Question about 2005 Dodge Durango

1 Answer

Hard to turn stearing wheel, but fluid is full?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 977 Answers

The power steering pump may be faulty or the pressure might need adjusting.....hope this helps.....cheers

Posted on Aug 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mercedes gl 450 2007 stiff turning


Check the ball joints and the belt tension.

Nov 11, 2013 | Cars & Trucks

1 Answer

Just replaced the stearing sector, now it does not steer correctly....feels like there is no power stearing fluid...1984 chev k10 series


Sounds like you may have a bunch of air in it. Make sure it's full of fluid, start it up, turn wheels all the way to the left, turn it off. Let it sit for 20 - 30 min. Then try it. Hope this helps, TJ

Jul 30, 2011 | Chevrolet Silverado Cars & Trucks

1 Answer

The steering wheel of my 2009 corolla became hard to turn with the its malfunction light is on , please what should i look at by my self


Add power stearing fluid, if its still hard to turn after adding fluid the the power stearing pump is bad and needs to be replaced

Dec 07, 2010 | 2009 Toyota Corolla

1 Answer

Hard stearing after replacing high pressure side hose but not all the time


POSSIBLE AIR IN SYSTEM,MAKE SURE RESERVIOR IS FULL. RAISE FRONT WHEELS OFF GROUND KEY ON ENGINE OFF TURN STEERING WHEEL FROM MAX LEFT TO MAX RIGHT 50 TIMES. MAKE SURE RESERVIOR IS FULL. ALSO MAKE SURE BELT BELT HAS NO P/S FLUID ON IT, IF IT HAS FLUID CLEAN IT OFF WITH BRAKE CLEANER

Aug 22, 2010 | 2000 Cadillac DeVille

2 Answers

2002 hyundai elantra power stearing pump replaced. Loud squeal and chatter when stearing left or right. HELP


was the p/s system bleed of air properly before running the new pump. wheels should be off the ground and the fluid reservoir full then wheels turned from left to right all the way and top of fluid as needed. then start engine and continue to cut left and right. fluid aeration will cause premature pump failure and noise. also ensure that no other parts are restricted, i have seen faulty valves in the rack or lines cause restrictions in the flow and cause the pump to fail even new ones. hope this will help you

Jan 28, 2010 | Hyundai Motor 2002 Elantra

1 Answer

Where do i put my power stearing fluid in my 1998 ford escort


2b9a938.gif

Position the vehicle on level ground. Run the engine until the fluid is at normal operating temperature. Turn the steering wheel all the way to the left and right several times. Position the wheels in the straight ahead position, then shut off the engine. Check the level in the reservoir; it should be at the FULL mark. If fluid is required, remove the cap and add fluid until it reaches the FULL mark.

Jan 10, 2010 | 1998 Ford Escort

1 Answer

WHERE IS THE P. STEARING FLUID FILLING PORT LOCATED?


It is always in the hood on the passenger front towards the full light. It has black rubber cover.

Jul 08, 2009 | 2003 BMW Z4

1 Answer

No power stearing new rack 3 weeks ago


you probably need a new power steering pump

Feb 28, 2009 | 1995 Lexus ES 300

2 Answers

Noise in front end when steering wheel is turned


is your van 4WD, AWD, or rear wheel drive? if it is 4WD or AWD, the front axle seals might be going bad. PLEASE RATE MY ANSWER.

Feb 26, 2009 | 1997 Ford Econoline

1 Answer

Stearing pump nnoise 1995 toyota tacoma


you may have air in the lines to the steering rack. or the fluid is low. there is also a chance your replacement pump is defective. a lot of steering pumps are remanufactured. a way to check for air in the lines is to take the filler cap off, have someone turn the steering wheel lock to lock a few times and hold for a few seconds at full lock each time, check to see if any air bubbles arise in pump reservoir. if no bubbles are seen you can also try a vacuum pull on the reservoir if you have the tool to do so, that tool will pull any air from the lines, but the engine has to be off because it will also pull some fluid from the pump in the process, when you don't see any air bubbles in the vacuum tools's lines it should be ok.

Jan 03, 2009 | 1995 Toyota Tacoma

Not finding what you are looking for?
2005 Dodge Durango Logo

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...