Question about 2004 Chevrolet Impala

1 Answer

When come to a stop put foot on gas car jerks before going foward or backwards

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 40 Answers

Check the transmission fluid level

Posted on Jul 31, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a Toyota Fielder car,but I face a challenge each time I stop up hill and want to drive forward, the vehicle rolls backwards despite being in D-drive. What should I be doing to avoid this?


This is when you need to let the clutch out just enough to stop the backwards roll when you take your foot off the brake, then you can move to the gas pedal and when pressing the gas pedal you can release the clutch all the way to get moving. IT is a matter of practice and timing..

May 17, 2018 | Toyota Cars & Trucks

1 Answer

Beeping noise, jerking, and then shuts off


if the beeping is coming from under the dash panel it may be the main fuel pump relay also I would check all the battery and engine grounds

Nov 15, 2013 | 2007 Volkswagen Jetta 2.5 Sedan

1 Answer

I have a 2005 suzuki forenza and when i am driving my car jerks violently and while my foot is on the gas pedal the engine does not go the engines just revs up so i let my foot off the gas pedal until it...


check your transmission fluid levels and add if low..also using a white paper towel, wipe some fluid off the stick and see if any contamination is present like blackened gunk and aluminum shavings..this is a sign that the fluid and filter need changed..

Feb 15, 2013 | Suzuki Forenza Cars & Trucks

1 Answer

****** jerks at take off 05 impala


HAVE SOMEONE WITH A FLASH LIGHT LOOK UNDER THE HOOD WHILE SOMEONE ELSE INSIDE THE CAR HAS 1 FOOT ON BRAKE AND 1 FOOT ON GAS KEEP GOOSING THE GAS WHILE IN DRIVE THEN SWTCH TO REVERSE GEAR AND SEE IF MOTOR MOVRES ALOT IF SO BAD MOTOR MOUNTS

Aug 08, 2012 | Chevrolet Impala Cars & Trucks

1 Answer

Golf SE 1.8l 1781 cc auto, constant jerking. Have tried all possibles suggestions but still not fixed


try this to see if it gets any better,from stop.put into drive and let car accelerate without gas(do not touch gas pedal) around 30/35 mph is about right.STOP.then use 1/3rd gas(keep foot still)and do same(around 60/70 mph)STOP. then foot to floor and go to max legal speed.then back off to 1/3rd pedal.then stop.you have just reset computerised gearbox settings.(only use 1/3rd gas for about 250miles,and you will feel the difference(boring)but saves you a fortune in fuel costs.and if you still have problem put on diagnostic to check out.

Aug 11, 2010 | Volkswagen Golf Cars & Trucks

1 Answer

1993 jeep cherokee sport 4wd, when i start it the engine runs strong, i put my foot on the break and put it in a gear (this is in both 4wd and 2wd) and it still runs with my foot on the break, but as soon...


Will the car move at all. If you put it in gear and let your foot off brake , does it move untill you touch gas , or does it jam up as soon as wheels start to turn. I am suspecting problem with diff.
Doubtfull about trans filter.

Apr 15, 2010 | 1993 Jeep Cherokee Country

1 Answer

FUEL FILTER REPLACEMENT-HELP!!!


look over rear end it is by the gas tank .you need to spray ihe fittings with wd40 or P B blaster it works alot better than wd40 to help loosen the fittings

Oct 23, 2008 | 1996 Chevrolet Beretta

Not finding what you are looking for?
2004 Chevrolet Impala Logo

188 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...