Question about 2007 Toyota Camry
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Push and hold trip button on dash with key off, turn key on but don't start, odometer will clock down, when it is finished, lite will go off
Posted on Apr 08, 2009
more trouble than its woth to repair .its digital and you have to remove the too much to do it.buy a cheap watch and stick it on the dash
Posted on May 07, 2009
SOURCE: hand brake, Camry Altise
Hello, I researched this problem for you and it is a common problem with the Altise. It feels like you have to pull the E-Brake really far up I am assuming. Factories and Dealerships do not normally adjust these to each and individual car but this is not a complicated thing to do. Adjusting your parking break from your car can be some what complicated due to the amount of work you have to do to get to it inside your car. You may have to remove your console to get to the necessary screws to take your cover around your transmission selector out but if you mark and bad all your parts and screws and their locations this should not be difficult at all. You can also try to adjust the parking brake from under neath the car and you will probaly have to remove a cotter pin and a washer and then screw the lond U shaped connector at the front of your parking brake cable towards the rear of the vehicle to make it more tight. This may fix the long travel of the parking brake cable. Just take note that this is a common problem with your vehicle but with a little time you can make this a manageble fix that you will be happy with and I hope you fix this and are happy with the work you done as well. I would refer to a Haynes or Chilton Auto Repair Manual for the best step by step information as well.
Posted on May 22, 2009
4 cylinder diagram
6 cylinder diagram
Loosen the tensioner pulley to remove the belt. It is the one that has a long bolt running through it. Once you remove the old belt, install the new one using the appropriate diagram from the above two links. Readjust the tension using the bolt you loosened to remove the old belt.
i hope this helps
Posted on Nov 20, 2009
Once all tires are aired up to spec (drivers door decal, COLD) the light will go off. Some models have a sensor for the spare tire, so if it does not go off, check if spare tire has a sensor at the valve, It wont hurt to make sure the spare is full of air anyhow.
Posted on Nov 16, 2010
Tips for a great answer:
Jul 25, 2017 | Toyota Cars & Trucks
Oct 26, 2016 | Cars & Trucks
Oct 21, 2014 | 2008 Toyota Camry
Oct 15, 2014 | Toyota Camry Cars & Trucks
Dec 19, 2013 | 2007 Toyota Camry
Mar 05, 2011 | 2006 Toyota Camry
Apr 11, 2010 | 2008 Toyota Camry
Oct 18, 2009 | 2002 Toyota Camry
Apr 01, 2009 | 2007 Toyota Camry
412 people viewed this question
Usually answered in minutes!