Question about 1991 Honda CRX

1 Answer

Turn key but starter will not engage - 1991 Honda CRX

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 35 Answers

Check your ground wire, they just clip on and the clip wears out over time and gets loose from vibrations etc. Also while you're checking the ground make sure your positive is tight with a 10mm open end wrench. If you check them and they are good you probably need a new starter.

Posted on Jul 31, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2005 GMC Envoy XL. Will not engage starter. Like something electrical. Turn key and nothing. Worked fine until now.


Could be the neutral safety switch if it won't crank in neutral or park, could also be the starter has failed.

Feb 22, 2015 | 2005 GMC Envoy Xl

1 Answer

Good battery, key will not engage starter, jumping starter will not engage drive


jumping across the solenoid will spin the starter but will not engage the pinion in the ring gear. Have a load test done on the battery as I suspect that there is a bad cell and you are not getting a full charge. If the battery is faulty then there is always enough power to turn on dash lights but nothing left to run the high current solenoid and starter.

Dec 23, 2013 | Cars & Trucks

1 Answer

Starter wont engage


either the starter is not kicking out its gear to meet the flywheel or the flywheel has missing teeth. either way the next step is to remove the starter so it can be tested outside of the vehicle and the flywheel can be looked at through the hole where the starter sat.

Mar 05, 2013 | 1987 Ford Ranger

1 Answer

Hi, have a toyota avalon, tried starting the car , it won't start, but then the starter engaged and won't turn off evenwithout the key, disconnected the battery and it stopped , when the batte


It sounds like you have a bad actuator. This is attached to the starter and has a solonoid that pushes the starter motor gears into the engine gear. If the solonoid is faulty this may happen. Also check alignment of the same.

Mar 18, 2012 | 1999 Toyota Avalon

2 Answers

Turn key and starter stays engaged. Turn key off


The starter solenoid is failing. Sooner or later the starter will probably not disengage after you turn the key off. Then you'll have to disconnect the battery in a hurry. It's no fun. And at that point the whole starter will probably have to be replaced. Depending on how long it takes you to unhook the battery. Trust me. That is no way to start your day. It's really bad for your blood pressure. Good Luck.

Mar 29, 2010 | 2006 Toyota Tundra

2 Answers

Ignition on but starter won't engage. Had new key


sounds like you need to relace the starter

Jan 05, 2010 | 1997 Chevrolet Lumina

1 Answer

Ignition/starter failing to engage for multiple turns of key


sounds like the starter has a flat spot on the solenoid. remove and test the starter, replace if necessary.

Nov 06, 2009 | 1993 Volkswagen Fox

1 Answer

1998 buick lesabre wont start


Do you have a Chip in the Key? if so that Could be the Problem,Ya see the chip is a resistor and if it looses its ELECTRONIC VALUE in its Case Resistance it wont start to test this Turn the Key in the ON posission then do the Screwdriver thing If it Starts Key is Good and Most Likely the Ignition (SWITCH) is Bad <<ELECTRICAL Side NOY LOCKEST SIDE For More Info Recontact Me
rejakwilson@aol.com<<<<<<<<<<<<<<<

Dec 23, 2008 | 1998 Buick LeSabre

Not finding what you are looking for?
1991 Honda CRX Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...