Question about 1996 Jeep Cherokee Country

1 Answer

Why does my fan only work on high speed? Is it easy to fix?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Teacher:

    An expert who has written 2 tips or uploaded 1 video tip.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 72 Answers

You need to replace the fan reistor.
Should be a cheap fix.

Posted on Aug 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2003 honda odyssey will only have heat when the fan is on high. The climate control doesn't work. How do I fix this?


you meant the fan is dead , except on high right.
yes, easy
bad heater resistor block bolted to heater box (fan box)
yes, easy fix. with FSM 10x. easy
or see alldata.com

find the heater box, find a 1 inch cube stuck in a hole in box
with wires attached, bingo 5+ wire? not 2,

Dec 16, 2013 | 2000 Honda Odyssey

2 Answers

Only high speed works on fan motor


This condition is caused by a defective blower motor speed control resistor. The resistor is located right next to the blower motor with the connector end sticking out of the ducting for the AC/Heater system. Very easy to replace and the part is cheap as well.

Jul 06, 2012 | 2002 GMC Sierra 2500HD

1 Answer

AC and Heater fan will only work on high speed, all fuses good. any ideas thanks, Dave


When the blower fan will only work on high speed setting this means the fans speed control resistor is burned out, when it fails the fan defaults to high speed only. The fan resistor is located next to the fan and held into the cooling air duct by 2 screws near the blower motor. The part is fairly cheap and easy to replace.

May 11, 2011 | 2000 Mercury Villager

3 Answers

My lower fan speed don't work except for the high, the fan high speed stay highest


Hello sanjuis24
It sounds like you've got a bad blower motor resistor. The resistor is located under the right side of
the dash at the blower motor. A new resistor is not very expensive and it's a fairly easy DIY.
Hope this is helpful

Mar 07, 2011 | 2003 Chevrolet TrailBlazer

1 Answer

Fan speed will only work on high,is the switch the problem


The switch is held on by 2 clip, on on the "high" side, one on the "low" side. If the low side came disconnected, it would only contact at "high". Fairly easy fix (tape or glue). Doubtful that the switch needs to be replaced. It is more likely the variable resistor, or rheostat, which allows less than full voltage to the fan motor. This would allow only full or no voltage to the motor with no "in-between".

Dec 20, 2010 | 1995 Geo Tracker

1 Answer

Cool fan low doesn't work. Doesn't appear to be


It needs to have the blower motor resistor card replaced.
It still works on high speed because on the high setting the voltage does not go through the resistor.
The resistor is mounted beside the blower motor and is easy to replace.
There you are, thank you for using FixYa.

KL

May 01, 2010 | 2003 Saturn VUE

2 Answers

A/c works great when fan is on high speed when


Could be as easy as a new blower motor switch or blower motor resistors.

Apr 16, 2010 | 1995 Nissan Pickup

1 Answer

A/c and heating fan problem


Easy there is a set of of resistors that make speed selector work when they burn out they fuse together and lock in the full speed ( high) position this is for safety. you got to have defrost to see right.
anyway they are located near the fan usually under the passenger side dash jsut replace the resistors. you'l be fine

Jun 28, 2009 | 2002 Chrysler Town & Country

2 Answers

The Fan speed has stop working on all setting except high/


so your fan stopped working on all settings but high....? sounds like a bad switch...i know alot of jeeps and fords have that problem....lemme know....might hafat add another car to the broken fan switch list....lol

Sep 30, 2008 | 1997 Pontiac Grand Prix

3 Answers

A/C blower question


Thats a bad fan switch
as you stated it works at lower speed....
replace the switch
LB

Sep 22, 2008 | 2002 Jeep Grand Cherokee

Not finding what you are looking for?
1996 Jeep Cherokee Country Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

78257 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...