Question about 1990 Dodge Dynasty

Open Question

1990 Dodge Dynasty. There is no reverse. And when driving it for a while, unable to shift gears.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 8 Answers

SOURCE: 1990 Toyota 4runner wont go into 5th or reverse

They had a problem with this plastic washer that is in the shifter tower it sits just under the shifter it self and gets worn out and causes this to happen- hope that helps.

Posted on Nov 06, 2008

Ad
  • 1 Answer

SOURCE: I HAVE A 1990 DODGE DYNASTY.HOW DO I FIX THE HEATER BLOWER THAT STOPPED WORKING?

it could be a 7 dollar resistor thats bad. Thats located behind the fluid washer resovoir.

Posted on Dec 15, 2008

  • 1 Answer

SOURCE: no brake lights of blinkers 1990 dodge dynasty

While not likely, it is possible that the light bulbs in both sides are have bad filaments. Turn on ignition key (but don't start engine). Then turn on parking lamps (first detent or "click" on headlamp switch). Walk around car and look for illumination on front parking lamps and rear tail lights. Turn on the right turn signal. Are those (right hand) lamps now changing brilliance? Try the left turn signal in the same manner. Are those (left hand) front and rear lights changing briiliance? Take note of any positions that did NOT change briliance when the turn signals were activated. If NONE changed briliance, you either have a bunch of bad bulbs (unlikely) or a bad flasher (more likely) or a bad turn signal switch (most likely) or perhaps wiring problems (possible if the car has been in a collision or has been "worked on" by some "non-expert" mechanic). Check the action of the emergency flasher control switch located on the steering column (facing up). Pushing it in (down) should result in the button going to two different heights alternately (low, high, low, high). You could just have bad flashers or corroded flasher contacts! Good luck!

Posted on Dec 29, 2008

dr_greg
  • 192 Answers

SOURCE: cannot shift into reverse although forward gears all functional

have ur shift linkage bushings replaced....most likely thse are torn or completely broken .. this is common on these models..also on some vw's of the same years

Posted on Apr 10, 2009

  • 1 Answer

SOURCE: all the sudden my 1999 dodge durango wont shift into reverse?

My 1999 Durango stalls when it’s cold and I shift into reverse. Once the motor is warm reverse works fine.

Posted on Apr 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1989 dodge dynasty v6, fwd, transaxle 3 speed auto, good condition, experiencing shift problem, doesnot want to shift into passing gear, sometimes it does, right now it doesn't, any takers


most auto trans don't shift into reverse when low. Reverse takes the most fluid of all the gears.
Check for a bad shift solenoid or wires to and from that circuit. Most trans-axles have them now.

Feb 25, 2013 | 1989 Dodge Dynasty

1 Answer

I have a 1990 dodge dynasty with shifting problems i have had the seloind pack replaced still stifts rough and still will drop out of drive down into second and then dosen't want to shift back to driv


go to the scrapyard and find a accident damaged vehicle then buy the box and the computer and change the whole lot ,failing which buy a newer secondhand car as it may be cheaper in the long run preffably one with a manual gearbox

Dec 11, 2011 | 1990 Dodge Dynasty

1 Answer

Transmission does not upshift. Shifts from park to reverse to neutral to drive but does not upshift from 1st gear. 117000 miles on the odometer HELP!!!


Sounds like one of the speed sensors are bad. It has an input speed sensor and an output shaft speed sensor. You need to have the TCM scanned for codes to see if one of them is bad.

Oct 30, 2010 | 1991 Dodge Dynasty

1 Answer

It will not shift out of 2nd gear into drive


Take to dealer and have it replaced, or to a good trans shop. A604 transmissions are notorious for troubles.

Jul 08, 2010 | 1990 Dodge Dynasty

1 Answer

Transmission for dodge dynasty v6 3.3 front wheel drive only goes forward no reverse


check to make sure your fluid is full, start car allow to warm then check fluid on level ground , if fluid is full then reverse gear my be blown. will need a used trany or rebuild that one if car is worth the cost.good luck.

Feb 19, 2010 | 1991 Dodge Dynasty

1 Answer

1990 dodge varavan will not go into reverse


It is more then likely either a solenoid or a clutch pack. If you hear a bump and then nothing when you shift, it is probably the clutch pack, if nothing happens, it is more then likely the solenoid. The bad news, it will require a rebuild either way. Reverse gears are some of the hardest to change, and especially on that transmission, it will be quite a process to repair.

Jul 12, 2009 | Mitsubishi Minivan Cars & Trucks

1 Answer

How to put the green shifting wire back to the way its suppose to


the linkage from where it meet the car body to the shifter parts green ground worldaround

Mar 29, 2009 | 1990 Dodge Dynasty

1 Answer

Reset factory alarm on 90 dodge dynasty key in door does not work


i have 1989 dynasty and my factory alarm is still engaged and i am unable to start my care how can i fix it

Mar 24, 2009 | 1990 Dodge Dynasty

1 Answer

MY 1993 dodge dynasty will drive forward for about a block and slip out of gear, you can then pull over stop the car and put it in park and then start the car again and it will go another block. It will...


You are going to need to have the trans pulled again. There aren't any electrical problems that can cause no reverse. Also it sounds like the 2/4 clutch is burnt and when it slips it puts it in limp and 2nd is gone. Hopefully the shop that did it in July will help you with a warranty.

Mar 24, 2009 | 1993 Dodge Dynasty

Not finding what you are looking for?
1990 Dodge Dynasty Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...