How to turn off the seat belt reminder on a 2009 chevy silverado?

Fluid Coming Out Power Steering Pump Cap - Taurus Car Club of ...

www.taurusclub.com > ... > Maintenance and Repair

Jan 9, 2010 - 2003 Vulcan has leak through cap on power steering pump. ... Hi I'm having the same thing happening to my 98 duratech. I was just getting ready to replace the rack today because of fluid coming out the drivers side boot... so decided to ... to be removed and that the bolt is recessed and difficult to reach.

Power steering issue - DodgeTalk : Dodge Car Forums, Dodge Truck ...

www.dodgetalk.com > ... > 2G Dodge RAM - General Talk

Jan 25, 2009 - Power steering issue 2G Dodge RAM - General Talk. ... Location:Sterling Heights, MI ..... pump, top off the reservior, screw on the cap, drop the truck and go drive it. .... I was able to loosen the pump and just dumped out the old fluid and.... I figured the belt was still good but the noise was definitely coming ...

Chevy Silverado Chrome Accessories - AutoAnything

www.autoanything.com/.../Chevy/.../110A50167A0A0A115A2690A1.as...

The Heartbeat has far better tastes when it comes to Chevy Silverado chrome accessories, and ... Check out our tail light chrome for Silverado rigs and you'll see what we mean. ... Chevy Silverado 2500HD Chrome Accessories .... 2012, 2011, 2010, 2009, 2008, 2007, 2006, 2005, 2004, 2003, 2002, 2001, 2000, 1999, 1998 ...

chevy bed rail caps - AutoAnything

PDF]2009 Chevrolet Malibu Owner Manual

https://www.chevrolet.com/.../2009_chevrolet_malibu_owners.pd... ChevroletDriving Your Vehicle . .... A French language copy of this manual can be obtained ... + : Fuses i : Headlamp High/Low-Beam Changer j : LATCH System Child .... If thevehicle has power seats, the controls used to .... Notice: Folding a rear seat with the safety belts still ..... vehicle's owner, are available in four basic types.

[PDF]2009 Chevrolet Silverado Owner Manual

https://www.chevrolet.com/.../2009_chevrolet_silverado_owners.... ChevroletDriving Your Vehicle . .... A French language copy of this manual can be obtained ... + : Fuses i : Headlamp High/Low-Beam Changer j : LATCH System Child .... On a vehiclewith power seats, the controls used to operate .... Notice: Folding a rear seat with the safety belts ..... vehicle's owner, are available in four basic types.

e-guide new clio - Operation - Renault

Code B001b is for Sensing Diagnostic Module (SDM) for Air bag.

Potential Causes:-

• Drivers Seat Belt Anchor Pretensioner
• Passengers Seat Belt Anchor Pretensioner
• Sensing Diagnostic Module (SDM)
• Sensing Diagnostic Module (SDM) Wiring

1. Confirm the passenger seat belt anchor pre tensioner connector position assurance is clicked into place.

2. If not, click it in and retest.

3. If the codes reset, disable the Supplemental Inflatable Restraint (SIR) system.

4. Substitute a 2.0 to 2.2 ohm resistor for the passenger seat belt anchor pretensioner. Refer to Tech Tips for a load tool.

5. Retest for the code to reset.

6. If the code resets, check for harness problems between the seat belt anchor pretensioner and the Sensing Diagnostic Module (SDM).
Tech Tips: At the beginning of the 2009 model year, the Impala began being equipped with two pre tensioners for the driver and two pre tensioners for the front passenger. The first pretensioner is still attached to the seatbelt retractor. The second pretensioner is attached to the anchor point for the seat belt.
A load tool can be fashioned from an 1157 light bulb and socket. Turn the bulb into the socket. Using an ohmmeter, determine which 2 wires have 2 - 3 ohms of resistance. Use those 2 wires as the load tool.

I’m happy to assist further over the phone at https://www.6ya.com/expert/uttamjeet_2f3adc18600f8ede

Buy the GM Seat Belt Driver tool from
Snap-On & remove the bolts

Forget the dinging & just use the vehicle as you
you would any vehicle

If you have a problem provide some detail, as that
question is strange in it's self

You have to have your seat belt on

All vehicles ding when the key is turned on
They are reminders to do certain things,wear
seat belt,remove key,turn off lights,etc.

Hello
The seat belt retraction reels contain a one time use gas charged cylinder (chemically generated) that at the moment of impact are fired to tighten the seat belt and hopefully prevent injuries to the vehicle occupants. This feature has been around for about 10-12 years or so and is installed on all cars and light trucks. It is great and it helps prevent injury, the draw back is the seat belts like the Airbags must be replaced the gas cylinders are fired.

Run the seat belt behind the seat and plug it into the seatbelt slot.

heated seat eliment needs replaced. or unplog

check the odometer cable

Buzzer Reminder Cancel Mode Setting
1) Set the LCD on the combination meter to the ODO display.
2) Press and hold the TRIP meter reset knob for ten seconds or more within six seconds of turning the
ignition switch to the ON position. Fastening the drivers seat belt while holding the knob cancels the
buzzer reminder.
3) When this occurs, the LCD displays -OFF. The buzzer reminder can be switched between ON and
OFF each time the TRIP meter reset knob is pressed. The LCD displays -ON or -OFF according to the buzzer reminder ON/OFF status. The display changes to the ODO or TRIP meter if the knob
is not pressed for ten seconds.
4) Performing steps 1) and 2) again when the buzzer reminder is off exits cancel mode.
5) The cancel mode will also exit when the battery or combination meter connector is reconnected.