Question about Chevrolet Silverado 1500

1 Answer

How do I replace my dash light bulbs in my 1989 Chevy K1500

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 130 Answers

THEY HAVE LIGHT BULBS BEHING THE CLUSTER AND BEHING THE DASH SWITHCES, REMOVE AND YOU SEE LITTLE SOCKETS THAT TWIST OFF AND REPLACE THE BULBS WITH THE BURN ONES. HOPE THIS HELPS YOU SEND A FEEDBACK THANKS

Posted on Aug 02, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1989 chevy have brake lights when park lights are off but when park lights are on have no brake lights pulled the light cover off noticed that the middle buld was on which is for stop, tail, an turn...


Check the brake light switch on the brake pedal. Sounds like it slipped out of adjustment. When pedal is depressed, the button on switch will extend and be on to pass current to the bulbs.
Also, you need to figure out the tail lights: those two filament bulbs are for park lights and for brakes/turn signals. One filament is for the parks, the other filament is for both brake and turn signals. American cars have the brake lights wired through the turn signal switch- from the brake light switch on the brake pedal to the turn switch, and then out to the rear bulbs for brakes and, or turn signals.

Feb 11, 2018 | 1989 Chevrolet K1500

1 Answer

Left turn signal quit working. 1969 chevy pickup-


sounds like you have a bad flasher which is usually located near the steering column under the dash. check for ground on front left bulb. may have to replace light socket if ground is good.please leave comment.

Mar 20, 2010 | 1983 Chevrolet K1500

2 Answers

What to do when the dash lights go out in a 1989 chevy caprice


check the fuse first. If fine the bulbs circuit behind the clusted may have a open burnt circuit

Mar 13, 2010 | 1989 Chevrolet Caprice

2 Answers

Turn signal makes the dash lights flash


97 chevy blazer left turn signal makes the dash lights flash then when i turn parking lights on left signal stays on constent when engaged

Jan 16, 2010 | 1995 Chevrolet K1500

1 Answer

1989 chevy 1/2 ton.brake lights or emergency flashers dont work.tail lights an blinkers work.


The Blinkers and the Brake Lights are the same bulb. So check the brake light switch. Flashers use a different flasher unit, than the turn signals

Dec 16, 2009 | 1989 Chevrolet K1500

1 Answer

I have a 1989 chevy silverado and the parking brake light on the dash is blinking


could be bad e-brake light sensor or ebrake is not fully disengaged.

Oct 01, 2009 | 1989 Chevrolet K1500

1 Answer

Dome light not working on my 1994 chevy k1500 is it the switch located on the side of the dash board?


could be. fuses ok? does it operate if you open a door? is the bulb good?

Sep 25, 2009 | 1994 Chevrolet K1500

3 Answers

1991 Chevy Blazer dashboard lights are burned out. Can't read


Your dash needs to come out. These bulbs push into a plastic piece that "twists" into the back of the dash board. (About a 1/4 turn) Unless you can get at them from underneath, but I think it's to tight.

Aug 13, 2009 | 1989 Chevrolet S-10 Blazer

1 Answer

Dash lights


sounds like you need to replace the board that the bulbs fit into

Aug 11, 2009 | 1992 Chevrolet K1500

2 Answers

Bad tail lights on 89 chevy 1500


you should be able to just unscrew two screws that holds the tail light to the truck, then just twist and pull to remove the bulbs then replace with a new bulb, this should fix it. otherwise its a wiring issue

Jun 16, 2009 | 1989 Chevrolet K1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

213 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

81285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...