Question about 2007 GMC Acadia SLE

1 Answer

I need to replace my driver side tail light cover. how to do this?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 33 Answers

I dont think you can nowadays.
most newer cars come with sealed units

Posted on Aug 03, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: replace tail light bulb

open hatch, look for two screws, remove , push tail light gently back and forth to release from clips pull light assembly out , twist bulb socket to remove from housing, replace bulb.

Posted on Sep 19, 2008

  • 45 Answers

SOURCE: remove passenger tail light

I have not yet worked on a Pilot, but from experiance, a lot of tail lights are pulled from the inside and not the out. You may check to see if it comes out from the trunk and not straight off the back from the outside.

gabenevins, a lot of places are selling the entire assembly and not just the lens. I would continue looking until you find just the lens unless you want to buy the whole piece. I do not know what the cost difference is. Perhaps pjpc might be able to tell you where to get just the lens.

Posted on Nov 13, 2008

  • 255 Answers

SOURCE: replace driver side tail light on 2004 cadillac deville

Hi,from inside the trunk, in some models just need to remove the carpeted cover and you will see the sockets ,in others you need to remove the complete tail lamp but is not hard ,just a few screws and it wil come off......C1

Posted on Jan 04, 2009

  • 23 Answers

SOURCE: I need to replace a tail light

Hi,If you open the tailgate you will see two plastic plugs on the light unit prise these out and you will see the 2 torx screws these can be removed with the SAAB toolkit you can then slide the lamp unit out to replace the faulty bulb.

Posted on Feb 01, 2009

jaysonemanme
  • 500 Answers

SOURCE: 2002 Ford Taurus Driver Side tail light bulb replacement

open the trunk.
pull back the cover on the side you need to change, there are usually 3 black plastic nut you have to remove before doing this.
after the trunk interior cover is pulled off there are 3 nuts, 11mm wrench or socket will take them off. pull the taillight assembly out and twist the socket out containing the bulb that is blown. the bulb just pulls out of the socket. while the bulb is out you should inspect the socket for corrosion, it wont hurt to clean it up and put some die electric grease in there

Posted on May 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Drivers side rear blinker light needs replaced


Open the tail gate, and you will see on the side of the tail light housing two screws that you will need to unscrew in order to take the housing out. If it is the tail light ,that is on the actual gate, open the tail gate and remove the plastic bed liner there are few of screws that need to be removed. Hope this helps you fix it.

Apr 17, 2010 | 2003 Subaru Baja

1 Answer

Changing the tail light cover for 2003 town and country minivan


There really is no way to change just the cover. Open the hatch. There are two quarter sized round plastic clips that have to be gently pulled out. Then you can remove the tail light.

Feb 04, 2010 | 2003 Chrysler Town & Country

2 Answers

Tail lights work on both sides. turn signal and


Sounds like you need to replace the drivers brake/tail light.

Dec 14, 2009 | 1998 GMC Sierra

1 Answer

How do you replace rear tail light assembly?


Open the trunk and along the bottom of the tail light, there should be a Philips screw securing a cover piece. (your car may or may not have this piece)
With the cover off, there will be another 2 screws securing the bottom of the tail light assembly. Remove the screws and pull the bottom out and the top is held in by two retainers that should just slide right out

Oct 13, 2009 | 2001 Toyota RAV4

1 Answer

Brake light, 2008 Nissan Sentra


Open the trunk and locate the trim door that covers the back of the drivers side tail light assembly. Open the door and locate the bulb holder. The bulb holder can be removed from the tail light assembly housing by turning counter clockwise 1/4 turn. Holding the bulb holder in one hand, press gently on the bulb and turn then bulb counter clockwise to remove. Replace with a combo bulb and reverse proceedure to re-install.

Jun 21, 2009 | 2008 Nissan Sentra

1 Answer

2002 Bonneville Tail Light Cover


Unfortunately There are only 2 Places to Purchase these Lenses. A Salvage yard or the Dealership.

Jan 23, 2009 | 2002 Pontiac Bonneville

3 Answers

Tail lights on 2004 nissan maxima out.


hey i just fixed mine with the same exact problem, look, all you have to do is open your 3rd fuse box which is next to your washing fluid on the passenger´s side under the hood, for that you need to remove the cover wich is pretty easy (5 staples all you need is a thin flat screw driver to lift the center of the staple and then the whole staple) then you take off the cover and then you open the fuse cover, you are looking for the TAILLIGHT fuse wich is the first on the upper row from right to left if you are standing on the passenger side looking towards the drivers side (you can also look for that fuse in the fuse box cover diagram) remembre is a 15A fuse, replace it, jaja and thats how you save some dollars. saludos desde guadalajara mexico.

Dec 19, 2008 | 2004 Nissan Maxima

1 Answer

Replace driver side tail light on 2004 cadillac deville


Hi,from inside the trunk, in some models just need to remove the carpeted cover and you will see the sockets ,in others you need to remove the complete tail lamp but is not hard ,just a few screws and it wil come off......C1

Nov 21, 2008 | 2004 Cadillac Deville

2 Answers

How to replace tail light


First you need to lift the hatch. There are two screws under plastic caps. Remove the caps and you will be able to unscrew these screws. Carefully using a flat screw driver to pry out the tail light assembly. It have to plastic pin that attached to the car body. do not break the pin. After you pry out the tail light assembly, you will be able to replace the light bulb. Replace everything in a reverse order.

Nov 17, 2008 | 1999 Lexus RX 300

1 Answer

Replacing tail light assembly


you will need to open the trunk remove the trunk cover and it is normally a 10mm socket and then all you do is unplug the wires and put the new one in the same way you took the old one off

Oct 10, 2008 | 2005 Ford Taurus

Not finding what you are looking for?
2007 GMC Acadia SLE Logo

Related Topics:

575 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...