Question about BMW 525

Open Question

BMW e34 1992 WINDSCREEN WIPER LINKAGE SLOPY PASENGER SIDE WHERE CAN I GET PARTS AND HOW MUCH COULD THIS COST

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 97 nissan sentra windshield wiper linkage arm disconnected

Most likely you will have to replace the wiper linkage from the center pivot to the left or drivers-side wiper pivot. The plastic piece in the linkage gets brittle over time and breaks down. To save a hassle in the future, replace both linkages. It should be under $20.00 for parts.

Posted on Sep 14, 2008

Ad
  • 1 Answer

SOURCE: Wiper linkage broken

i had this problem for my 1997 HONDA ACCORD

MAKE SURE IT IS NOT THE MOTOR
to do this turn on the windshiled wipers. if you hear the motor, it is fine.

SECURE THE PART
you cannot buy the plastic part which is called the bushing. technically it is called the wiper linkage bushing. (well you can buy the bushing, but usually from a place like autozone and they dont sell it for our car. ) so you have to buy the part from honda, and you have to buy the whole arm, called the wiper linkage. (you have two of them, an A and a B. A is on top, B is on the bottom)

TAKE DOWN THE COWL
that is the plastic part over the motor and the wiper linkages

REMOVE OLD WIPER LINKAGE

APPLY NEW LINKAGE --BUT LUBE UP SURFACE VERY WELL,, b/c it will be too tight.

SET WIPER to ZERO to make sure it wipes the way it needs to.

hope this helps. BUT if it doesn't HONDA can put it on fro about 45 minutes if you take down everything, and all they have to do is put on the arm and put back on the wipers!

TESS





Posted on Dec 05, 2008

  • 64 Answers

SOURCE: e34, 1994: DME module das not respond with carsoft

its fried

Posted on Jul 11, 2009

  • 1619 Answers

SOURCE: where is the windscreen wiper relay located on a

should be under the screwed down cover behind the fuses in the engine compartment.
If your wiper is having issues normally it is the mechanical side of the unit. Try going to www.benzworld.org or peachparts.com and look on how to lubricate it.

Posted on Jul 12, 2009

  • 2 Answers

SOURCE: Refitting windscreen wiper linkage

Good evening Kah2110,

I assume you have replaced the linkage by now and all is fine?

I have freed a sticking spindle (driver side) but now find I can't seem to get the wipers arms positioned properly - did you find that there is a sequence/procedure to follow?

Many thanks

Please reply to gharborough@aol.com and not this email addresss.

Many thanks

CAG

Posted on Jul 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The passenger side windshield wiper stopped working but the motor is good & driver side works


the wiper arm may have come loose from the motor linkage , where the arm joins the linkage outside of bonnet/hood there is a flip up cap , under there is a nut that holds the wiper arm in position , this may be loose so remove completely then remove the arm as the splines may not be in the correct position, replace the arm so that when it is laid back down on windscreen it is level with the bottom and tighten the nut , you must tighten the nut with the wiper arm raised so as to get a good fit , this may require a couple of attempts to get in the exact position when wiper arm is laid back down, hope that makes sense

Mar 09, 2015 | Cars & Trucks

1 Answer

Why has my drivers windscreen wiper suddenly stopped working?


There is one motor driving both wiper arms. If one side has stopped and the other side still works, it is likely that the point there the are connects to the drive is stripped or slipped off. Check at the point where the driver side wiper arm is attached to the drive / pivot point

Oct 13, 2014 | 2003 BMW Z4

1 Answer

The wiper arm on the passenger side stopped wiping. Someone told me that a small screw on the end of it probably needs tightening but I can't find it. Can you help me ?


Hello! Is the cap nut that holds the external wiper arm missing?...If so you can purchase one at any Nissan parts department...If the internal linkage is broken...The cowl cover and cowl needs to be removed to access the wiper motor linkage...The linkage comes in one piece...See photo below and cost around $60...Guru....Saailer


saailer_106.jpg

Jan 26, 2011 | 1996 Nissan Maxima

1 Answer

I have a 1993 BMW 320i and I want to change the windscreen wiper motor. I have no idea where it is situated and how to do it. Please help. Thanks


If you open the hood, it's on drivers side under the cowl. It's held down with three bolts and is attached to an arm that connects wiper arms. If you have the tools it's fairly easy. If not have a reputable shop do it.

Jan 07, 2011 | BMW 325 Cars & Trucks

1 Answer

Need to no where the rear windscreen relay swicth


Where exactly is the rear wiper relay in an X3??

Feb 21, 2010 | 2009 BMW X5

2 Answers

Wipers worked one turn then stopped


may have broken bushing in one of the arms in the wiper linkage, remove the cowl and take a look. most part stores sell replacement bushings start there good luck.

Jan 07, 2010 | Mitsubishi Colt Cars & Trucks

2 Answers

I have bmw 525. the wiper was working but suddenly its stopped. when i try the switch, its try to move but few cm.i have cheake the fuses, its ok. please hep me. thanks


I have had a similar problem. On mine it was a linkage arm/socket that kept popping out, stopped both the wipers working with one stuck half way across the screen and the other wiper upright against the side of the screen.
Cost £8 for a new one.

Mar 08, 2009 | 2001 BMW 5 Series

1 Answer

Refitting windscreen wiper linkage


Good evening Kah2110,

I assume you have replaced the linkage by now and all is fine?

I have freed a sticking spindle (driver side) but now find I can't seem to get the wipers arms positioned properly - did you find that there is a sequence/procedure to follow?

Many thanks

Please reply to gharborough@aol.com and not this email addresss.

Many thanks

CAG

Aug 23, 2008 | 2002 Audi A6

9 Answers

97 nissan sentra windshield wiper linkage arm disconnected


Most likely you will have to replace the wiper linkage from the center pivot to the left or drivers-side wiper pivot. The plastic piece in the linkage gets brittle over time and breaks down. To save a hassle in the future, replace both linkages. It should be under $20.00 for parts.

Jul 13, 2008 | 1997 Nissan Sentra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Anthony Jones
Anthony Jones

Level 2 Expert

128 Answers

Frankie B

Level 2 Expert

65 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...