Question about 2003 Porsche 911 Carrera

1 Answer

Top would not go back up after the panel moved out of the way. after a couple of hours when I tried, it worked. Afraid to put top down now. Anything I should try or look for?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,297 Answers

Most common issue on these were the parking brake switch and the ground wires however there are no active recalls or campaigns

unless the parking switch is active the power top control module/computer will not allow the top to operate

Posted on Aug 02, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 350z Nissan convertible top wont close all the way to the trunk


Lubricate every single part that moves in the top frame all the hinge points, use a light oil like 3 in1. Wipe off the excess do not get it on the interior trim like seats and door panels. Move the top up an down a few times to work the oil in and then try putting it all the way down. Good luck

Sep 28, 2016 | 2006 Nissan 350Z Coupe

1 Answer

2008 Chrysler Sebring hard top convertible goes halfway back to open then stops in the middle of the cycle.


There are many possible causes of this problem on the convertible Sebrings, the most common problems are as follows;

1) The cargo platform in the trunk is in the wrong position which blocks the rear window from folding downward. Ensure that the cargo platform is in the down position before attempting to operate the top.
2) The Hydraulic pump is low on fluid, it is located in the trunk, in the left rear corner, underneath the carpet. Inspect the fluid level in the reservoir.
3) There is an electrical fault in the system.
4) There is physical damage to one of the panel pivots, inspect for panel binding while the top is moving.

A couple questions for you;

When the top stops moving can you still hear the pump running or does it go quiet?

When the top stops moving does the cluster display "convertible top in operation" or "convertible top malfunction" or something else?

Report back with anything you find or if you need further help.

Nate

Aug 26, 2015 | 2008 Chrysler Sebring Convertible

1 Answer

Starting problems Nissan Maxima 2006


It could well be the battery. Charge it up for 24 Hours.
Get to know a good mechanic, We are worth it.

Oct 06, 2009 | 2006 Nissan Maxima

1 Answer

The power window on my 1993 Mercury Grand Marquis is not working?


more than likely the motor in the door. pull the door panel off and try hooking the motor up directly to the battery and see if it will move up and down if you hear the motor running but nothing happens pull the motor out take the cover off of the gears and see if the little nylon bearings are the if nut a cheap fix is to get a couple of nuts that will fit in the slots with a little slack and put it back together and motor should work.

Aug 29, 2009 | 1993 Mercury Grand Marquis

1 Answer

Dismount door panel. VW Polo Net


Sounds like it is a broken window regulator. You will need to remove the door panel to fix it. Mine broke and I can actually pull the window up and it will stay until the vibrations of the freeway eventually make it slide back down again (this would be a temporary fix of course). Anyways, there are a couple screws behind the door handle I believe, and then some snaps around the edges, and some clips along the window line. You should get a Bentley's manual so you know exactly how to fix the window regular. 

Jun 15, 2009 | 1999 Volkswagen Jetta

1 Answer

Driver side power window will not go up


You have a bad door motor. When you wait a few hours and it goes back up slow. The motor has had time to cool off and allows voltage to run thru the motor windings. common problem. You need a new motor. On some models you can remove the door panel and manually move the motor to roll up window.

Jun 12, 2009 | 2001 Chrysler Town & Country

2 Answers

'00 Mercury Cougar Wont get out of Park. gear shifter is stuck


sounds like your brake/shift interlock solenoid is not releasing.
Your owner manual will tell you how to bypass in emergency.
Check your fuse first. fuse panel on instrument panel.

Please rate as fixed if this helps.

Fuse 23 - 1 5 amp
Fuse 34 - 7 1/2 amp

check enigne light not related.
----------------------------------------------------

The selector lever lock can be moved mechanically out of position ”P" when for example the battery is disconnected or completely discharged.
Using a ball point pen or similar item as an unlocking lever, push forward and hold in position.

Move the selector lever out of position "P".

NOTE: If the selector lever is moved back to ”P" it is re-locked.

Selector Lever Lock

9f95ca1.gif

Apr 28, 2009 | 2000 Mercury Cougar

1 Answer

2003 Jeep Liberty Power Window Off Track


its the window regulator. not to bad to change. just a couple of screws to remove the door panel. peel the liner back & remove the 6 10mm bolts and uunhook the electrical connector and the window from the regulator. installation is reverse

Jan 21, 2009 | 2007 Jeep Liberty Sport

2 Answers

98 bmw 740i wont start


I would first check the condition of the battery. If the battery is okay, that is it puts out enough current to operate the starter. I would then check for a short. The battery would be dead in a couple of hours only if there is a short or another load on the battery.

Oct 04, 2008 | 1998 BMW 7 Series

Not finding what you are looking for?
2003 Porsche 911 Carrera Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Porsche Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

896 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

Are you a Porsche Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...