overheating as well. Drain radiator leave cap of and start motor add water slowly until radiator is at the level recommended. Does car have white smoke comming out exhuast pipe this would be good indication of a blown head gasket. Hope this helps

Posted on Aug 23, 2008

Ad
  • 1 Answer

SOURCE: 2007 jeep wrangler sahara with a mopar remote starter just beeps

That's not a remote starter on your key chain, it's a keyless entry for an alarm system.

Posted on Dec 17, 2008

Mikey108
  • 475 Answers

SOURCE: I need to change the Heater core, Please help me. Thank You

Replacing the heatercore on a wrangler is not easy. The dash has to be pulled foward,cables have to be disconnected,heater hoses disconnected,heater housing dropped and disassembled. I suggest for you to buy a repair manual and it will guide through all the steps to perform this task.

Posted on Feb 16, 2009

emissionwiz
  • 76846 Answers

SOURCE: 1991 jeep wrangler clutch

U have what is called a hydraulic clutch, one of the hydraulic cylinders hs failed, there is a master and a slave cylinder. The most likely and most common cylinder to fail is the slave cylinder, this requires the transmission to be pulled out to replace it. the art is around $125.00, while the trans is out u might as well replace the clutch, the labor is about the same. Here is a picture of the part, let me know if u can see it.



1abd4ec.jpg

Posted on May 13, 2009

  • 1779 Answers

SOURCE: Need owners manual for 2000 Wrangler Sahara

Hi, Jeep offers a free download of owners manuals for '04 and newer vehicles. For older models, you can purchase a manual. Log onto this Jeep site to order one. Let me know if you have any trouble finding the manual. Good luck!
http://www.jeep.com/en/owners/manuals/index.html

Posted on May 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2000 standard shift jeep wrangler sahara, I went out to start it , there was nothing, we replaced the battery, the clutch safety switch, but still nothing ,any suggestions, need this going asap,...


can you use a jumper wire at the starter to bypass the key ? Jumping the small wire on the starter solenoid with the large wire should make it crank.

Feb 02, 2014 | Cars & Trucks

1 Answer

My 1993 jeep wrangler clutch keeps giving out even after i bleed the line..any thoughts? it works fine for a little while then goes to the floor again


replace the CLUTCH MASTER and SLAVE assembly! Age of that classic jeep needs NEW CLUTCH MASTER and SLAVE! That part together w/ clutch slave should be change! Personally i have experience replacing the kit only, it didn't last longer than expected and even got me in trouble, and I spend like i bought a NEW one! So its up to you to decide? taaah!

Nov 10, 2010 | 1995 Jeep Wrangler

1 Answer

Looking for a diagram for a 1999 Jeep Wrangler Sahara that shows photos on how to find the bleeder screw on bleeding the clutch


You wont need a photo its super easy, but it is under the jeep follow the line from resivior to the clutch master cylinder (holds fluid) then the other end located on the trannsmission is the slave cylinder the bleeder is on it usually has a rubber cap on it! hope this helps. p.s. dont let the resivoir get empty it will leave air in the system and make bleeding almost impossible.

Aug 17, 2010 | 1999 Jeep Wrangler

2 Answers

Cani put regular gasoline in my 2000 jeep sahara?


Yes, you can. The vehicle is rated for unleaded fuel.

Specs link:

http://www.automotive.com/2000/99/jeep/wrangler/sahara-utility/1290/index.html

HOPE THIS HELPS! Don't forget to rate, please.

Jan 09, 2010 | 2000 Jeep Wrangler

1 Answer

Shocks


It depends if your jeep is lifted or stock, and what kind of performance you want. Check www.quadratec.com . They have a great suspension and lift kit advisor that will help. In general, Old Man Emu, Teraflex, Rancho.

Dec 10, 2009 | 1999 Jeep Wrangler

1 Answer

1994 Jeep Sahara Wrangler. I love it. A while


more than likely a broken belt in tire but you mite have a bad tie rod or tie rod end, if all that checks out ok than I would start looking at o/d in the trans

Oct 23, 2009 | 2001 Jeep Wrangler

1 Answer

1991 jeep wrangler sahara shifting promblems


Your clutch is not disengaging. If it a hydrolic clutch chk. the fluid in resavor, Or slave cyl. for the clutch is bad, Or it has got air in it and needs to be bleed. This is a clutch problem, nothing wrong with trans. If its a manual clutch linkage its an ajustment thing. My best guess if its hydrolic slave cyl. went bad, or resavor is out of fluid.

Feb 10, 2009 | 1991 Jeep Wrangler

1 Answer

2007 jeep wrangler sahara with a mopar remote starter just beeps


That's not a remote starter on your key chain, it's a keyless entry for an alarm system.

Nov 17, 2008 | 2007 Jeep Wrangler Unlimited Rubicon 2...

1 Answer

1998 jeep wrangler sahara brake, tail and turn signal wont work


Did you go off road in the mud or woods?If so the connecting plug where all the connect probably has gotten disconnected.I think it is near or between the fuel tank and rear bumper.

Aug 30, 2008 | 1998 Jeep Wrangler

Not finding what you are looking for?
2001 Jeep Wrangler Logo

Related Topics:

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...