Question about 2002 Chrysler Sebring

Open Question

I have a 2002 chrysler sebring. My power windows wont roll up or down with the individual switches, it only works from my drivers side panel. Im not sure if the window lock is stuck on or what the deal is. I have checked the fuses and it doesnt seem to be that. Any Idea's?-- Brian

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 82 Answers

SOURCE: driver side power window stopped working

The door panel is held on by plastic clips and 5 screws. 3 screws are on the bottom and 1 in the pull cup and 1 in the inner door handle.Then grab one of the corners and give a small tug, when you get some of the clips to pop out then proceed around the whole panel. To replace the panel take the clips out of the door with a fork and slide them back into the panel and then line it up on the door and use your hand like a hammer and bang the panel back on. Hope this helps

Posted on Jan 12, 2009

Ad
  • 202 Answers

SOURCE: 2002 Chrysler Sebring Oil pressure light

Could be a bad oil pressure switch, or a bad oil pump. Both will cause this issue. Hope it is the switch b/c the oil pump is a costly repair.

Posted on Mar 26, 2009

  • 2 Answers

SOURCE: replace air filter 2002 Chrysler Sebring convertible

you need to loosen the clamp on the throttle body and unplug the map sensor then there are two clips on the other end pull that out and you should be able to pull the filter out you don't need to take the box off.

Posted on Apr 28, 2009

polarcycle
  • 1392 Answers

SOURCE: 1999 chrysler sebring, transmission doesnt shift

find out why the light is on and fix it. This will most likely be a trans wiring issue that the light is on for.

Posted on Jul 11, 2009

  • 1 Answer

SOURCE: Driver's side power window doesn't work

2006 chrysler town and country passenger side window suddenly stopped working.
other windows work, sliding doors work as does rear hatchback.
fuses seem to be good.
might there be a safety switch that somehow got pushed that keeps the passenger window from opening?

Posted on Aug 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Buick 2002 LaSabre Custom all windows do not go up and down, door lock/unlock switch drivers side does not work(passenger & rear doors lock/unlock door switches work, trunk release button does n


coulb be the control switch on your panel you can take the door panel off and check for loose connections and try to test for continuity. if you dont know how take it to a shop and have them diagnose the electrical. im quite sure it the switch that burnt out

Oct 24, 2012 | 2002 Buick LeSabre

1 Answer

Passenger window wont roll up.......fuse/relay is good....window motor is good..module is good.......tested and got a ul 1110 and ul 1120 codes ...what is this ? 2008 sebring convertible / chrysler


IF THE PASSENGER WINDOW SWITCH IS BAD IT WONT WORK FROM EITHER SIDE HAS TO BE A COMPLETE CIRCUIT.IF YOU MANUALLY JUMPED WINDOW MOTOR WITH A BATTERY AND TWO WIRES ,I WOULD START THEIR.OR IF THE DRIVER WINDOW SWITCH IS BAD SAME THING

Aug 03, 2011 | 2008 Chrysler Sebring Convertible

1 Answer

I have a sebring 2002 ..driver side window not working and the back passenger window also ..back 1 use to work when i opened the driver door a bit, now it stopped competetly wires maybe? confused ..any...


There is a recall on the power window lift plates on some certain chrysler models.......
I cant recall exactly which year model it is but I am a chrysler tech. and have had to change them
before...If the lift plate is not the problem you will have to change the window regulator which is not very cheap....You may be lucky and it could be a fuse blown or just a power switch but I doubt it very highly because of working on them I have never seen the switch go bad yet or a blown fuse...
You should call the chrysler dealer and give them your vin # year and model and they will be able to tell you...All you can do is if the fuse is good you have to check for power from the switch to the power window motor...If power is there you will have to buy the regulator unit because of design..
With any luck it will be a recall ....GOOD LUCK....Hope this helps....................Metalpoet

Mar 28, 2011 | 2002 Chrysler Sebring

1 Answer

Power Window problem sebring sedan 2001


it could be possible that the window switches on each side as gone bad or possibly you have a shortage dnt know how exactly to pin point the shortage without an amp or voltage tool..but if the master window switch is working fine then yes you do have a shortage or bad switches but while you are at it check all window fuses

Nov 21, 2009 | 2001 Chrysler Sebring

2 Answers

Power Windows are dead


It sounds like your electrical window regulators are the problem, you might want to remove the door panels and check the connection to the regulators, hope this helps. God Bless.

Willie

Aug 14, 2009 | 2002 Chrysler Sebring

2 Answers

Driver-side window non-respondent (2003 4door Chrysler Sebring)


you need to check your window switch also check the fuse box for blown fuse

Jun 29, 2009 | 2003 Chrysler Sebring

1 Answer

Driver Side Window not working in 2006 Sebring


cable that lifts it up could have broke you will need to remove door panel and take it out to have a look.Does it make a noise when you operate the switch

Apr 05, 2009 | 2006 Chrysler Sebring

1 Answer

I have a 2001 rodeo. the power windows all work from each window if you hit that particular switch at the window, they work. the drivers side window also rolls down. but the 3 other switches at the drivers...


First check your fuse panel. Other than that...Perhaps moisture has gotten in the door panel and messed with the connection. I would take the panel off and investigate..make sure everything is plugged in.

Mar 14, 2009 | 1997 Isuzu Rodeo

1 Answer

Driver side window


check the fuse. if it isn't popped than take the switch out and clean the connections. you might need to get another switch.

Jul 08, 2008 | 2002 Chrysler Sebring

Not finding what you are looking for?
2002 Chrysler Sebring Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...