Question about 2005 Kia Sedona

1 Answer

Car starts just fine , I put it in gear and it shuts off . What can my problem be ??

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 34 Answers

Your clutch might not be tight enough, does it jump forward a little before it shuts off?

Posted on Aug 01, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

04 pt cruiser auto. start engine put in gear and drive shifts fine. eng light is on from time of start.


Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem.
Best Manuals

Jan 06, 2017 | Chrysler PT Cruiser Cars & Trucks

1 Answer

Engine revs but no acceleration


Clutch plate and pressure plate seem to be too weak to pull the car. Or one of the CV joints is detached from the gear box. To test the clutch plate, park the car on flat surface. Pull the hand brake up, start the car, depress the foot brake pedal, depress the clutch pedal, put the car in 1st gear, press the gas pedal and leave the clutch pedal at once, while keeping the brake pedal depressed.
Follow one of the two following statements:
1. Engine does not shut down and remain start. (Clutch plate, pressure plate and clutch bearing defective - Replace all as a set)
2. Engine shuts down. (Clutch system is OK and does not require any repair).

May 22, 2013 | Honda Civic Cars & Trucks

1 Answer

Car chokes then shuts off when put in gear acura legend 1990


It could be anything from faulty coils, injectors, head gasket. Did the car over heat? Has it been regularly maintained, is it low on oil?

Jan 11, 2013 | 1990 Acura Legend

1 Answer

1996 mercedes c280 dies when put in drive


Engine stalls or RPM fluctuates at idle up and down or dies near idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Oct 15, 2012 | 1996 Mercedes-Benz C-Class

1 Answer

99 Cirrus Trans


do you have a bad motor mount pulling on the cable?

Apr 12, 2012 | Chrysler Cirrus Cars & Trucks

1 Answer

Car shutting off when put in gear


If the clutch assembly of the car is damaged or has wearied out. It may cause problem to put the gears. The best solution is to replace the clutch assembly.

I hope this will solve your issue.
Good Luck.

If my solution proves useful please accept it.

Regards
Arjun

Mar 30, 2009 | 1996 Pontiac Grand Am

1 Answer

98 Ford Taurus shuts off when shifted into gear.


its in the timing ...whenever you start it it sits and idles fine but when you go to put it in gear it dies...the timing needs to be repaired. its a guaranteed solution.

Feb 13, 2009 | 1998 Ford Taurus

1 Answer

2001 Honda Civic manual will not shift


my old honda did that too. replace the clutch, it's probably the pressure plate.

Dec 24, 2008 | 1995 Honda Civic

Not finding what you are looking for?
2005 Kia Sedona Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...