Question about Lexus RX 300

Open Question

My lexus rx300 model TA-MCU15W-AWPGK-B FRAME MCU15-0265665 ABS LIGHT STAY ON...MANY TIME RESET BUT STILL ON CHECK BY COMPUTER READ "SHORT CIRCUIT IN ABS MOTOR RELAY CIRCUIT CODE C0274... WHAT IS IT MEAN ? IF WANT TO BUY ABS WHAT PART NUMBER FOR MY CAR

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1861 Answers

SOURCE: car codes

When you have P0440, P0441 and P0446, it is a very good bet that the fuel cap was loose, or the fuel cap rubber seal is compromised. You will get all three of those codes every time that the cap is loose. Always make sure that the fuel cap is as tight as you can get it after you refuel.

Posted on Nov 13, 2008

Ad
keithheavili
  • 410 Answers

SOURCE: ? to Replace Timing belt on 2000 Lexus Rx300 with 57,000 miles.

If it is running perfectly I wouldn't think that you would need to replace the timing belt. You shouldn't need to replace that until 100,000-120,000 miles. I would definitely hold off until now unless you have start having some timing problems. Let me know if you have any other questions. Thanks for rating my response and for using FixYa!

Posted on Jul 08, 2009

  • 23 Answers

SOURCE: High RPMs

yes its related to knock sensor because car is running rich in fuel, and car runs of on safe mode, so overdrive will be off. have you and a friend replace it. remove intake assembly, then intake manifold, but first remove your anifreeze from radiator, trust me you want to remove antifreeze! their are brackets by the fire wall to hold down the manifold, thats the hard part is taking it off and putting that on since not to much space to work on it. on the block you'll see the two knock sensors, has 2 wires each, knock sensors cost between 150- 200 a piece, still cheaper than dealership putting it on. also buy some liquid gasket because you will need that. after putting it all back together reset the ecu and you should be fine,

Posted on Jul 14, 2009

  • 17 Answers

SOURCE: replace side marker light on lexus rx300

Remove 3 - 4 screws on fender cover close to side marker light. Pull fender cover out a bit for you to use your other hand to reach side marker light. By twisting on one direction and here you go the light out. Replace new bulb and replace everything on reverse order.

Posted on Aug 18, 2009

  • 17 Answers

SOURCE: Replacing outer tail light on Lexus RX300 ?

Normal 0 false false false MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-fareast-font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;} Lift the hatch. The tall center light is located behind the upper hatch inside panel. There are two panels need to remove. One panel is on the right, the other on the left. To remove the panels you have to use flat screw driver to pry out the panel in several locations. (These panels are secured by several small metal clips.) Be careful to collect all these clips and replace them on the back of the panel. You will need these clips to replace the panel later on. After remove the panels, you will be able to locate the screws on the tall center stop light assembly. Remove those screws and cover. After replacing light bulb. Assemble everything in reverse order. Remember, the metal clips have to set on the back of the two panels not the car body.

Posted on Aug 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi hoping one of you's could help me. I have a year2000 lexus is200 the problem is the abs light comes on with the Trc light flashing which cancels out any trc. It will stay on for a while the cancel...


The TCS gets it's signals from the ABS, so if the ABS detects a problem it'll automatically shut off the TCS. The ABS problem can be a bad wheel speed sensor or corrosion on the "tone" wheel. Get the trouble codes read so you'll know which wheel is causing the problem. The knocking is the ABS system working as if you're going into a skid, so the computer is getting a bad signal. Read this post on ABS sensors

http://ricksfreeautorepairadvice.com/abs-light-on/

ABS light on Ricks Free Auto Repair Advice

Oct 10, 2017 | Lexus Cars & Trucks

1 Answer

Lexus es300 got auto code p1150. What does this error mean?


Air Fuel Ratio Sensor not working within set parameters

P1150 LEXUS Air/Fuel Ratio Sensor Circuit Range/Performance ...

https://www.autocodes.com/p1150_lexus.html
The 1150 code is set when A/F sensor output voltage change value is not what the Engine Control Module (ECM) is expecting. P1150 LEXUS Description. The Air-Fuel ratio (A/F) sensor varies its output voltage in proportion to the air-fuel ratio.

Repair solution to 2000 LEXUS 300 RX code P1150.Thanks,XXXXX ...

https://www.justanswer.com > Car Questions > Lexus Troubleshooting Repair solution to 2000 LEXUS 300 RX code P1150.Thanks,XXXXX@XXXXXX. - Answered by a verified Lexus Mechanic.

Engine Sensor: Code Reads P1150 After All Resets. Vehicle Is a ...

https://www.2carpros.com/questions/2000-lexus-rx-300-engine-sensor Feb 22, 2011 - Code reads P1150 after all resets. Vehicle is a 2000 Lexus RX300 with 90,000 miles. On-line research tells me it should be an air fuel ratio ...

Experience W/ Code P1150 - 99 - 03 Lexus RX300 - Lexus Owners Club ...

us.lexusownersclub.com > ... > 99 - 03 Lexus RX300 Jul 27, 2009 - 12 posts - ‎4 authors
I recently replaced the Air/Fuel ratio sensor and thought I would consolidate all the info I found as well as my experience into one post for future ... Cel Codes P0125, P1150, And P1155
5 posts
11 Apr 2011
Urgent Help: 99 Rx300 With Cel {p0141, P0171 ...
11 posts
31 Jul 2008
P1130 And P1150 Dtcs...
4 posts
19 Feb 2007
Multiple Codes - P1150, P1153, P1155, P0330
12 posts
7 Sep 2005
More results from us.lexusownersclub.com

Lexus es300 error code p1150 Google Search

Aug 30, 2017 | Lexus Cars & Trucks

1 Answer

Why is my lexus rx300 vsc and engine light on?


Usually means there is a hard fault code in memory.
Go to your local Auto Zone and have the codes pulled and give them to me.

Master Tech Lee Auto Repair Help US

Sep 14, 2014 | Lexus RX 300 Cars & Trucks

1 Answer

1999 lexus rx300 4wd eng. light comes on, no power, rough idle hesitation cat converter cherry red. when computer reset runs ok for short time


Converter is ruined, as are the O2 Sensors

Now you have to fine out why

Rich Condition or Overheating,
Engine Misfires

Have fun !!

Feb 16, 2011 | 1999 Lexus RX 300

1 Answer

2003 rx300 - problem the skid control light came


Most likely a bad wheel speed sensor or wiring harness issue.

Jul 02, 2017 | 2001 Lexus RX 300

2 Answers

Check engine light is on


no such thing as a catalytic computer... there is a catalytic converter ... part of the exhaust system so they may now be "guessing" that it's an O2 sensor. take the car to autozone... they will scan the codes for free.... post the codes here tho the lads and lasses there are pretty clever and will probably tell you what the codes mean.

Apr 16, 2009 | 2001 Lexus RX 300

1 Answer

Check engine light on 2000 Lexus RX300


no. the next time the light sets codes you need to have the coputer scaned.

Feb 22, 2009 | 2000 Lexus RX 300

1 Answer

Lexus rx300 check engine/ vsc light


Vehicle Stability Control is part of the ABS function and is probably due to moisture on the brake pads when not used for a while.

Jun 01, 2017 | 2002 Lexus RX 300

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

119 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

907 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...