Question about 2000 Isuzu Rodeo

2 Answers

Start engine and engineine pops for couple of

Start engine and engine pops for couple of minutes than runs ok but
trans lights always stay on and flickers along with engine light 2000 isuzu rodeo

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 18 Answers

Have the ABS pump ECM checked (it is separate from the main ECM), try to catch it early. I bought a transmission last year. This is typical 98-02 Rodeo behavior.

Posted on Aug 15, 2010

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I own a 2000 rodeo, and the lights are working but there flickering on and off while the trucks running, but when i press on the gas the lights stay lit, also when i press on the gas i hear a slight rumbling sound on the drivers side.

Posted on Mar 14, 2011

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 6 Answers

SOURCE: Were is my ABS sensor located on my 2000 Isuzu Rodeo

there should be a sensor at all 4 wheels so make sure there all pluged in 

Posted on Jul 04, 2009

  • 1 Answer

SOURCE: brake light bulb

I have a 2000 Isuzu Rodeo and had the same problem. On the 2000, there are 2 screws on the side of the light assembly and 1 at the bottom the need to be removed. I found I needed a longer philips screwdriver for the bottom screw as there is not much room. Once you remove the screws, pull straight back on the unit. There are 2 plastic pins that are about 3/4" that will pop out of their socket when you pull straight back. Then, just lift the unit out and replace the bulb.

Posted on Jan 03, 2010

  • 2 Answers

SOURCE: my 2000 isuzu rodeo has a reduced power light come

i had the same issue and it was my APP senser. its located in your gas pedal

Posted on Apr 16, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Check trans light pops up when I put the key in ignition and start the truck up then it goes off and the Rpm rev for a little bit


You didn't mention the year, make, or model of your truck, but it's irrelevant.
As long as the light turns off once the engine is running, nothing to worry about.
It is normal for an electronically-controlled engine to "rev" momentarily when it is first started but, if the RPMs stay over 1000 for more than a minute, there's a problem.

Jul 19, 2014 | Cars & Trucks

1 Answer

I have a 1991 pontiac trans sport with a cold start engine surge. At cold start up the engine will increase and decrease in the rpm and sometime die but ofter the van worms up it seems to run ok.


remove and clean IAC ( idle air control ), this is what controls idling on to days cars. if this does not help a lot, check or replace coolant tempurature sensor. it may be bad, if it is, it will think the engine is always warm and send wrong info to pcm. good-day ! and may god bless. you can also have a vaccumn leak ! if check engine light is on, get it scanned to know what area is causing the problem.

Oct 16, 2011 | 1991 Pontiac Trans Sport

2 Answers

I HAVE A 2002 HONDA CIVIC, WILL START BUT WON'T STAY RUNNING, HAS NO FAULT CODES WHEN HOOKED TO DIANOGISTICS


ok -
Have you checked your fuel source: How old is the fuel in it now - is there a chance of water being in there? How about your Fuel pump/pressure? - Fuel filter? How about the gas cap - is it vented or creating a vacume?

Alternatively how long does it stay running - till it heats up? only a couple of minutes??

Mar 06, 2011 | 2002 Honda Civic

1 Answer

1997 Buick Regal GS Auto starts but won't stay running. Any ideas? Fuel pump runs a couple seconds and then loses pressure.


you have to monitor the fuel pressure, if you find that the pressure drops off as soon as the engine has started you should check the fuel pump resistor located on the frame next to the windshield washer tank. If the resistor is ok see if you can keep the engine running with carb cleaner. If the engine stays running on the carb cleaner try disconnecting the mass air flow sensor and see if the engine continues to run by itself. This is all taking for granted that there is not a security system problem. check if the security light keeps flashing while trying to start.

Jul 08, 2010 | 1997 Buick.5 Regal

1 Answer

Transmossion problem on a1998 chevy ck1500 with a 4.3l vortek, 4l


only diagnostic procedures will find the exact cause. Unless you have the info and the tools to perform this your going to have to have a shop perform this for you.
Guessing only works if your always lucky when you go to Vegas.

Dec 29, 2009 | 1998 Chevrolet C1500

2 Answers

Engine management fault


this is going to sound nuts but its true.if your brakelight switch is defective that light will flash.
see if you brake lights are working.if it is automatic trans you will notice the shifter will not always release when you depress brake pedal.
if its not brakelight switch get it autoscaned with a VAG.com

Dec 06, 2008 | 2001 Volkswagen Golf

2 Answers

Intermittent Speedometer Operation


Replace the speed sensor on the transmission. This controls the speedometer.

Oct 07, 2008 | 2000 Dodge Caravan

Not finding what you are looking for?
2000 Isuzu Rodeo Logo

314 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...