Question about 2006 Mini Cooper
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Horn alarm randomly beeps
Make sure to check all doors, the trunk latch, and the hood to ensure that they are shut. I have looked up your 2006 Chevy Malibu and there has been a lot of people complaining about the alarm system and it going off. There is a TBS (Technical Service Bulletin) out for your car. The TBS says that the Faulty Door Sensor. Take it to your local dealership and tell him what I found for you and they should get you a quote on how much it would cost to repair it.
Thank you for using Fix Ya!
Any questions don't hesitate to ask me.
Don't forget to rate the overall satisfaction of this solution.
Posted on Feb 02, 2009
SOURCE: how do I reset my
you can not reset it. all you have to do is go to the dealer and get a new sensor. once the sensor touches the disk it opens up the circuit, thus you have your brake pad warnning.
Posted on Feb 09, 2009
Sounds like an transmission control module problem I have seen this and often times just replaced the trans mission control module and found everything working properly again.
Posted on Mar 01, 2009
this is how i replace the coolant on minis. remove the lower splash shield and disconnect the lower radiator hose right off the radiator. when it stops draining, resecure the hose and clamp. next , ur going to have to refill and bleed the cooling system.i do this through the coolant resevroir. this is important, or else ur vehicle is going to overheat and boil over no matter if the system is full or not. there are 2 coolant bleeder valves. open both valves a little and fill the coolant system with the correct coolant. fill the coolant. fill the coolant till it begins to come out of the 2 valves . when coolant begins to come out through the valves slowly and steady with no air pockets , go ahead and close up both valves and run vehicle to normal operateing temps, make sure vehicle isnt overheating and u should be fine. u may have to repeat the procedure over again. once u do it once u remember how next time. ( the two bleeder valves are sort of hard to explain in words where they are, they arent hard to access ) u can turn them with a flathead screwdriver) they are usually black and plastic.
Posted on Apr 03, 2009
this is something if you need to ask you need to leave to the professionals . not to be mean but that is your life you are playing with and one little air pocket in the line could cause you your life. buy the way it is a 2006 there really shouldn't be any reason you should need to change this yet.
any way take the cap off brake bleeder loose at the pass side rear and use a brake line bleeder kit to drain the fluid any refill the resivior as needed then do the driver rear bleeder then the pass front then the driver front
just rememver to never let the resivior get empty
Posted on Oct 05, 2009
Tips for a great answer:
Jan 12, 2016 | Mini Cars & Trucks
Oct 19, 2014 | 2006 Mini Cooper S
Mar 02, 2011 | 2006 Mini Cooper
Sep 03, 2010 | 2005 Mini Cooper
Dec 21, 2009 | 2005 Mini Cooper
Aug 07, 2009 | 2006 Mini Cooper
Jun 02, 2017 | 2006 Mini Cooper
Jan 15, 2009 | 2006 Mini Cooper
169 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: