Question about 2004 Kia Rio

1 Answer

Car stop running when stop at a red light try to restart only clicks, batt. is hotbut some of the eletrical are not working right, flasher for one.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 432 Answers

Almost sounds like you ran out of power, test the battery check all of your fuses, then if nothing check your alternator youre lacking power so track back to its source and work out from there, not a big task just time consuming

Posted on Jul 31, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Right turn signals work but left signals don't work


Front right and rear right are on a different circuit than the left front an left rear. Locate the Flasher control module behind dash. With key in RUN position check for pulsing battery voltage on the Green/white wire coming out of the flasher control module electrical connector. If no battery voltage, check for battery voltage coming into the flasher from the turn signal switch on the white/red wire. Left turn input is on the white/black wire. If not battery voltage on white/red, but voltage on white/black when turning left, then the turn signal switch is bad

Dec 05, 2017 | 2002 Mazda Protege

3 Answers

On a chevy traverse i cant get the windows to work. i cant get key out of ignition, and right rear blinker doesnt work


Fuse under the right passenger dash. Fifth up on the right (blue 15 amp). It is called BCK/UP/STOP. All the same symptoms short in wiring harness for the trailer package caused the windows not to function, the right rear turn signal had no power, and the key was stuck in the ignition.
7_17_2017_9_57_25_pm.jpg

Dec 02, 2012 | Cars & Trucks

1 Answer

When I approach stop light and press in clutch to shift down, car stalls. Battery light comes on. Sometimes will restart and be OK until next stop, other times will not restart until it "rests"...


if it is cranking and starting back i would say its not a batt or alternating problem

most likely the reason the batt light is coming on is because its idleing rough as it quits running if it were me i would just drive it to a dealer and save the toe bill

Jan 23, 2011 | 2005 Volkswagen New Beetle

1 Answer

Control ?i have a 1997 s10 pick signal flashers ( right and left ) stopped working, fuse replaced no go, all other electrical working ( brakes /emergency flashers etc) what do you suggest mission


The flasher may have gone bad for the turn signal, and there may be a second flasher for the emergency flasher lights. Look and listen for a click of the flasher for the emergency flasher lights. Then, the other flasher is the one to replace.

Good luck on this repair.

Dec 18, 2010 | Chevrolet S 10 Cars & Trucks

2 Answers

Turn signals aren't working but flashers are


that is because they run off different systems, they both have thier own relays, normally the common fault with flashers not working is either, fuse, or relay (flasher repeter unit), if you turn your turn signals left or right can you hear a click click click noise? if not its your flasher unit, hope this helps

Feb 01, 2010 | 1994 Chevrolet S-10 Blazer

1 Answer

Turning Lights Not Working


If you put a 2 element bulb in a single bulb elemet socket you would or could destroy the flasher unit. Especially if it is a electronic flasher try replaceing the flasher but get mechanicl flasher they last longer.

Jul 09, 2009 | 1998 Toyota Sienna

1 Answer

New trailer wiring for my 06 Nissan Maxima wont work on traile


Have you tried a heavy duty flasher? Also, if your signals & brake lights are 2 different bulbs, as in amber for signals & red for stop, then you will need a small in line converter to separate those 2 as most vehicles use same bulb for signal & stop.

Jun 15, 2009 | 1998 Ford F150 Regular Cab

1 Answer

Left flasher dead, right on works


double check your bulbs again, if still good
check your flasher

G

May 09, 2009 | 2005 Jeep Wrangler

1 Answer

Some kind of eletrical problem


unhook the batt and let it sit for a few mins while the batt is off turn on headlights running lights and press the horn to drain any residual power from the computer, then rehook it , this almost sounds like a bad switch or wire harness

Jun 13, 2008 | 1989 Toyota Camry

Not finding what you are looking for?
2004 Kia Rio Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Marvin
Marvin

Level 3 Expert

81400 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...