Question about Ford F-150

Open Question

Traction control light and abs light stay on in my 2009 f150 laariat

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: ABS and Traction control stay on after smart car is started

Although I am unfamiliar with the smart cars, it sounds like you just need to reset your computer. Remove the negative cable from your battery, then flip your lights on, pump the brakes, press the horn. What this will do is drain all the capacitors including the ones in your computer. Ultimately it will reset your computer (aka turn off the ABS and TC light) hope this is helpful and good luck

Posted on Feb 04, 2009

Ad
  • 599 Answers

SOURCE: 2004 lincoln ls 3.0 abs light and traction control

have the car scanned with a scanner capable of reading ABS codes,get back to me with the code and we'll go from there. sounds like like one of the wheel sensors is bad. this controls both ABS and TRACTION CONTROL

Posted on May 15, 2009

  • 396 Answers

SOURCE: Engine light and ABS traction control light remain

The ABS sensor is a speed sensor also for Traction Control. This is why both lights are on , One of your front ABS sensors are bad or disconnected, or has a pinched wire.

Posted on Jan 16, 2010

daves944
  • 1050 Answers

SOURCE: 2005 impala ls the abs light and the traction control light comes

You'll need to have the codes read from the computer. You will have a code that indicates one of the front wheel sensors is bad. This could be the case, but they are very expensive as they are built into the wheel bearing assemblies. It is more likely that the wiring harness between the frame and the part of the front spindle that holds the harness, has broken internally. It is a very common problem and can be repaired with a new wiring harness section or by tracking down the fault and repairing it.

Posted on May 31, 2010

  • 27 Answers

SOURCE: ABS LIGHT AND TRACTION CONTROL LIGHT ON DASH

make sure u didnt break a wire, there are sensors on the brakes, make sure theyre plugged in

Posted on Jun 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Abslight stays on. How to fix? This is a2007trailblazer?


First you need to have EBCM - electronic brake control module check for DTC'S - diagnostic trouble code's . If the light is on there is a code stored . I think most part stores can do this and for free . After you find out what code is stored , looking up that code in service repair information for diagnostic trouble shooting chart would be next step . There are a few codes too.
DTC C0035 or C0040
DTC C0045 or C0050
DTC C0110
DTC C0131
DTC C0161
DTC C0186
DTC C0196
DTC C0201
DTC C0240
DTC C0241 or P0856
DTC C0244 or P1689
DTC C0245
DTC C0283
DTC C0287
DTC C0290 or C0292
DTC C0455
DTC C0550
DTC C0558

Find the code do the diagnostic's , fix the problem , wiring issue's , a sensor , bad module ,what ever it is . The light will go out then . Here is a sample of code discription .
• DTC C0035 Left Front Wheel Speed Sensor Circuit
• DTC C0040 Right Front Wheel Speed Sensor Circuit

Dec 30, 2016 | 2007 Chevrolet Trailblazer

1 Answer

What is making my stabilitrak light staying on


StabiliTrak service light - Chevy TrailBlazer, TrailBlazer SS and ...

forums.trailvoy.com > ... > 02-09 General Tech Q&A > General

Dec 24, 2009 - 11 posts - ‎7 authors
However, the StabiliTrak system seems to be working, as in my area ... If you have OnStar push the button when the Service Stabilitrak light is on have them run a diagnostic. ... 2007 Chevy TrailBlazer LS .... Choose your make. Service Stabilitrak light comes on
11 posts
Mar 31, 2011
Service Stabilitrak
11 posts
Mar 27, 2011
very strange thing happend/ traction control light ...
8 posts
Sep 2, 2010
Abs and traction control light
11 posts
Sep 20, 2009
More results from forums.trailvoy.com

Feb 09, 2016 | 2007 Chevrolet Trailblazer 4.2

2 Answers

Why does my ABS light stays on and sometimes i get a vibration in the brake petal causing my 2002 Cadillac escalade not wanting to stop?


Sounds like a fault with the Antilock Braking System. The vibration in the pedal is the ABS working. With your foot on the brake pedal, it releases and re-applies the brakes to stop a skid from the wheels locking up. You need professional service for brakes.

Seems to be a known issue on all Cadillac and requires the ABS module to be replaced.

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > DeVille Cadillac DeVille ABS Light Due to ABS Control Module Failure. This is a verified problem based on 126 reports. Learn more about this problem, when it occurs ...

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > Seville STS Traction control and ABS lights stay on dash. This is due to ecbtm Module gone bad. replace Module and this should fix the problem. You can go by the VIN and ...

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > DeVille DTS ABS Light Due to Control Module Failure on Cadillac DeVille DTS. The anti-lock ... ABS and Traction control light stays on. ... abs light to abs control stay on.

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > Seville SLS ABS Light Due to Control Module Failure on Cadillac Seville SLS. The anti-lock brake ... SLS135,000Jumsee. Abs and traction lights stay on when started.

Jan 12, 2016 | Cadillac Cars & Trucks

1 Answer

Where are the traction control senors in a 2009 chevrolet trailblazer?


The traction control uses the ABS wheel speed sensors (1 on each wheel - usually in the wheel bearing assembly). The speed sensor is for your speedometer. Do you have an ABS light on too?

Feb 16, 2015 | 2009 Chevrolet TrailBlazer

2 Answers

Vcs light and traction of light on


For this VCS and traction lights coming ON,its advisable to check/click this help links :----
VCS maintenance required ? http://howtobyme.blogspot.com/2011/11/vcs-maintaince-required-on-toyota-camry.html------- VCS and ABS lights go on and off intermittently? http://howtobyme.blogspot.com/2011/11/vcs-and-abs-lights-go-on-and-off.html
--------Traction control message? http://schematicsdiagram.blogspot.com/2012/01/traction-control-message.html
---------The ABS and Traction Control Lights stays ON dash of car? http://schematicsdiagram.blogspot.com/2011/06/abs-and-traction-control-lights-stays.html
----------This will help.Thanks.

Feb 09, 2012 | 2006 Toyota Highlander

2 Answers

Abs, brake and traction control light stay on. how do i reset them


I have a 2001 Cadillac Deville with 105,000 miles. The ABS and Traction Control light stay on. What could be the problem? Could I reset the ABS and Traction Control light?

Jan 09, 2011 | 2001 Cadillac DeVille

1 Answer

Brake peddle is chattering 2003 ion and would like to pull the anti lock brake fuse (if safe ) until i can afford the repair. I would like to know witch fuse to pull?ABS is on and traction control


If brake pedal is chattering or pulsating it is most likely because you need either front or rear rotors, or both. They are rusted or out of round. If there is something wrong with either your abs or traction control,the abs or traction control light will come on & stay on. As soon as these lights come on, it automatically disables abs or traction control. If you would like to take out fuse that disables abs or traction control circuits, it will leave the lights on.You just wont have their functions. If by some strange condition your chattering goes away, then there is indeed something wrong with your abs or traction control.Fuses are labeled abs or traction either under hood or in your fuse panel in car.

Jun 13, 2010 | 2003 Saturn ION

3 Answers

Both abs and traction control light stays on also spedo not working have checked all related fuses all ok have tried to scan with both snapon solus and launch x431 niether will communicate with abs ecu but...


had my 2000 chev impala 3.8 liter ,traction control llight and abs light both go on the reset it and go right back on .so i replaced both sides of the bearing hub assembly this is connected the senser,so far so good.replaced it dec 21 2009 about 3 hours ago. because the assembly came appart when took off.

Oct 30, 2009 | 1997 Acura CL

1 Answer

Transmission Traction "Off" light stays lit with Traction button


The traction control system is controlled through the Anti-lock brake system. The way it works is if one of your wheels starts spinning the ABS applys the brake to that wheel to transfer power to the oppsite wheel that is getting traction. If your ABS is bad then your Traction control won't work. To check it I would find a parking lot on a wet day. In an open space mash in the gas. if you hear the ABS system kick in and you don't squall the tires then your good. My guess is you won't. What I would be worried about is will my ABS work. When checking the traction control is a good time to check the ABS. Acclerate to around 15 mph, then mash the brake as your live depended on it. If you hear a motor run and feel a vibration or grind in the brake peddal, then it works.

Jan 09, 2009 | 1997 Buick LeSabre

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

2,214 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...