Question about 2005 Ford Escape

1 Answer

Cyclinder will not fire and I have replaced the coil pack and had the computer checked out

Posted by on


1 Answer

Iam going to answer this with a question.

If you don't work on your own vehicles and you go to a shop that does.

My question is--How does a Shop replace a coil pack and do other diagnostic checks, and give you a vehicle back with a cylinder misfire?

Posted on Aug 03, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2000 honda passport got 3 cyclinders firing and 3 not

Check for power at the injector plugs. The injectors are on one power source. No power, broken wire. If you have coil on plugs, do the same. If you have a coil pack, check for spark on the bad side. No spark, replace the coil pack.

Feb 24, 2016 | 2000 Honda Passport

1 Answer

Engine hesatation. engine stalls. engine idles very ruffly. engine has no pick up.

The 4.0 V6 can have injector problems and not be running on all cyclinders. You can pull one plug wire or injector connector one at a time witht hte engine running and see which cyclinders aren't running. The 4 cyclinder has two coils and one of them can stop working and it'll still run but lose alot of power pulling one plug wire off the coil pack and seeing the spark with it running they shoul all spark so if you find one the does'nt even though other wires are firing in the coil pack you have to repalace the whole thing to get it to work right. It this information does'nt help you or you check and find more troble add a comment and i'll help you somemore. I really need to know what engine you have and what country your in as these cars are built a litttle differently depending on the country they were built for.

Apr 19, 2011 | 1998 Ford Ranger SuperCab

2 Answers

Engine light comes on and engine runs rough.

That's not a question

You have a check light on- got to
get codes set and diagnose that issue

Runs Rough--may be related,still have to
have diagnose and repair

If you do all your own work,
ask a question

Feb 09, 2011 | 2004 Jeep Grand Cherokee

2 Answers

The code is # 1 cylinder miss fire. i replaced plugs and wirers still running bad but no code yet

check for spark at the coil, if its weak, or no spark, replace the coil pack.

Dec 03, 2010 | 2001 Ford Windstar

1 Answer

For coe pack

I'm fuessing that your refering to the coil pack. The coil pack has the plug wires coming out of it and they connect to the spark plugs. Theirs a 7 wire electrical connector hooked to it and they are key on power and a ground wire one for each cyclindrt going to the engine control module. As the computer grounds these wires the coils fires the cyclinders connected.

Oct 26, 2010 | 2001 Dodge Intrepid

1 Answer

I have an 2002 buick century that has a iginition miss. We have changed the spark plugs, iginition wires, coil pack. It first came back with a miss fire number 2 cyclinder. The coil pack was changed. Now...

double check plug wires to be sure they go to the right cylinders. After that i would check fuel injectors
You need a listening device and listen for metallic clicking sound. Bad injectors will be silent and they do cause the same miss

Apr 21, 2010 | 1997 Buick LeSabre

2 Answers

02 camry firing on only 2 cyclinders

If 2 and 4 won't fire no matter what coil is there, then you likely have problems with either spark plugs or spark wires. If rotating the coil packs doesn't make a difference, it has to be something that's always "with" those cylinders, which would be plugs and/or wires. A new set of plugs is very inexpensive, and isn't a bad idea, especially if it's been awhile since they were changed. I'd try them, see if it works, and if it doesn't, try swapping spark wires between cylinders (at both ends - undo the wires from the coil AND plug and move them to another cylinder and see if the fault follows).

Sep 27, 2008 | 2002 Toyota Camry

Not finding what you are looking for?
2005 Ford Escape Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides