Question about 2006 Nissan Altima

1 Answer

Pls guide me how to remove Ac dash vents from Nissan Altima 2005

The dash AC vents are broken and i want to replace it by myself

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 87 Answers

You need to look online for a junk yard called pull apart an you can get all your parts fairly cheap I would buy the book for the car cost 20-30 dollars it will be most vaulable in this adventure

Posted on Aug 01, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 2005 Nissan murano the a/c compressor comes on and hot air comes out the vents. Please help

Your problem is most likely caused by a jammed AC/Heater temperature control blend door and or blend door electric actuator motor. The door is stuck in the heated air position and can't move to divert the air flow across the cold AC evaporator core. In most cars this problem requires the entire dash assembly be removed to replace the parts.

Jul 14, 2016 | 2005 Nissan Murano

1 Answer

I have a 2005 Nissan Altima I need to bypass the ad compressor I have a Nissan Altima and I am trying to bypass the AC compressor until I can get the money to put a new one on there is...

-Why you need to by pass the AC...? You mean you want to replace the belt with out going to the AC motor...? Even the AC motor is not running you still be able to use same belt number with out any problem. Unless the AC motor is frozen.
-If so. Make sure the AC is not on it's way and make sure you can
adjust the new belt to it tension. Just use a rope to wrap around the pulley to the accessory you need to run and make a circle then take to auto part store to match the length.

Good Luck


Feb 09, 2015 | 2005 Nissan Altima 2.5

1 Answer

2009 Altima, 2.5. We recently had the BCM and radio replaced, transmission control module reprogrammed, engine torque rods and buffer assembly replaced by Nissan under an extended warranty. After getting...

Sorry to tell you this, but neither of those computers would require any work on the HVAC case. The BCM is located above the instrument cluster. The TCM is located under the hood [which is a very poor location] I'm a 35 year professional mechanic. Sorry to tell you this, but my opinion of the Altima is very poor. These things have all sorts of problems, are hard to work on and the parts are very expensive. Lots of recalls and TSBs [technical service bulletins] TSB is dealer speak for "oops, we goofed". You can't blame the dealer for this one.

Dec 03, 2014 | 2009 Nissan Altima 2.5

1 Answer

Location of AC drain 2005 Nissan altima

Should be protruding from the floor near the firewall on the passenger side.

Jul 15, 2013 | Nissan Altima Cars & Trucks

1 Answer

A/C stuck on floor vent.

a vac. problem several possible causes a vac. line off at the vac. canister under the hood. a broken vac line with time some lines crack and are no longer functioning a bad activator under your dash. a bad control head on your dash if it just started acting up I would look to source vac.

Jun 25, 2012 | 2005 Nissan Altima

1 Answer

2005 altima blowing hot air

could be your switch, or you have a freon leak and there is no freon in the system. open hood and watch the ac pump and have them turn on and off the ac. if in engages then it is probably freon. if it doesn't check ac fuses.

May 26, 2012 | 2005 Nissan Altima 2.5

1 Answer

1997 Nissan 4 cylinder truck AC works excellent throwing snowballs cold air, then it will blow hot air. Relay switch and clutch has been replaced....Did not fix problem!

sounds like compressor isn't working properly or heater vacuum is opening vent to heater core.try turning on ac and if it cuts on and off repeatedly every few seconds the freon level is not correct or high pressure switch may not be working make sure radiator fan comes on when ac is on.if all this is working properly check vacuum hoses to heater may be opening vent doors to heater.hope this helps

Aug 11, 2010 | 2005 Nissan Altima

1 Answer

Weak vent air

your thermostat is not working properly it should trip off the A.C bt not doing so

Aug 01, 2010 | 2005 Nissan Altima

1 Answer

VIbration in AC/HEATER fan

I've had mice in my Nissan PU and actually caught one in a trap set on the floorboard; so I know they can get inside. They also knocked some of the fiberglass insulation into the blower motor so it vibrated as it was no longer balanced. You could have a dead one in your blower. Mine was easily accessible from under the passenger side under the dash. Three screws and the motor dropped so I could clean out the fiberglass.

May 07, 2009 | 2003 Nissan Altima

Not finding what you are looking for?
2006 Nissan Altima Logo

Related Topics:

563 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

81424 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides