Question about 1989 Chevrolet S-10 Blazer

Open Question

1989 chevrolet s10 pickup truck won't stay running

1989 chevrolet s10 pickup truck 5 speed, 2.5 liter engine, will crank but won't stay running, it shuts off as soon as I let go of the key. If I hold the key to the start position then it will stay running but as soon as I let go, it shuts off. I have replaced the ignition modue, ignition swith, stater, oil pressure sensor, map sensor, and rebuilt the distributor. Does anyone have any ideas???

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 422 Answers

SOURCE: 1998 chevrolet k1500 pickup 305 a misfire in # 2 cylinder

hi there, if you can feel the misfire at an idle but not at a higher rpm than the fuel pressure regulator is bad im working on one right now that has mifire code and random misfire codes coming up

Posted on Aug 28, 2008

Ad
  • 1 Answer

SOURCE: 2000 chevy blazer, truck cranks

Does your battery go dead?

Posted on Dec 18, 2008

  • 19 Answers

SOURCE: S10 pickup misifirng when light highway load

I had to rebuild my engine at 97000 miles cuz of low engine oil pressure and bad berrings

Posted on Jan 09, 2009

  • 54 Answers

SOURCE: how do I replace the wiper pulse module on a 94

open hood and go to the wiper motor remove electricle plug and plastic cover you will see a circuit board i believe you will be able to get it from there if not holler at me

Posted on Mar 19, 2009

luv2tango
  • 36 Answers

SOURCE: 98 s10 starts and then dies

How did the water get into the fuse pannel? Was this vehicle a flood victum? Or, just some rain. It kind of makes a difference on what I'm about to tell you. I guess if it was a little water from rain the first thing I would do is check the relays.They are nothing more than little switches ad water can have an effect on them. The points in them could be corroded, weaken the springs, etc. Start there. Then check wire connections for corrosion, and loose or broken wires. Do you have any type of repair manuals? If you can, identify the relays, many times there are several that are the same and you can move them around and interchange them to help you find a bad one. Other wise there are some electrical tests which you can perform on them, but you will need some electrical test equipment. Let me know if this fixes your problem or if you need to know how to test the relays.
If on the other hand this vehicle was flooded, you have a lot of checking to do, starting with the computer. Do you have a diagnostic tester? You may need one.
I hope this helps you.

Posted on Apr 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause you to lose fuel pressure while driving.


Chevrolet S-10 Questions - Fuel System Loses Pressure ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusJul 28, 2012 - Fuel System Loses Pressure - I have a 2003 Chevy S-10 Pick Up with the 4 ... car a few times, what essentially you are doing is priming the fuel pressure. ... A dirty fuel filter will not cause the lines to lose pressure after the engine is shut off. ... I have a 98 s10 2.2 liter and it was driving fine all day then when ...

Chevrolet S-10 Questions - My 2001 S10 has a hard starting ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusSep 16, 2012 - My 2001 S10 has a hard starting problem if the truck sits between 1 ... Vacuum leak, have you checked fuel pressure while it sits? ... Would the spider alsocause a misfire at low rpms? .... at an idle, or squeaking while driving and it gets faster as you go? ..... 1994 Chevrolet S-10 2 Dr STD Standard Cab LB.

Chevy S-10 Won't Start - Repalced Fuel Pump and Pressure ...

www.cartruckinfo.com/chevy-s10-wont-start.html
Chevrolet S-10 pickup won't run and has no fire unless I jumper the fuel pump relay. ... Once the truck starts and is running you can remove the jumper to the fuel pump ... Iwould get the fuel pressure checked to start with, because that's where the ... 93 gmc 4.3l FI runs but dies out loss of power after 5 mins of running then ...

Stalling S10: I Have a 1994 Chevy S10 2.2l It Stalls After 35 ...


Dec 10, 2015 | 1994 Chevrolet S-10

1 Answer

How many liters of 80/90 weight gear oil does my 1990 chevy c1500 take in the transmission?


Fill at side fill hole until fluid begins to run back out. Let it run until it stops, install plug and wipe up excess. If fully drained, usually holds less than 3 liters.

Sep 02, 2015 | 1994 Chevrolet C1500

1 Answer

93 s10 blazer with 4.3 liter vortec won't stay


You first need to run a fault code test on this engine, to do that go here.

Oct 10, 2012 | Cars & Trucks

2 Answers

Ineedthefiringorder


1985 Chevrolet S10/T10 P/U 2.8 liter V-6

2a49b1c.gif

1985 Chevrolet S10/T10 P/U 2.5 liter L4

818a8ae.gif

Hope helps (remember to rate and comment this)

Sep 22, 2010 | 1985 Chevrolet S-10

3 Answers

Need firing oder for 1999 chevy s10 pickup 4.3L


1999 Chevrolet S10/T10 P/U 4.3 liter V-6 VIN "W"

66379a1.gif

Hope this helps (remember to rate and comment this).

Sep 15, 2010 | 1999 Chevrolet S-10 Pickup

1 Answer

'98 S10 4 cyl. 5 speed: Sudden high idle, now surges.


Go to your local shucks or auto zone and they can check any codes behind your check engine light and it's free. It sounds like one of two things a O2 sensor or your mass airflow sensor but they will tell you for sure

Oct 02, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

1998 Chevrolet S10 2.2 liter is popping


u need to replace the distrbuter cap and roter , clean the MAF by brake and parts cleaner

Mar 15, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

1989 s10 pickup will not crank after everything gets warm.


i had a old ford that had the same problem thiers afew things itcould be.... flywheel..... Out of time...... check timing and timing belt..... and make sure ur battery termials are nice annd tight. check starter!

Feb 17, 2009 | 1989 Chevrolet S-10 Blazer

1 Answer

1987 Chevy S10 won't stay running


is the engine running at unusualy low RPMs. if so the engine could be going.

Jan 26, 2009 | 1987 Chevrolet S-10 Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

228 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...