Question about 1999 Mercedes-Benz C-Class

1 Answer

I have merc c240 1999 model the car went into a limp mode we have replaced the electronic plate at the bottom of the gearbox after a month it did the same problem they replaced the ms sensor one week later same problem what can i do

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 170 Answers

Possibly a bad ecm throwing codes/ because it cant monitor the problem correctly if its defective

Posted on Jul 31, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I just replaced the transmission control module in my 2001 Chrysler voyager and now it seems to shift sometimes and sometimes it seems to be stuck back in limp mode?????????????


Whenever you service an electronic transmission gearbox you need reset the memory soon after and before using it you go to the transmission mode then erase all errors

Sep 29, 2017 | Chrysler Cars & Trucks

1 Answer

Mechanics advised that gearbox needs replace after diagnostic Of codes . Dash light still on after codes being read , have had ecu replaced 2yrs ago ? What do you think it could be , thanks phil


didnt specify vehicle --generic answer--until repair is made the vehicle will show engine light and have codes --if gearbox is problem for limp mode /until repairs are made or gearbox replaced you will be in limp mode --and as to sensor find out what one it was --start problem may show back up if sensor was problem --and GET a 3rd opinion you have 2 mechanics with different opinions on your problem and i guess they are reading your trouble codes differently

Sep 20, 2016 | Cars & Trucks

1 Answer

Gearbox


needs connecting to merc star computor

Mar 22, 2014 | 2003 Mercedes-Benz C-Class

1 Answer

2010cruize cdx went into limp mode, dealer tells me spark plugs misfiring caused the coils to burn out is this right


HI, I never hear the plug misfiring can burn the coil.
With this new cars if something wrong the gearbox shift to limp mode for not get more damages. you need to stop your car. You can diagnosis to find out what its wrong.

Mar 03, 2014 | Cars & Trucks

1 Answer

Hi my transit van t350 53 plate has went into limp mode after engine change can you tell me what's up


Sorry dealer only to read the software ,unlike the old V4 2.0 litre or the OHC engine .then the good old workhorse with the 2.4 york diesel these vans have become so complicated with the electronics i am at a loss .I remember when these vans first hit the market and they were great for bank robberies as they outran the police noddy cars ,and put a zodiac or capri V6 engine in one ?? with a mkII zodiac diff unit and on the motorway -- well fast

Dec 17, 2013 | Cars & Trucks

1 Answer

C180 merc


dont do that anymore ur rev limiter is cause that flux in accelerated idle you are haveing a miss meaning u need a full tunup plugs,wires,ignition coil packs and air filter

Jun 08, 2013 | Cars & Trucks

2 Answers

I have a 2007 MB C230 with approx. 61k on it. The other day the car went into Limp Home Mode, I'm assuming from what I found in my manual atleast. When trying to accelerate from a Stop the car barely...


Hello.

There are many reasons for your car to go into safe mode: turbo, air mass sensor, gearbox, EGR...

The best thing to do is a computer diagnosys. Check your ECU for errors and then we will decide the course of action.

May 19, 2011 | Mercedes-Benz C230 Cars & Trucks

2 Answers

02 mercedes clk430 stuck in limp mode. Transmission has been rebuilt, we have no power to the speed sensor, we changed the connector plate and the car is still in limp mode what can be wrong? all fuses are...


HI

Since you have rebuilt the transmission it is suggested to replace the speed sensor,this is the cause that your car is stuck in limp mode.

Let us know if you want to know somethin more else accept the suggestion.

Thanks for contacting fixya.com

Apr 27, 2010 | 2001 Mercedes-Benz CLK-Class

1 Answer

Xr6 going into limp home mode when car is turned


theres a solenoid that selects gears it can trick the gearbox into limp mode, id have that checked before spending big money i spent 6000 on a new gearbox (not standard price i had a heavily modified gearbox) because the standard gearbox did the same turns out it was an $80 solenoid, i found out after forking out the money. any ford dealer should be able to plug it in and run diagnostic checks for you

Jan 20, 2010 | 2005 Ford Futura

Not finding what you are looking for?
1999 Mercedes-Benz C-Class Logo

225 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Marvin
Marvin

Level 3 Expert

81285 Answers

Joseph Prosser

Level 3 Expert

772 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...