Question about 1994 GMC Sierra

1 Answer

Started truck, idrove 2 feet, engine died and now i have no electricsl power at all

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Check for a loose battery cable. I had a Buick that did that but when I closed the hood I guess it made contact and would start up and run for weeks. My local mechanic could not figure it out. I eventually took it to a dealer and it only cost me a hand shake.

Posted on Aug 13, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 2004 chevy pickup/v6,it was running finewhen Idrove it homefrom work,has not started since,will turn over right along but starting,help

Make sure you have ample fuel pressure for the engine. You need at least 40# at the fuel rail for the injectors to function.

Feb 22, 2018 | Chevrolet Cars & Trucks

2 Answers

Just turns off on it's own, Wait 60 sec. restart press pedel it dies.

This engine is electronically controlled so the first thing that must be done here is to have the systems control computer tested for fault codes and then do the proper diagnostics based on those codes.

Jun 07, 2012 | 1995 Plymouth Voyager

1 Answer

I have a 97 chevy cavalier with a 2.2 liter engine and an automatic trans. i replaced the head gasket and it ran fine for about a month. Then it suddenly started sputtering and stalling, it also had a loss...

you need to take the car to a muffler shop and have the catylitic converter changed... the converter is stopped up not letting the exaust leave the engine thus stopping it.

Jun 12, 2010 | 1997 Chevrolet Cavalier

1 Answer

Ford 204 Expedition will not start. There is no power nothing. I got the truck started then when I drive 40 feet is died. Battery is good. Connections are good. Would this have somethng to do with the...

no probably bad feul pump. test pressure on top of the engine in the feul rail with a pressure tester. you could also have a freind listen for the pump at the rear of the truck. drive sloly till it dies and does the pump sound go away? it is a common problem.

Dec 27, 2009 | 2004 Ford Expedition

1 Answer

Will not shift to 2 gear

If you keep accelerating will it catch third or does it stay in 1st? Does it **** hard when you put it in gear?

Mar 14, 2009 | 1984 Chevrolet K2500

1 Answer

Completed tune up, drove for 2 blocks, engine shut down

Just having fuel is not enough on this engine, here are the spec's. Even 1 psi out of spec can cause a no start.

Fuel Pressure
Pressure 1 (PSI) Pressure 2 (PSI) Pressure 3 (PSI) Range Note Range Note Range Note 60.0 - 66.0 Y131 50.0 - 63.0 Y132 66.0 Y133 Y131: System pressure with ignition on (PSI).
Y132: System pressure while idling (PSI).
Y133: Fuel pump pressure (PSI) with return line briefly restricted.

Feb 24, 2009 | 2000 Chevrolet Blazer

1 Answer

Car died wont start

You can check for spark if there is none then check for power to the coil if that checks out the replace ignition module .

Dec 06, 2008 | 1988 Chevrolet Beretta

1 Answer

89 volvo 240 dl wagon stalls and will not even turnover

If you can get it running again, get it to an electrical shop where they can test the charging system. If the alternator is still bad, it will continue draining the battery. If it won't run, pull the alternator and take it to a shop that can test it.

Nov 26, 2008 | 1992 Volvo 240

1 Answer

I replaced the water pump, starter, timing belt and thermostat, 2 days later I started up the tracker, backed up 3 feet and it died, can't get it started. Plugs are fine, getting gas in the carborator, I...

You may have a timing problem. Have you double checked to make sure that piston #1 is just barely past Top Dead Center? Sometimes when a person puts belts on it turns the pullies, and knocks off the timing. Also, did you undo the motor mounts and jack the engine up to remove the H2O Pump? If you did, you may have unseated the transmission. which would explain why the car died after going three feet.


Jul 21, 2008 | 1995 Geo Prizm

Not finding what you are looking for?
1994 GMC Sierra Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

81285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides