Question about Chrysler Town & Country

1 Answer

1997 town&country very intermitantly van will start but stop when key let go.no instraments or overhead trip computer data, odm11 won't connect. This recently happened on a long trip while I was driving I kept going with no instraments while passenger connected code reader that time odm11 gave a p1698 code after about 45 mins came back on its own .

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,272 Answers

Trouble code P1698 means: No CCD Messages Received From The TCM.---------------The P1698 code means that no digital data is being received by the powertrain controller from the transmission control module, located on the right inner fender. The manual says to check the ccd bus wires between the module and the rest of the system using the Chrysler diagnostic readout box. But if you don't have one then I think you can do the same thing by measuring for continuity (near 0 resistance) between pin 4 of its plug and pin 11 of the data link plug under the dash or pin 59 of the powertrain controller plug.
Then check the resistance between pin 43 if its plug and pin 3 of the data link connector or pin 60 of the powertrain controller plug. The powertrain controller is on the opposite side of the engine compartment on the left inner fender. These module plugs are held in place by a bolt. If the continuity between the transmission and the powertrain CCD wires checks to be ok, then according to the manual the trans controller should be replaced. Also take note that you find an honest shop that has a code reader and let them determine for sure that it is the TCM and not the Powertrain control module (PCM) that is the fault. These modules are expensive enough that you would not want to replace the wrong one.
The other symptoms (1-3) are likely related to the problem because they are also dependent on the digital data communication bus for getting their instructions or sending their information. The passenger side window is probably not related to this, but rather a failed connection, switch or motor.
---------- Thanks. Keep updated for any more query. You can rate this solution and show your appreciation.

Posted on Jul 31, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 Chrysler Town and Country won't start. Lights, radio and horn works just fine. Even put in a new starter and still get nothing. Ran a wire from battery to the starter and got a little kick.


Chrysler Town & Country Questions - My van won't start ...

www.cargurus.com > Questions > Chrysler > Town & Country

CarGurusSep 29, 2008 - ckf2004 answered 4 years ago. I have a 96 chrysler town and countrylx and the engine died, turned over but wouldn't start, I researched and replace the flywheel .... My van sometimes won't start because it kills the battery.

My town & country 2004 wont start sometimes - CarGurus

www.cargurus.com > Questions > Chrysler > Town & Country

CarGurusMy town & country 2004 wont start sometimes - My van start doing something really weird. it will ... Asked by TownCountryguy May 03, 2013 at 03:31 PM about the 2004 Chrysler Town & Country Base .... Sometimes you tap it & it won't work.

Van won't start - Chrysler town and country - YouTube

? 1:01
https://www.youtube.com/watch?v=mkEL2vlLZr0
Jun 26, 2014 - Uploaded by Philip Walker
We have the same issue currently...very randomly...with our 2008 Caravan at the moment. Wife just got ...

2011 Chrysler Town & Country Engine Won't Turn Over, Will ...

www.carcomplaints.com/Chrysler/Town_Country/.../engine_wont_turn_...
The 2011 Chrysler Town & Country has 34 complaints for engine won't turn over, will not start. Average repair cost is $902.00 at 58178 miles.

Jan 14, 2016 | Chrysler Cars & Trucks

1 Answer

Why won't my 2008 Town & Country Chrysler Van not start? Shows damaged key.


Security is set. If both keys register damaged. You have either a broken wire(usually by the ignition lockset/switch). Or the computer has died.

Oct 03, 2014 | 2008 Chrysler Town & Country

1 Answer

2003 Chrysler town & country limited


First try and change the fuel filter. this also happened on a van i worked on. I cahnged the filter and it runs fine now.

Nov 16, 2011 | 2003 Chrysler Town & Country

1 Answer

2005 Town & Country Van dead battery after short trips


Possible dead cell in battery, most likely a fault in the charging system. First, Jump Vehicle to get started then remove the Negative cable. If the vehicle dies when you take the jumper cables away or when you disconnect the negative cable your alternator or charging system is faulty. If the vehicle runs without battery connected you have a bad cell in your battery, replace the battery.

Dec 12, 2009 | Chrysler Town & Country Cars & Trucks

2 Answers

I cannot start my 1997 chrysler town & country minivan. When I try to start it I get a "alarm set" reading. It starts for a minute then cuts off. HELP. I AM STRANDED.


I have a 97 Chrysler Town & Country Van with 104000 miles on it. The past two months the van will not start and run after driving for a while. Let it set for about an hour and it will start and run fine. When it does not want to run it will start and run for about 5 seconds then quit. During this time the dash instruments will not display but the radio, windows, and lights work just fine. The battery was replaced with in the past month so I don' t think that is the problem. Any seggestions?

Mar 11, 2009 | 1997 Chrysler Town & Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...