Question about 2008 Chevrolet Express

1 Answer

2008 chevy express 2500 with a 6.0 crank sensor problems

I have a 2008 chevy express van with the 6.0l motor and it keeps going through crank sensors. tried napa ones and the last 2 were GM ones.


thanks

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 22,265 Answers

Check the alternator ouptut ,it shouldnt go above 15v ,

Posted on Aug 01, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tire pressure monitor on my 2008 chevy van not working how or where is fuse for monitoring system?


Sensors are rf transmiters and the door lock module is the reciever this information is the sent to the body control module and then to the display on dash. Is only tire pressure monitor having a problem?
most comon problwmis damage to sensors during tire changing









Jan 12, 2011 | 2008 Chevrolet Express

1 Answer

2006 chevy express 2500 van with 4.8L idles really low, when you floor it it bogs down, after you let off the gas it dies, replaced the fuel pump already


Clean the throttle body with throttle body cleaner and make sure the air filter is not dirty or plugged.Also clean the mas air flow sensor with mass air flow sensor cleaner.Give this a try and let me know if it took care of your problems.Hope this helps.Good luck.

Sep 05, 2010 | 2006 Chevrolet Express

2 Answers

How to replace brake light in 2008 chevy express cargo van


You have to remove the upper applique to remove the tail lamp, it is the trim panel above the lamp. I think it is held in place by two nuts/bolts but not sure. You have to have the rear doors open to remove it

May 23, 2010 | 2008 Chevrolet Express

4 Answers

My chevy express van 1500 cranks but wont start


test and see if you have spark and fuel preasure, you may have bad feul pump, common problem is the fuel pump goes bad, but check before replacing.

Oct 01, 2009 | 2000 Chevrolet Express Cargo

2 Answers

Engine 1 fuse keeps blowing when you turn the key


sounds as if you have a power shortage in the van. first establish what fuse keeps blowing this will help in narrowing down the short.once short is located check all connections ,wires,and plugs.

Jul 12, 2009 | 1999 Chevrolet Express

5 Answers

2002 chevy express fuel pump/crank sensor?? not starting


i had a similar problem and called the dealer during lunch hour. i talked to a mechanic, the distributor in these vehicles is plastic, and is prone to cracking.not just the cap but the body also, I have been taking the cap off and wiping the moisture out of the cap. or replacing the cap but the problem is I need a new distributor. just a cheep way to get rolling is cleaning the inside of the cap, especially when it is very damp or the outside temp changes alot during the day. good luck.

May 27, 2009 | 2002 Chevrolet Express

1 Answer

What Code PO171 means I have a chevy express awd 2500 van 2003 124k miles


hello, this is an oxygen sensor code, usually replacing the sensor in question solves this, it is caused by low crooss counts by the sensor. good luck, marty

Apr 24, 2009 | 1987 Ford Ranger

3 Answers

1997 Chevy Express 2500


try to spray a little fuel into the throttle body or carb and see if it starts and runs if it does check your filters and spider injectors also it wouldnt hurt to check your hall effect sensor

Jan 17, 2009 | 1997 Chevrolet Express

1 Answer

2002 chevy express fuel pump/crank sensor?? how to change


THE CRANK SENSOR IS LOCATED RT UNDER THE CRANK PULLEY. IT IS USUALLYEASIEST WITH AN EMPTY TANK TO REPLACE IT.

Dec 05, 2008 | 2002 Chevrolet Express

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

521 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...