Question about Jeep Liberty

1 Answer

P0137 was the code that popped up on the reader

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 22,156 Answers

P0137....O2 Sensor Circuit Low Voltage (Bank 1 Sensor 2)

Posted on Aug 01, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car has gone into limp mode with both codes reading. P0457 and P0137. I have already done a smoke test to see if there were any leeks and we could not find any. any help would be appreciated.


P0131 and P0137 - OBD-II Trouble Codes - RepairPal

repairpal.com > ... > P0131 and P0137 - OBD-II Trouble Codes
Definition of error code P0131 and P0137 - 02 Sensor Low Voltage (Bank I ... Decrease in fuel Eeconomy because PCM is in a "limp home" mode; Engine dies .... The AAmco company replaced 2 oxygen sensors in my car and the engine light ...

Sep 25, 2015 | Cars & Trucks

1 Answer

Code p0137 2003 pontiac grand am


You use Google to find out what
the codes are & the solution

Apr 04, 2013 | 2003 Pontiac Grand Am

1 Answer

P0137 issues changed out manifold new sensor new cat converter. Still have p0137. HELP!


Essentially the same as P0136, P0137 refers to the second oxygen sensor on Bank 1. P0137 means the O2 oxygen sensor's voltage remained low for longer than 2 minutes. This, is interpreted by the ECM as a low voltage condition and sets the MIL. Bank 1 Sensor 2 is located to the rear of the catalytic converter and should produce an output signal relative to oxygen storage capacity of the catalytic converter. This rear (sensor 2) sensor is less active than the signal produced by the front sensor. However, if the ECM senses the sensor is inactive, this code will set.

There may be no visible symptoms to the driver, other than the MIL (Check Engine / Service Engine Soon) illumination.

A code P0137 may mean that one or more of the following has happened:
Faulty o2 sensor Exhaust leak near the rear sensor
Plugged catalyst
Short to voltage on O2 signal circuit
High resistance or open on O2 signal circuit

Hope helps; your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

Oct 24, 2011 | 2000 Hyundai Elantra

1 Answer

Codes P0131, P0137, P0341, and B1218. Code P0131 and P0137 were listed twice. This is for a 2000 chevy venture. I already spent $400. 2 years ago for emissions


HI ghosthunter6 codes P0131&P0137&P0341 indicative of having electrical short .
P0131 Front Heated Oxygen Sensor Bank 1 harness is open or shorted .
P0137 Rear Heated Oxygen Sensor Bank 1 harness is open or shorted .
P0341 Camshaft position sensor harness or connectors (The sensor circuit is open or shorted) .
code B1218 horn relay coil circuit short to voltage battery .
IT could be cousin problem with other sensors .
First replace horn relay and clear E C M codes
IF problem and codes P0131&P0137 come back you need o2 sensors .put I don't thank so.
YOU MUST REPLACE HORN RELAY .OK

good luck


Jul 27, 2011 | Chevrolet Venture Cars & Trucks

1 Answer

I have code p0137 coming up on my 2003 jeep grand cherokee laredo what does the code mean?


P0137 - Oxygen O2 Sensor Circuit Low Voltage (Bank 1, Sensor 2)

Essentially the same as P0136, P0137 refers to the second oxygen sensor on Bank 1. P0137 means the O2 oxygen sensor's voltage remained low for longer than 2 minutes. This, is interpreted by the ECM as a low voltage condition and sets the MIL. Bank 1 Sensor 2 is located to the rear of the catalytic converter and should produce an output signal relative to oxygen storage capacity of the catalytic converter. This rear (sensor 2) sensor is less active than the signal produced by the front sensor. However, if the ECM senses the sensor is inactive, this code will set.

Symptoms: There may be no visible symptoms to the driver, other than the MIL (Check Engine / Service Engine Soon) illumination.

Causes: A code P0137 may mean that one or more of the following has happened:
* Faulty o2 sensor Exhaust leak near the rear sensor
* Plugged catalyst
* Short to voltage on O2 signal circuit
* High resistance or open on O2 signal circuit

Possible Solutions:
* Replace faulty sensor
* Repair exhaust leak near the rear sensor
* Check for restriction in catalyst and replace as necessary
* Repair short, open, or high resistance on o2 signal circuit

Hpe hti shelps (remember comment and rated this).

Jul 26, 2010 | 2003 Jeep Grand Cherokee

2 Answers

P0137 and u1120


P0137 -o2 sensor circuit low voltage [bank 1 sensor 2] sensor is located after cat converter--- possible faulty sensor/broken -damaged-disconnected sensor circuit wiring / plugged cat converter / exhaust leak by sensor --- the U1120 is an undefined enhanced manufactures specific code --wheel distance message --the PCM doesnt receive a vehicle speed message from the anti-lock brake module over the CAN C bus -possible CAN C bus circuit open or shorted / anti-lock brake module damaged or defective / PCM problem notify a dealer may be a recall or a service bulletin on the problem the code seems to pop up on the durangos also might get lucky and be covered under warranty

Feb 01, 2010 | 2004 Dodge Durango

2 Answers

I am getting a trouble code thats reading P0137 on my reader for a 2004 Liberty chrysler, any idea as to what the problem is


Symptoms There may be no visible symptoms to the driver, other than the MIL (Check Engine / Service Engine Soon) illumination.
Causes A code P0137 may mean that one or more of the following has happened:
  • Faulty o2 sensor Exhaust leak near the rear sensor
  • Plugged catalyst
  • Short to voltage on O2 signal circuit
  • High resistance or open on O2 signal circuit
Possible Solutions
  • Replace faulty sensor
  • Repair exhaust leak near the rear sensor
  • Check for restriction in catalyst and replace as necessary
  • Repair short, open, or high resistance on o2 signal circuit

Jan 18, 2010 | 2004 Jeep Liberty

1 Answer

I just get a 2000 lanos but the check engine ligth is ON when i put it the code reader says to me 2 codes : 1st code is P0137 and p1336 say a lot lf items but got to be only one of those , whath can be???...


Essentially the same as P0136, P0137 refers to the second oxygen sensor on Bank 1. P0137 means the O2 oxygen sensor's voltage remained low for longer than 2 minutes. This, is interpreted by the ECM as a low voltage condition and sets the MIL. Bank 1 Sensor 2 is located to the rear of the catalytic converter and should produce an output signal relative to oxygen storage capacity of the catalytic converter. This rear (sensor 2) sensor is less active than the signal produced by the front sensor. However, if the ECM senses the sensor is inactive, this code will set.

Symptoms There may be no visible symptoms to the driver, other than the MIL (Check Engine / Service Engine Soon) illumination.

Causes
A code P0137 may mean that one or more of the following has happened:
  • Faulty O2 sensor Exhaust leak near the rear sensor
  • Plugged catalyst
  • Short to voltage on O2 signal circuit
  • High resistance or open on O2 signal circuit

  • Possible Solutions
  • Replace faulty sensor
  • Repair exhaust leak near the rear sensor
  • Check for restriction in catalyst and replace as necessary
  • Repair short, open, or high resistance on o2 signal circuit
The other code is your crankshaft position sensor. You need to replace both of the sensors and the check engine light will go off.

Sep 28, 2009 | 1999 Daewoo Lanos

1 Answer

2000 saturn SL2,reader says PO131and (PO137 Peading)


P0131 - oxygen sensor circuit low voltage (bank 1 sensor 1)
http://www.obd-codes.com/p0131

P0137 - oxygen sensor circuit low voltage (bank 1 sensor 2)
http://www.obd-codes.com/p0137

www.obd-codes.com

These websites help me a lot. Hope they do the same for you too.









Jun 07, 2009 | 1999 Honda Civic

2 Answers

Code P0157 and P0137


Hi P0157 is
02 sensor circuit low voltage bank 2 sensor 1

P0137
02 sensor circuit low voltage bank 1 sensor 2

May 06, 2009 | 2000 GMC New Sierra 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

464 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...