Question about 2000 Chrysler Cirrus

Open Question

I am trying to charge a 2000 chrysler cirrus 2.4L air conditioning unit. The compressor has no 134A in the system and wont turn on so i can charge it ..how do i get the compressor to run w/o freon, i know there is a jumper somewhere to make it run?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 4044 Answers

SOURCE: 2004 ford freestar air conditioning compressor

Actually, it is very common to be low on coolant. In fact that is the most common cause of your problem. If you are not comfortable doing this your self you will need to go to a shop and have the AC serviced. It is fairly easy. GO to Auto Zone and purchase one of the refill or cool boost cans with a gauge on it. Locate the low pressure side, this is easy in that the fitting on the can will only fit on the low pressure side. Start the vehicle and set the AC to MAX cool. Follow the directions on the can to fill your system. R134a works on pressure in the system. If the pressure falls the cooling falls that is why you felt the cooling better when driving on the highway than you did in traffic. Make sure you don't overfill the system. If you do it is possible that you will damage a seal and end up having to replace the compressor. Good Luck.

Posted on Sep 12, 2009

Ad
  • 76 Answers

SOURCE: where is low side of air conditioning unit, so I

FOLLOW THE TWO LINES COMING OFF THE AC COMPRESSOR THEY BOTH HAVE FITTINGS FOR CHARGING THE BIG ONE IS THE LOW SIDE THE SMALL ONE IS FOR VACUMING THE SYSTEM OUT

Posted on Jun 25, 2009

  • 1 Answer

SOURCE: 1997 Chrysler town and country

I found a sticker after looking under the hood with the AC information.

Thanks!

Posted on Jul 18, 2008

c17hydro
  • 2984 Answers

SOURCE: 1996 CHRYSLER CIRRUS LX A/C COMPRESSOR WONT KICK ON CANT FIND ALL THE FUSES

Look under the hood on the drivers side of the engine compartment next to the air box for your filter. Two black covers there that have fuses and relays.

Also, on the drivers side of the dash on the end (I think). Look there too.

Let me know what you find.

Posted on May 07, 2009

  • 38 Answers

SOURCE: My AC Compressor wont kick on. I have the proper amont of freon

replace comp cycling switch

Posted on Jun 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heat comes in my 2000 chrysler cirrus lxi from dash panel and when air cond is on.


You may need to have your R-134a replaced or the A/C Compressor needs to be replaced.

Aug 24, 2011 | Chrysler Cirrus Cars & Trucks

2 Answers

Put 2 cans of 134 freon in now it makes a nosie


DID YOU ADD OIL AS WELL ,NOISEY COMPRESSOR ,,MAYBE ON ITS WAY OUT,

Aug 09, 2011 | 2000 Chrysler Cirrus

1 Answer

MY 2000 CHRYSLER cirrus wont start if i leave the car idling with the heat on. It will start after i let it sit for at least an hour. Lately it will only start with a jump


Sounds like your alternator isn't charging your battery. Most auto parts stores will test your charging system for free.

Oct 31, 2010 | 2000 Chrysler Cirrus

1 Answer

Air compressor wont come on to to put in 134a


The AC compressor does not have to be running to charge the AC system, and the low pressure switch will even prevent the AC compressor from operating until there is sufficient pressure to operate the AC compressor without damaging it.

Start the engine and turn on the AC, then charge the system with the R-134a and as soon as there is enough pressure built up to trip the low pressure switch off, the AC compressor clutch should then engage and then finish charging the AC system.

May 31, 2010 | 1997 Cadillac DeVille

2 Answers

In a 1995 cirrus, where is the air compressor located and is it hard to fix?


it should be on the front side of the motor where the belt is and it is recommended that a shop evacuate the system. but then you can remove compressor and flush the system with compressed air then add pag oil and new compressor, then go back down to shop and have vacum test and freon added. it is alot cheaper.

Dec 17, 2009 | 1996 Chrysler Cirrus

1 Answer

Steering is really stiff after replacing power steering pump on 2000 chrysler cirrus??


Is the drive belt adjusted properly. Did you bleed all air from the system after installing the pump? Start the engine and turn the steering wheel from left to right fully 10 times. This will remove any trapped air. Check the fluid level and top it off.

Nov 21, 2009 | 2000 Chrysler Cirrus

1 Answer

A/C quit blowing cold air after a loud squeeling noise stopped!


Look way down on the engine front area passenger side for the compressor.
Is the belt gone?
Check the belt tensioner pulley....can you turn it?....is it seized?
If it is OK then try and turn the compressor.......and the idler part of the compressor.
If the compressor is seized.....why?
Usually lack of oil in the system,or an overcharged system.

Once you have removed the 134a gas from the A/C system before removing the compressor and before installing the new compressor make sure you add the correct amount and type of oil into the system to prevent another seized compressor after you have flushed the system to remove contaminates such as old compressor grindings......if the compressor was seized.
You will also need a new receiver/dryer once you open the system to the moisture in the air.
Do not expose the new receiver/dryer to air....install last.
Vacuum the system well before refilling with the correct amount of 134a.
At 70 to 80 degrees outside temp........a vent temp at medium fan speed of 48 to 45 degrees should be a full charge .......use this reading if you do not have a electronic scale and/or A/C machine.
DO NOT OVERFILL THE SYSTEM.

Sep 08, 2009 | 2000 Chevrolet Silverado

1 Answer

1996 CHRYSLER CIRRUS LX A/C COMPRESSOR WONT KICK ON CANT FIND ALL THE FUSES


Look under the hood on the drivers side of the engine compartment next to the air box for your filter. Two black covers there that have fuses and relays.

Also, on the drivers side of the dash on the end (I think). Look there too.

Let me know what you find.

May 07, 2009 | 1996 Chrysler Cirrus

2 Answers

Chrysler Cirrus Air Conditioner Cools Sometimes and Sometimes not


I had this problem along with my fuel gauge dropping to empty and back up to actual amount and tach worked sometime and didn't other times. I ended up replacing the Engine Control Unit (near positive battery terminal on firewall. If you read the codes out and they all have something to do with low voltage, this will solve the problem.

Jun 22, 2008 | 1995 Chrysler Cirrus

Not finding what you are looking for?
2000 Chrysler Cirrus Logo

Related Topics:

402 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

81423 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...