Question about 1996 Mercury Grand Marquis
1996 Mercury Grand Marquis 4.6L SFI 8cyl
Fig. 1: The fuel pump is located in the fuel tank. On some models it can be viewed from the side as shown here
Fig. 2: Electric fuel pump removal
The Relay - Fuel Pump is located: Under hood, driver side, front side of wheelwell, mounted in relay block.
Hope this help to solve it (remember comment and rated this).
Posted on Aug 02, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Lets try a new keyswitch and a fuel filter. The key activates the starter side of the ignition. This terminal should power both the starter solenoid and the fuel pump. Although the fuelpump runs on the ignition side continuously, you should be primed when the key is in the "on" position. I would wonder if the pump is cutting off too early meeting the resistance of a dirty fuel filter.
Posted on Jul 26, 2009
check the fuse .if the fuel pump was bad you blew the fuse . there is a inertia switch in the trunk or under the dash you could check . push the red button to reset relay should be under the hood in the fuse box check your book if you have one.
Posted on Nov 19, 2008
It should be under the vehicle on the drivers side. Follow the fuel line under the car and you should see it mounted up agains the floor pan.
Posted on Jun 22, 2010
you will need the proper Quick Disconnect tool, Look on the Frame rail for the filter, remove filter from the spring type retainer, remove the safety clips on the lines but not remove them completely, insert the disconnect tool & push into the fitting of the fuel line, push line & tool into eachother then pull filter away from line, if not done properly you will have a big problem putting the line back on
Posted on Oct 28, 2009
Raise car under frame then put jack under axle before removing the shock.
Can use locking pliers to hold the shaft from turning (may have to cut away dust boots). Top nuts are accessed and can be seen from the wheel wells or from the gap between the trunk and mount frame (can't see nut from this angle). Take care with fuel lines near the driver side nut.
Preventing shafts from turning on new shocks will be tough. Make sure you have a proper tool to fit top of shaft with enough room between top of shaft and trunk (gap decreases as the nut is tightened) so the tool can be removed.
Posted on Mar 30, 2009
Tips for a great answer:
Oct 10, 2017 | 1996 Mercury Grand Marquis
Jul 25, 2012 | 1989 Mercury Grand Marquis
Sep 12, 2011 | 1996 Mercury Grand Marquis
Mar 19, 2011 | 1996 Mercury Grand Marquis
On your 2000 Mercury Grand Marquis 4.6L SFI , the Fuel Filter is located: Under vehicle, passenger side, below seating area, passenger side of fuel tank, mounted on frame in fuel line
it is attached to the frame near the rear passenger side door by a hose clamp, so you need a screwdriver to loosen the clamp, and pliers to remove the lines.
Mar 15, 2011 | 2000 Mercury Grand Marquis
Feb 10, 2011 | 1988 Mercury Grand Marquis
Jun 02, 2010 | 1996 Mercury Grand Marquis
Oct 18, 2009 | 2001 Mercury Grand Marquis
Apr 18, 2009 | 1996 Mercury Grand Marquis
Dec 16, 2008 | 1996 Mercury Grand Marquis
1,761 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: