Question about Chevrolet S 10

1 Answer

The truck idles fine but during take off it hesitates and then straightns up but i was driving it other day and it got to were id didnt wana pull its self i replaced the spark plugs cap and rotor tps sensor and gutted the cat

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,301 Answers

Check the fuel pump it sounds like you've checked the electrical end of the problem,, but not the fuel side of it, also the fuel filter

Posted on Aug 02, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

'80 jeep cj5 2.5 engine. Cranks and idles fine. Sputters and hesitates during acceleration. Revs smooth while in neutral. New plugs, wires + accel. Pump.


CJ5 Hesitates when accelerating - JeepsUnlimited

www.jeepsunlimited.com/.../showthread.php?...CJ5-Hesitates-when-accel...

Mar 29, 2006 - 19 posts - ‎13 authors
If it still hesitates I'd say it was a carburetor issue (accelerator pump, power valve..). If it is only acting up when accelerating (while driving) that would tell me it ... 1980 CJ5Renegade with 304 v8 .... The idle mixture screws were nearly 3 turns out, I think i have them somewhere around 2.5 turns right now.

97 TJ 2.5L hesitating and sputtering - JeepsUnlimited

www.jeepsunlimited.com/.../showthread.php?...97...hesitating...sputterin...

Dec 8, 2001 - 20 posts - ‎9 authors
Reving the engine in gear with the clutch in a bit would load the ... alot longer to warm up and tends to hesitate when pulling away from a ... Jeep rater score from the factory:26, today:238 ..... 92 XJ 155/80r13s and 17"s of lift.Missing: cj5

Hesitation on Acceleration... performance problems #1 ...

? 7:13
https://www.youtube.com/watch?v=0m4IiVzwjzE
Nov 17, 2013 - Uploaded by Luke Nodzo
Luke will explain why your car may be hesitating or sputtering on... +ameer aklil My 2012 2.5l Frontier does the same thing when it is in 3rd and ...

Dec 16, 2015 | Jeep Cars & Trucks

2 Answers

1995 dodge neon cuts out during normal driving runs at full throttle


hi I assume this is a fuel injection vehicle and if so it sounds a lot like you have a throttle body problem or throttle sensor problem ,have you also checked that the fuel filter is not blocked,remove the fuel filter and blow thru it in the direction of flow and if your cheeks blow up while blowing thru the filter it is blocked or restricted -replace.
hope that helps .
Nazeer

Dec 07, 2013 | 1996 Plymouth Neon

1 Answer

Serpentine belt squealing


Either the belt has stretched, or the tensioner is not keeping it tight.
Or it has oil on it.

Dec 12, 2012 | 1996 GMC Suburban

1 Answer

I have a 95 f150 and it has a tendency to idle at 1100 rpms in park. i clean the idle position sensor and that didnt help. also it seems like it has no power when i drive it and i'm not getting very good...


symtoms of a bad coolant sensor. poor idle, stalling, rich mixture, retarded timing, low idle speed, cold hesitation or stumble, poor fuel milage. ( will also ****** timing ). in some cases you can unplug sensor and the pcm will compensate by running a default air/fuel ratio and in some cases allowing car to run without the sensor.Id just replace it !! if light is on, get vehicle scanned to find problem code. most all auto parts stores will scan for free, auto-zone etc. have a good day !!

Mar 25, 2011 | 1995 Ford F150 Styleside Regular Cab

3 Answers

2002 gmc sierra 1500, starts up fine but soon as it starts it idles down and sometimes stalls out if if it doesnt stall the idle comes right back up and sometimes might go back down. after i get the idle...


check for codes. If no codes are stored then maybe the idle air control valve is bad, or the air cleaner clamps are loose.. If the clamps were loose or a vacuum hose fell off you should have a code stored. If the IAC is bad it usually will not set a code.

Nov 26, 2009 | 2002 GMC Sierra 1500

1 Answer

Rough idle hesitating at idle drives fine i


check plugs, wires, and coils for proper spark.

Oct 28, 2009 | 2002 Ford E250

1 Answer

1999 rough idle/hesitating at idle .drives fine i


Yes it could be a vacuum leak at the intake manifold, could also be the MAF sensor (especially if you use a gauze/oil air filter).

Oct 25, 2009 | 2003 Ford E250

1 Answer

1997 Cavalier while you driving hesitates and stall


I had to replace my Idle Air Control Valve and Throttle Position Sensor.

Apr 28, 2009 | 1997 Chevrolet Cavalier

1 Answer

Hesitates/stalls during acceleration


i would check fuel supply, volume adn pressure, i wold also look at the MAF sensor hot wire to see if it has a little chia pet growing on it.

Dec 13, 2008 | 1992 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...