Question about Ford Explorer

1 Answer

(04 ford explorer xlt) left lights on for about 1-2 hours without noticing. car wouldn't start of course. tried jump starting it. it only cranked over 3 times. then after that it just wouldn't do anything not even make a sound. took starter off and tested it and it worked fine. bought a new ignition relay and it still wouldn't do anything. jump started the starter with a screw driver and ignition on and all it did was just crank but wouldn't start. please help!!!

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 130 Answers

HAVE YOU CHECKED ALL THE MAIN JUMBO FUSES ON THE ENGINE CONPARTMETN YET??? SEEMS YOU CAUSED A GOOD SHORT. TEST ALL THEM SPECIALLY THE IGN AND THE ECU ONES. THOSE FUSES DO BURN DUE TO INPROPER JUMPSTARTS HOPE THIS HELPS.

Posted on Aug 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 ford explorer xlt 4.0 4x4 cranks but does not start I can hear the fuel pump running the theft light is blinking


Anti theft will stop it from starting. Try locking and unlocking the drivers door with the key to reset .

Nov 17, 2014 | 2000 Ford Explorer

1 Answer

Electrical problem on 1996 Dodge Dakota


It will drain at a rate of 21Watts X 2 = 42Watts at 12Volts = 3.5Amps. If you have an 70 Ah battery that is 20hours to totally flat from fully charged.

May 27, 2017 | 1996 Dodge Dakota

1 Answer

2005 explorer wont start, anti theft light is flashing fast


you need wiring diagram as it look's that some wire has been damaged and and locate the wire and the exact location from where the wire is damage go to the given link and the repair manual with diagram http://toolsnyou.com/

Sep 18, 2017 | 2005 Ford Explorer

1 Answer

When I shut off the motor sometimes it wont start. I just bought a new battery 2 months ago. When I turn the ignition the starter doesnt even make a clicking sound. I can jump it or let it sit a couple of...


It might be your anti-theft alarm system. When the car doesn't start, is there a ticking sound inside the car? If so, hit the unlock button a few times on your keyless entry remote, until the ticking stops, then try to start the car. Hopefully this helps.

Mar 27, 2010 | 1998 Ford Explorer

1 Answer

Change battery,had starter tested,and check fuses in both places cant start my 04 exployer


Appears to be a cranking isuue. Ford uses a starter relay an normally mounte under hood on left fender.. Battery + cable will ytake yo to it. Nake sure vehicle is in park or neutral. The relay has two large posts. momentarily jump the two and see if it cranks. If it does, Momentarily jump the post from the battery to the small post that has a push on wire connectorr. SShould crank that small wire is the one energize when you turn the key. Ck the wire for current if t he engine cranks in bith of your jumo tests. Good Luck -Ned

Sep 26, 2009 | 2004 Ford Explorer

1 Answer

94 ford explorer, starter won't turn


If you have the proper voltage at the starter, (battery voltage) and the starter won't turn, it is the starter or the engine. Try turning the engine over with a wrench on the harmonic balancer.

Jun 22, 2009 | 1994 Ford Explorer Limited

1 Answer

Starter/solenoid prob?


Replace the MAF sensor. The starter is overheating due to cranking excessively. It has noyhing to do with the engine staying running. The MAF sensor is located as the first sensor out of air cleaner. It controls the fuel. Good luck and have a safe trip.

Jun 18, 2009 | 1993 Ford Explorer Limited

1 Answer

Starter location on 91 ford explorer xlt and is replacing easy?


2 things
1 starter is bad its located on the driver side of the engine beside the oil pan. 3 bolts and 2 electrical connections

2 bad battery cables. i have replaced a lot of battery cables on these they let enough power through to get a click but not enough to start the engine. this cable is a special cable only available through ford or you can make 1 yourself

Apr 26, 2009 | 1991 Ford Explorer

2 Answers

Anti theif light is blinking fast & it wouldn t


OOPS dealer only ,Try opening and closing door lock three times drivers side 10 sec interval between clicks then try starting if no go then dealer only

Mar 14, 2009 | 2000 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...