Question about 2007 Chevrolet Tahoe

1 Answer

How to change oil on a 2007 chevy tahoe

Where do I locate the bolt to drain oil and is the filter the one that's tucked on the side of I think the oil pan.

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 78 Answers


Posted on Aug 01, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to replace oil filter adapter gasket on a 2007 impala

Remove Front Right Side Wheel and Plastic well Covers Remove Drive Belt From A/C Compressor Undo The 3 bolts Holding the A/c Compressor To the Block Then You Can Locate The Three Bolts Holding The Adapter to the Block If you Have Not Done So Drain All The Oil from the Car (I suggest Draining the Oil By Taking Filter Off Not By The Drain Plug) That Way You Still Have A tiny Bit Of Oil Still In The Pan Remove The Adapter And Gasket Clean Both Faces To Ensure New Gasket Seals Right Then Place New Gasket and Reattach Adapter and The Bolts Followed By The Filter Then Re assemble the As Compressor And So on remember to check That all Bolt Are tight God Bless and Good Luck

Nov 15, 2012 | 2007 Chevrolet Impala LS Sedan New Cars

1 Answer

I need to know exactly where the oil filter is located on my 2001 Chevy Tahoe.

it's under the vehicle on the drivers side next to where the engine and transmission meet. If you can see the drain plug the filter is right next to it.

I’m happy to assist further over the phone at

Mar 25, 2011 | 2001 Chevrolet Tahoe

1 Answer

How to change the oil in a 2002 chevy trailblazer

Get the oil, and filter first then get it up on jack stands. On the side of the oil pan is a 15mm bolt, remove that bolt and drain the oil. Once that is done put the bolt back in and tighten it up. Next locate the oil filter and spin off counter clockwise, let all the oil drain and then take the new filter and dab a little of the used oil on your finger and smear it on the new seal for the new filter. Tighten up the new filter and then take the car off the jacks. Pop the oil filler cap and add oil. Once you have done that start the car for 60 seconds then turn it off and check your oil level. Add more oil if needed. Then your done.

Jan 03, 2011 | 2002 Chevrolet TrailBlazer

2 Answers

Were is the drain plug located on a 2007 chevy 5.3 on the passenger side of engine . is it behind the ac unit. i want to put a engine block heater in.

The block drain is on the passenger side of the engine, in the center of the block near where the oil pan attatches to the block.

Engine Block Plugs/Sensors

Engine Block Plugs/Sensors
100 - Engine Block
100 - Engine Block
101 - Oil Gallery Plug - Front
110 - O-Ring
111 - Oil Gallery Plug - Rear
112 - Oil Gallery Plug - Side
113 - Washer
114 - Engine Coolant Heater
115 - Washer
116 - Oil Gallery Plug - Side
117 - Washer
130 - Transmission Housing Locating Pin
145 - Washer
146 - Engine Block Coolant Drain Hole Plug
701 - Crankshaft Position (CKP) Sensor
702 - O-Ring
718 - Knock Sensor
718 - Knock Sensor
739 - Bolt
739 - Bolt
750 - CKP Sensor Bolt

Oct 19, 2010 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

Changing the tramission filter on a 2007 Saturn Vue Hybrid

Hello and welcome. here is the instructions for removing the trans filter. you will need to drop the bottom trans pan off to gain access to the filter.

  • Remove the oil pan bolts from only the front and the sides.
  • Loosen the rear oil pan bolts about 4 turns.
  • Lightly tap the oil pan with a rubber mallet or pry in order to allow the fluid to drain.
  • Remove the remaining oil pan bolts.
  • Remove the oil pan.
    Install the oil pan attaching bolts.
    Tighten the bolts to 12 N·m (106 lb in).

    Aug 13, 2010 | 2007 Saturn VUE Green Line

    1 Answer

    How to change the oil on a 1999 ford expedition

    oil filter located inside of front drivers side fender. lay down and look up you will see the filter in the front of the fender. oil drain plug located on the back of the black oil pan I think its a 15mm bolt unbolt let drain. When done draining put it back in the oil pan. next pull oil filter off turn counter clockwise and put new filter back on then fill with 6quarts of oil. I think its 5w-30 but you can use 10w-30 won't hurt it.

    Aug 10, 2010 | Ford Expedition Cars & Trucks

    1 Answer

    Hi i have a 2007 chevy tahoe, i just changed oil & filter but now oil pressure lite comes on but it doesnt come hot. Do you have any idea on what could be the prob or how to fix it?

    double check the oil level - should hold aprox. 6 quarts, 5w30. make sure the filter and the drain plug are tight. make sure it is a quality brand of filter you put on, or there could be an internal problem with it. if all else fails, have an oil pressure test performed to ensure you are not going to damage your engine. good luck!

    Jun 15, 2010 | 2007 Chevrolet Tahoe

    1 Answer

    Where are the oil drain plug and oil filter located on my 2003 tahoe so that I may change my own oil? any special instructions?

    Here is a step by step video on changing the oil and filter on your Chevy Tahoe. It starts with a lot of safety information, but will quickly get into the process.

    Jan 21, 2010 | 2003 Chevrolet Tahoe

    2 Answers

    I am having problems locating the oil drain screw to empty the oil so I can change it

    The engine oil drain bolt is a size 15 mm wrench.It will be on the lower side of motor block on the pass side of the vehicle.....get back to me if you have any other questions...HOPE I COULD HELP!!!

    Nov 20, 2009 | 2007 Chevrolet Equinox LS New Cars

    1 Answer

    Recently purchased a 2007 Camry, 2.4 Liter 4 cycle 2AZ-FE engine. My older 2001 camry had the oil filter located on the rear front (left side of the engine. Where is the oil filter located on my new c

    Your filter is visable by looking under the car. its near the exhaust pipe again, but toward the front of the car. tucked near the plastic air shield.

    Apr 29, 2009 | Toyota Camry Cars & Trucks

    Not finding what you are looking for?
    2007 Chevrolet Tahoe Logo

    326 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts


    Level 3 Expert

    81400 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22359 Answers

    Ronny Bennett Sr.
    Ronny Bennett Sr.

    Level 3 Expert

    6927 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides