Question about 1997 Honda Accord

1 Answer

A/c doesnt cool the car. High pressure line is hot low pressure line is warm.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 22,156 Answers

The valve on the evaproator ,or in laymans the restrictor valve thats bolted to teh rad thats inside the car

Posted on Aug 01, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Front AC cold but Rear AC very hot


Not likely, but Is Hot water flowing to heater coil in back? How hot is "very hot" Is it a refrigerant line? If a refrigirant line, Very Hot means it is hot gas from the compressor that "should be going to the condenser coil usually in front of the radiator. It's almost impossible for that Hot refrigerant gas to go to the cooling coil in the back unless you had some repairs done and they weren't certified. My guess is the radiator hot water is not being controlled properly, due to bad valve or control system components.

Jun 07, 2015 | 2009 Saturn Outlook XR

1 Answer

Where is the low pressure switch on my 2006 Dodge Ram Diesel


The low pressure switch would be around the air dyer system.

If line drier is cool on one side and warm on other you have a line restriction. Is compressor cycling on and off.?.. be careful jumping low pressure switch...The high pressure on low side is restriction going to evaporator coil in firewall... check for a filter in cab for evaporator coil it may be stopped up

May 16, 2014 | 2006 Dodge Ram 2500

1 Answer

A/c does'nt get very cold comming out of vents center vent feels kinda cold. left and right vents by the doors is warm. a/c is fully charged pressures are right were they should be hihg and low side...


use a proper AC machine and remove the gas so its weighed on removal and i do think you will find that its undercharged with gas ,most vehicles operate with around 750 grms of gas by weight and i think yours will show about 150 grms of gas so it works but it doesnt get cold enough ,the low pressure pipe out of the valve under the bonnet should be well cold with condensation on it and the inlet pipe which is thinner should be warm to hot ,unless you have operating flap thats not closing properly that is ,but i would stick the machine on it and weigh the gas to make sure before you pull the dash apart

Jun 07, 2011 | Chevrolet Monte Carlo Cars & Trucks

1 Answer

1997 geo prizm the AC blows air out at 80 degrees, I had the pressures checked and they are at the proper pressure, the high pressure line is warm to hot but the low pressure line is just cool, the...


What are the pressures?And the low side line going into the firewall should be cold.We need to know what the pressures are,and is the evaporator sweating>and giving off condensation?If the vents are blowing out 80 degrees,then the temp door is not moving .It is either a door actuator motor,or a vacuum that is not working the temp door,check for a bad vacuum under the hood,going into the firewall.

Aug 03, 2010 | 1997 Geo Prizm

1 Answer

Cold air with low fan but warm air with high fan


If there was a blockage,the low pressure pipe would freeze up after awhile.Check that there is sufficient gas in the system and there are no leaks.The high pressure should be between 8-13 bar and low pressure shouldbe between 1.8-3 bar.

Aug 17, 2009 | 2006 Volkswagen Passat

1 Answer

01 Suburban AC question


check the space between the ports, it is common to have both fittings on the same line if and only if the orifice tube is located between them because thats what seperates the low pressure side from the high pressure side, the high pressure side will be warm to hot when the a/c is running, once the hot liquid hits the orifice tube it turns into a cool vapor, so if you feel one side is hot and one side is cool then the orifice tube is whats between them and it is true that the low and high pressure sides can be on the same line.

Jun 30, 2009 | 2001 Chevrolet Suburban

1 Answer

Durango AC Wont Cool


Yes,it probably is & cheapest way to start. 200 isn't the end of the world,150 is normal. Depending on ambient temp that could be fine. The dryer could be restricted as well. Last possibility is the r134 is low or overcharged.

Jun 27, 2009 | 2004 Dodge Durango

1 Answer

AC not cooling


IS IT LOW ON FREON?HAVE THE FREON LEVEL CHECKED FIRST

May 01, 2009 | 1992 Pontiac Bonneville

Not finding what you are looking for?
1997 Honda Accord Logo

Related Topics:

363 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...