Question about 2005 Chrysler Town & Country

1 Answer

Hi I have a 2005 Chrysler Town and Country van 3.8 liter engine. I just replaced the ERG valve but still have the error code of PO406? Anyone have any suggestions? Thanks so much for your time. Bret

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Chrysler Master
  • 757 Answers

The diagnostic code will not clear immediately from the computer memory. It will take a predetermined number of complete warm up and drive cycles without the problem detected to have the diagnostic code disabled. If you want your SES light turned off right away and all codes cleared, you will need to use an OBDII compliant scan tool to reset it. Otherwise just continue to drive the vehicle as usual and monitor your gas mileage and driveability before assuming that the new part fixed the problem.

Posted on Aug 03, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

08' town and country shows codes p0406, p0404, p0301, p0300

egr valve is stuck open at idel exhaust gas is entering engin causing lean condition and missfire your po300 301 codes replace egr and clear codes

Feb 09, 2014 | 2005 Chrysler Town & Country

1 Answer

Po406 trouble code

EGR sensor which could be the sensor or the EGR valve.

Jun 25, 2012 | 2005 Chrysler Town & Country

1 Answer

Error code P0406 & P2008. Any suggestion

by dillardw I had the code po406 in my 2005 chrysler town and country. I is problem in the EGR valve. I replaced the EGR valve. the valve is by the alternator on the 3.3L engine and has a tube going up and into the intake manifold on top of the engine. The valve cost $ 65.00 in 2008 at the dealer with discount it was cheaper than two after markets that i checked. I erased the dtc from the computer and have had no more problems with this. Of course the problem could be different on your vehicle. I hope this helps.

Jun 21, 2011 | 2005 Chrysler Town & Country

1 Answer

I have a 2005 dodge hemi 5.7 liter i had a egr code po406 come on. Wandering what part it takes to fix it and where it is located

exhaust gas recirculation sensor A circuit high. you can find out about this at they have assistance in troubleshooting, and locations of parts.

Dec 08, 2010 | 2005 Chrysler Town & Country

1 Answer

Po406 code

it is a 2005 chrysler town and country 3.8 liter.

May 29, 2010 | 2007 Dodge Ram Truck

1 Answer

2005 chry tc van 3.8 eng code po 406

hi you have a failure on your exhaust gas sensor < erg solenoid >

Nov 19, 2009 | 2005 Chrysler Town & Country

1 Answer

Got an inspection failure on my 2005 town and country. The error code is P0406. what is the cost to fix a Exhaust Gas Recirculation Sensor?


Aug 29, 2009 | Chrysler Town and Country Cars & Trucks

1 Answer

MAP or MAF Sensor Diagram for 2005 Town&Country Touring Van 3.8l.

Yes it has a sensor and they are color coded however I don't think it's called a maf or map sensor that’s a GM name, there would be three wires on it on ground one 5 volts reference and one for connection to the computer to tell the computer how much air flow there is, and the reading would be from 1.5 volts to 4 volts.

Jun 20, 2009 | 2005 Chrysler Town & Country

1 Answer

Check engine light came on and the error code is 040.4 what is it and can i drive it?

this is an egr valve trouble need a new egr valve..make sure you disconnect battery when you replace it..sometimes fault will come back even though replaced valve

May 09, 2009 | 2005 Chrysler Town & Country

2 Answers

Diagram 3 liter chrysler engine removal 1995

pvc valve for 2006 town and country chrysler van

Jul 24, 2008 | Chrysler LeBaron Cars & Trucks

Not finding what you are looking for?
2005 Chrysler Town & Country Logo

451 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides