Question about 2006 Pontiac G6

1 Answer

My key holder on my remote broke all i need is the casing its a 2006 g-6 4 buttons where could i buy one

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 175 Answers

Ebay is littered with cases... search 'fob case'

Posted on Feb 06, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My car alarm / key remote broke, I believe it is a factory alarm. I don't want the horn to go off, what do I do to disable the alarm system once I open the door


You may be able to disable the alarm, by opening the door with the key. Or pull the fuse, to the alarm system in the fuse box. Open your key fob remote, and check the internal 3v battery as well. It could be dead, or the (outer) case buttons are not making contact with the board which has the actual buttons on it. When pressing the buttons manually on the board they should make a "click", else wise they are the source of your problem in the remote.

Oct 30, 2014 | 2005 Kia Sedona

1 Answer

CHANGED IN FOB - STILL DOORS WILL NOT UNLOCK


I had to fix the same problem. Some of these fobs didn't get the battery holder soldered on very well when they were made & the battery holder can come loose just by dropping the fob on a hard surface. Of course if this happens the fob becomes intermittent. The good news is that any competent electronic shop or hobbyist can easily re-solder it back into place. However it is possible to set the holder too deep in the holes & if you do the battery may not fit. So install the battery before you leave the shop. To verify if battery is not the problem try all of the buttons if any of them work consistently then your battery is not the problem.
Next most likely cause is the contacts on the buttons you use the most have worn out. If so you'll need to buy a replacement fob case. Most cost less than $20 from auto part stores. I ordered one for my 06 Malibu from NAPA parts & they sent it right to my home in just a few days. Put my old fob board in new case & every thing worked again.

Jul 14, 2014 | 2006 Buick LaCrosse

1 Answer

Key code


Well you don't actually program the key, you put the car into a condition so it will "learn" the remote to use with it.

Procedure
1. First open a window (just in case) use existing key (if you have one) place in ignition and turn to ON (RUN position), do not start the engine.
2. Use the new key to lock the car, the key not the remote. Now press one of the buttons once on the new key transponder, the lights should flash, wait 10 seconds and press the unlock button, the doors should unlock and the key should be recognized by the car's security system.
3. If you are programming a second key repeat the above but press the remote button twice, three times for a third key.

Alternative Method
Procedure
1. Switch on ignition; system will then remain in programming mode for 30 seconds.
2. Briefly press any button on the remote control unit while the unit is in the ignition.
3. The central locking system locks & unlocks to show that the remote control has been programmed into the car's security system as a valid remote now paired to that car.

Jul 12, 2014 | 2006 Opel Astra 1.8

1 Answer

Remote key does not open /close door lock


Hi.
It seems that the remote key need a battery change. replace the batteri inside the remote key.

If this is not curing the problem you might be in the situation where the transmitter (remote key) or the receiver (car) is defect.
In this case you need help from Suzuki.

Good luck

Feb 27, 2011 | 2006 Suzuki Swift

1 Answer

Need to remove the panel on the back door so I can reattach the light frame above the license plate. How do I do this as the holders seem really tight. Do I break them and then replace them?


buy some replacement pins when you buy the frame, they're not expensive. But I just used a straight screwdriver and pried them off... Only broke one, myself.

Feb 07, 2011 | 2006 Scion xB

2 Answers

2006 Tahoe Rear Hatch lock actuator


A wrecking yard is your best bet. The odds of you getting one that is bad are astronomical. Are you sure your remote has fresh battery's? Also check your fuse going to that devise before buying another one. The second choice on where to find one is eBay. Of course they are usually higher then a wrecking yard. They get a lot of there parts for sale by going to the salvage yard them selves. I hope this helps and Good Luck, The Raz

Apr 16, 2010 | 2006 Chevrolet Tahoe

1 Answer

Key fob needs reset 2006 VW jetta TDI


I hope this might help. -- I had the same problem yesterday and fix the problem today. The steps on the manual (page 32) was too simple and wrong for my case. Read carefully the followint steps and thank me if these steps work. -- JB (owner of Jetta 2.5, 2006 model)

* The most important thing is to make sure that the LED in the driver side window frame stays blinking. The blinking means that the receiver has entered a programming mode and is waiting for the signal from the key. Good luck!


1. Insert the key with a faulty remote into the driver door lock and turn the key to the UNLOCK position 3 times in succession for at least 0.5 seconds each time, and within a total duration of 5 seconds.
: The system should now enter so called a "programming mode" and the window frame LED should blinking once every 1~2 seconds for the next 15 seconds. The faulty remote must be programmed during this period.


2. Aim the key to the (infrared) window frame LED which can be considered as a key signal receiver and press the lock button of the key fob and keep it pressed. While the button is pressed, press the unlock button three times in succession for at least 0.5 seconds each time.
3. Release both buttons.


* After all the efforts described above, the system should now acknowledge a successful programming by flashing the LED once every 1~2 seconds for more than 10 seconds. (Someone said that the small LED on the key fob should also blink a few times; although it didn't in my case.)

JB // jbparkthree@yahoo.co.kr

Oct 20, 2009 | 2006 Volkswagen Jetta

4 Answers

Rear hatch will not unlock on my 05 Denali


Check the unlock mechanism for the hatch. These are controlled by an electrical motor pulling a cable. If the cable came loose you might or might not hear the click click that it makes. I would also check the fuses and relays related to the system. Usually if you can get the interior panel off all the innards are exposed. I would suggest pulling that panel off, then triggering the keyless remote and see if anything moves, that might pinpoint where it has gone bad.

Sep 28, 2009 | 2005 GMC Yukon Xl Denali

1 Answer

The key of my honda 2006 does not work upon pressing lock and unlock button. I need to insert the key to the principal door to lock all the doors and activate the alarm. The trunk is locked as well. Any...


the key fob remotes need to be reprogramed or have the battery checked... make sure to have all key fob remotes present when reprogramming...

Apr 06, 2009 | 2006 Honda Accord

Not finding what you are looking for?
2006 Pontiac G6 Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8547 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...