Question about 2000 Ford Windstar
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
From Lusty Kid:
I know the economy is bad, but change all of the plugs. Check your PCV Valve hose, 150 rottens them out allowing air to be sucked in, thus all kinds of codes.
Depending on mileage. Dismount the EGR valve and clean passages. If you are really good dismount the throtle position sensor body and clean out passages with Choke Cleaner., dismount where the EGR valves connects to the engine, clean out passages. Also check the hose thats behind this mounting to ensure is not clogged. If clogged clean it out. If not replace it. Is about 1.5 ft. long, connects to the PCV Valve Hose.
When is the last time you change your harness. Can't remember??? Replace it. Good Luck
Posted on Dec 26, 2008
This means that your key is not being recogonized.Ethier the chip in the key is bad or the patts transciever at the lock cylinder. Do you have a spare key? If not you will have to get 2 new keyss cut and programmed.
Posted on Feb 16, 2009
P0171 indicates a lean condition. The most common cause of this is a defective mass air flow sensor. Also check if any vacuum leaks.
P0174 OBD-II Trouble Code
System Too Lean (Bank 2) Basically this means that an oxygen sensor in bank 2 detected a lean condition (too much oxygen in the exhaust. Note: This DTC is very similar to P0171, and in fact your vehicle may show both codes at the same time. ----------- Thanks.
System Too Lean (Bank 2)
Basically this means that an oxygen sensor in bank 2 detected a lean condition (too much oxygen in the exhaust.
Note: This DTC is very similar to P0171, and in fact your vehicle may show both codes at the same time.
Posted on Oct 01, 2010
#1 Try starting the car in Neutral, if no start replace the Park and Neutral safty switch. #2 Check for a faulty starter solenoid. #3 Check for a faulty stsrter motor. #4 Check for a faulty ignition switch. #5 Check for faulty starter Relays.#6 Check the Transmission Range sensor it could be out of adjustment or defective. #7 On 1998 and later models, the power relay is in the power distribution box in the engine compartment. Refer to your owners manual for more information on relay location. Good Luck From Ernie @ RedDeer, Alberta, Canada.
Posted on Jan 11, 2011
Tips for a great answer:
Aug 05, 2014 | 1999 Ford Windstar
Apr 19, 2011 | 2000 Ford Windstar
Feb 17, 2011 | 2000 Ford Windstar
Jan 15, 2011 | 2000 Ford Windstar
Apr 18, 2010 | 2000 Ford Windstar
May 27, 2009 | 2001 Ford Windstar
Feb 15, 2009 | 2000 Ford Windstar
Sep 10, 2008 | 2000 Ford Windstar
Jul 28, 2008 | 2004 Ford Taurus
97 people viewed this question
Usually answered in minutes!