Question about 2002 Dodge Durango

Open Question

Where are the timing chain marks for a 2002 dodge durango 4.7 motor

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 512 Answers

SOURCE: 3.3l dodge caravan, where to set timing chain marks

the top gear timing mark points at 6oclock...crank gear at 12 oclock

Posted on Sep 27, 2008

Ad
farroutideas
  • 78 Answers

SOURCE: I need a time diagram of an 2002 dodge intrepid,

Hi there;

Here is a picture of the timing marks for the 2002 2.7L intrepid engine.


Hope this helps
Farrout!

Posted on Mar 17, 2009

landsend
  • 1066 Answers

SOURCE: HOW TO INSTALL AMP INTO A FACTORY RADIO IN DODGE DURANGO 2002

You can buy adaptor plugs that allow a simple hook up at most car stereo places.  However, when you increase the power going to the speakers you also have to replace the speakers to handle the higher power or you'll toast them. 

Posted on Apr 01, 2009

c17hydro
  • 2984 Answers

SOURCE: Timing Chain Cover, Chain, Sprockets, replacement

2.2L VIN 4 To Remove:

  1. Remove or disconnect the following:
    • Drive belt.
    • Drive belt tensioner.
    • Alternator.
    • Power steering pump. Place the pump aside with the lines attached.
  2. Lift the vehicle.
  3. Remove or disconnect the following:
    • Oil pan.
    • Crankshaft pulley and hub.
    • Timing cover bolts.
    • Timing cover. If necessary, tap with a rubber mallet to loosen the cover.
  4. Clean the mating surfaces.
To Install:
  1. Install or connect the following:
    • Timing cover gasket.
    • Timing cover and the bolts. Tighten the bolts to 11 Nm (97 in. lbs.).
    • Crankshaft pulley hub and the crankshaft pulley.
    • Oil pan.
  2. Lower the vehicle.
  3. Install or connect the following:
    • Power steering pump.
    • Alternator.
    • Drive belt tensioner.
    • Drive belt.

Posted on Aug 30, 2009

  • 1 Answer

SOURCE: need timing marks for jeep liberty

necesito marcar jeep liberty 2002 3.7

Posted on Feb 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2001 Dodge Durango my sprockets dots are where they are supposed to be but the white dots on my chain or not do the white dots on the chain matter


I Assume you have a 4.7 liter V8, have you taken the chains or gears off yet, if so, did you line everything up before disassembly and lock the gears with a locking fixture and chock the chains in the guides? yes, all the dots and marks matter. it is an interference engine which means if the cams are out of time with the crankshaft, severe valvetrain/piston damage can result when started. get out the manual and go over all the marks and be absolutely sure everything is exactly lined up before trying to start. turn the engine over by hand at least 2 full revolutions to check for interference , then recheck all timing marks again. before cranking with the starter motor. timing is critical on the 4.7, if its off, bad thing can happen, please take your time and be careful

Oct 24, 2014 | 2001 Dodge Durango

2 Answers

Time a dodge 4.7 litter


If you just want to check the timing marks on your Dodge 4.7L engine, skip ahead to step #32 of the procedure below.

I found this Dodge 4.7L engine info in a manual for the 2000 Durango 4WD
MFI 8 Cylinder, but whatever year your SUV/truck may be, all Dodge 4.7's should be the same.
I tried to post the entire procedure (with 5 illustrations), but got an error.
Happy Thanksgiving FunnyJennifer/Josh, and may your 4.7 keep perfect time.

Excerpt from Timing Chain & Sprocket Removal & Installation:
Dodge Durango 4.7L MFI 8 Cylinder
------------------------------------------------------------------------------------------
#32 Rotate the engine two full revolutions. Verify alignment of all timing marks:

Primary chain idler sprocket: dot at 12 o'clock

Primary chain crankshaft sprocket: dot at 6 o'clock

Secondary chain camshaft sprockets: V8 marks at 12 o'clock

Nov 20, 2011 | Cars & Trucks

1 Answer

How do I change the blower motor on a 2002 dodge Durango. The resistor has been changed and last three days. Blower motor ordered just looking at where and how to get to it.


the blower motor is located under pass dash, it has about 4 to 5 screws in it and you get to it by removing the glove compartment and or straight from the bottom there

Sep 09, 2011 | 2002 Dodge Durango

1 Answer

To install and take it apart/timing replacements? for a dodge durango 2001 4.7 2 wheel drive


What leads you to think your timing chain needs to be replaced? In the 4.7 motor, the timing chain is designed to last the life of the engine, or at least 150K.

May 19, 2010 | 2001 Dodge Durango

1 Answer

Looking for how to line up or time a dodge durango


I don't think you have to remove the timing chain, to do head gaskets. if you are talking about the distributor, you could use a paint marker to mark indicator marks on intake and on this distributor

Apr 10, 2010 | 2000 Dodge Durango

1 Answer

I need to know where the timing marks are on a 2002 dodge intrepid with a v6 motor.


the timing marks are located on all four cam cogs and the crank cog. there are also timing marks on the chain itself. there are three gold colored links on the chain. these corospond to the three cogs. good luck.

Sep 01, 2009 | 2002 Dodge Intrepid

1 Answer

I need a time diagram of an 2002 dodge intrepid,


Hi there;

Here is a picture of the timing marks for the 2002 2.7L intrepid engine.


Hope this helps
Farrout!

Mar 17, 2009 | 2002 Dodge Intrepid

1 Answer

Blower motor wire harness


Links show replacement of the resistor and wiring harness. Second link is to RockAuto where you can buy the resistor with a harness. Apparently (from the first link), Amazon also has the resistor available with the harness. Dodge Dakota Durango Blower Motor Resistor Replacement 2002 DODGE DURANGO 4 7L V8 Blower Motor Control Module Resistor RockAuto

Jan 18, 2018 | 2002 Dodge Durango

Not finding what you are looking for?
2002 Dodge Durango Logo

Related Topics:

413 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

82322 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...