Question about 1995 Ford Contour

1 Answer

How do I remove the heater blower motor on a 1995 ford contour. It has the 2.0 L 4 cyl.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 6,826 Answers

Blower Motor Switch Resistor Assembly REMOVAL & INSTALLATION Fig. 1: Remove the resistor assembly by gently popping it out of the evaporator housing using a screwdriver how do I remove the heater blower motor on a 1995 - 91056g24.gif

  1. Disconnect the negative battery cable.
  2. Remove the push pins and remove the upper footwell panel from under the passenger side of the instrument panel.
  3. Unplug the connector from the blower motor resistor assembly.
  4. Insert a screwdriver approximately 0.2 inch (5mm) under the edge of the resistor assembly to disengage it from the evaporator housing.
  5. Remove the resistor assembly. To install:
  6. Position the resistor assembly into the housing and snap it into place.
  7. Attach the resistor connector.
  8. Install the upper footwell panel.
  9. Connect the negative battery cable. prev.gif next.gif

Posted on Jul 31, 2010

  • Duane Wong
    Duane Wong Jul 31, 2010

    In 1999 there was a recall on the blower motors not working due to the resistor not working right.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

I have a 95 Ford Contour 6 cyl DOHC, we had ice accumulation last night and stated car ealy this morning and defroster worked fine, ran about 15-20 minutes and it was too early to leave so we shut car off....


the fan may have went out. what your feeling is air coming in as you drive. ford trick for fresh air lol. the fan needs to be tested to see if it has stopped working

Jan 20, 2011 | 1995 Ford Contour

1 Answer

The steps please to remove the heater blower motor on a 1995 Park Ave. The check engine light comes on readily when driving or idling. The numerical external temperature/heater temperature setting...


  • Disconnect the negative battery cable.
  • Disconnect the blower motor lead connector from the wiring harness connector.
  • Remove the blower motor cooling tube from the blower motor.
  • Remove the four retaining screws.
  • Turn the motor and the wheel assembly slightly to the right so that the bottom edge of the mounting plate follows the contour of the wheel well splash panel.
  • Lift up on the blower and remove it from the blower housing.
  • Installation the new blower motor by reversing the removal steps.
  • Connect the negative battery cable.
  • Jan 02, 2011 | 1995 Buick Park Avenue

    1 Answer

    I have a 1998 ford contour and the past few weeks i have smelt somewhat of a burning rubber odor.then all of a sudden my heat wont work any ideas? fuse looks good.looking for ideas before i start replacing...


    If you aren't getting any airflow out of the heater, your blower motor had a sticky bearing and overheated until it blew its thermal fuse, the motor resistor burned out, or something fried in the heater-A/C controller.

    I've never looked under the hood of a Contour, but many cars have the blower motor mounted on the engine side of the firewall, and some of these have the connector out there also. Otherwise, you'll have to crawl under the dash. Once you find the blower connector, you can test the system before you buy parts. First, unplug the blower connector, then (with the car turned on and set so the heater could run if it was working) check the voltage* between the connector pins and ground (not the motor half of the connector!). If you get voltage (which pin has voltage will depend on fan speed settings), then check the motor and any resistors mounted with it. If you don't, look for a separate blower motor resistor, then check the control if necessary.

    *Use a voltmeter (preferred) or a small 12 V lightbulb. The "screwdriver spark draw test" used by some amateurs is potentially hazardous and destructive, especially if there are solid-state controllers in the circuit.

    Nov 27, 2010 | 1995 Ford Contour

    2 Answers

    My Contour is overheating and I beleive it is the thermosta, but I am not usre where it is onthe motor. It is a 4 cyl, Vtech. I have topped off the overfill tank as there is no fill hole on radiator


    Check this procedure for 1995 Ford Contour 2.0L MFI DOHC 4cyl...

    REMOVAL & INSTALLATION
    2.0L Engine (see Figures 1 through 6)

    zjlimited_72.jpg

    Fig. 1: Remove the coolant recovery tank hose from the water outlet


    zjlimited_73.jpg

    Fig. 2: Remove the upper radiator hose from the water outlet


    zjlimited_74.jpg

    Fig. 3: Remove the three retaining bolts for the water outlet


    zjlimited_75.jpg

    Fig. 4: Carefully separate the water outlet from the thermostat housing


    zjlimited_76.jpg

    Fig. 5: Remove the thermostat from the housing


    zjlimited_77.jpg

    Fig. 6: Make sure you replace the O-ring when installing a new thermostat





    I hope this helps top solve it (remember comment and to rate this answer). Good luck.

    Nov 16, 2010 | 1995 Ford Contour

    1 Answer

    Where is the location of the blower motor in a 98 Ford Contour?


    Check the firewall on the driver or passenger side. Look for a wires leading to it in plastic conduit.

    Also, the radiator has a blower motor on it to cool the antifreeze in the summer. That's another motor.

    Jun 28, 2010 | 1995 Ford Contour

    1 Answer

    Heater of my 1999 ford contour is not working. is there a fuse i can replace to make it work?


    There is a fuse under the steering wheel area, also there is a heater conrol under the passenger side dash on the left side of the blower motor. 1 screw holds it in the plenum(heating duct) there is a 4 wire plug going to it. You can check the actual blower motor for operation by putting 12 volts to it. To remove it there are two tabs on either side of the housing.Remove the wire first. Push the tabs up together and turn the fan housing to remove it. You now will have the whole fan in your hands. Using a wire jump from a 12v source(car battery works) to test the fan.2 wires reqd for + and-. if the fan does not function it may need replacing or just lubrication.

    Jan 09, 2010 | 1999 Ford Contour

    2 Answers

    I have a 1997 ford contour and the AC/Heater blower is not blowing air out. Is there a fuse for this?


    fuse in fuse box there are 2 of them 1 under hood marked fuses and 1 under dash or in glove box

    happy hunting and check your book

    Jan 02, 2010 | 1997 Ford Contour

    2 Answers

    My heater only works when i go above 50 miles an hour, and it only blows one speed, what is wrong?


    Having to increase speed to get any heat means that your coolant may be low, as far as only 1 speed, the switch for the heater may not be working properly

    Nov 12, 2009 | 1995 Ford Contour

    1 Answer

    96 ford contour blower fan removal


    You remove the heater blower by removing the bottom cover of the Glove Compartment. Then you will see The heater blower housing. Then you will see like a black clip you need to lift. Then You simply turn clockwise and bingo its off. To install just do the same thing except in reverse mode. Good Luck!!

    Oct 28, 2008 | 1996 Ford Contour

    Not finding what you are looking for?
    1995 Ford Contour Logo

    270 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts

    yadayada
    yadayada

    Level 3 Expert

    76164 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    fordexpert

    Level 3 Expert

    5520 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...