Question about 2005 Mercury Monterey

Open Question

My 2004 Mercury Monterey has the following problem. Both the left and right outside mirrors do not work, the drivers power seat does not adjust, the pedals do not adjust, pedal memory does not work, drivers side air conditioning temp does not adjust. This all has happened since the torque converter was changed. Any common item such as a relay or wiring harness or connector, All fuses check good

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: 1999 cougar brake lights not working Fuse+bulbs+switch ok

I am asking you what switch you cheked and how did you know that is ok and working I had the same problem I replaced the switch under the brake pedal and it works fine if you still have this problem write to me @ absi20@hotmail.com thank you good luck.

Posted on Feb 06, 2009

Ad
  • 398 Answers

SOURCE: What are the suggested service items for a 60,000

transmission fluids filter, fuel filter, air filter, oil change, spark plugs , wires,radiator fluids, inspect underneath for wear and tear

Posted on Feb 26, 2009

inhisname
  • 76 Answers

SOURCE: no power to tow wiring harness

hello, if the vehicle came with factory towing, i has the relay already....sometimes they ship however without the fuse. the fuse should be behind knee panel on driver's side labed TOW or TRAILER good luck, marty

Posted on May 27, 2009

  • 5 Answers

SOURCE: liftgate on van not working at all

There are 2 support shocks that support the lift gate. You need to replace them. One or both of them are no longer supporting the door. Your local auto parts store will have them in stock. Compare prices with competitive stores, prices vary depending on where you purchase them from. It't really easy to replace them.

Posted on Sep 03, 2009

  • 97 Answers

SOURCE: 2004 Mercury Monterey 70k CEL code PO401

po401 egr flow insufficient vaulve could be stuck or disconected

Posted on Mar 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why is my 2004 mercury monterey wont start and before that the power sliding door stop working?


If door is open , interior lights may be on and killing the battery. The door switch may be bad and that may be why the door wont close.

Mar 16, 2017 | Mercury Cars & Trucks

2 Answers

Where are the fuse boxes located a 2004 mercury monterey?


I know there are at least two. The first being under the dash to the left. Second being in engine bay above the driver side tire.

BIll

May 29, 2014 | 2005 Mercury Monterey

1 Answer

Memory seats adjust on there own as well as mirrors


BCM has nothing to do with this function , MMM - memory mirror module !
Memory Mirror System Operation
The MMM is capable of storing mirror position for 2 different drivers. Mirror position is determined by both horizontal and vertical position sensors in each of the power mirrors. The MMM supplies a reference voltage and a low reference to these sensors and determines mirror position through the horizontal and vertical position signal circuits.
The MMM receives power through the battery supply voltage circuit and the MIR/LOCK fuse and a constant ground source. Any time that battery voltage is disconnected and then connected from the MMM, the MMM will enter the mirror relearn mode. The mirror relearn mode can also be commanded using a scan tool. Refer to Memory Mirror Module Learn for further information.The memory switch receives power through the battery supply voltage circuit and the MIR/LOCK fuse. The MMM upon receipt of a memory switch signal input, a class 2 message from the SIC or a class 2 message from the PCM indicating that the transmission is in park, will then supply battery voltage and ground to the appropriate power mirror motors through the mirror motor control circuits to move the mirrors to the predetermined positions.

DTC B1586, B1596, B1616, or B1626
The mirror horizontal and vertical position sensors are potentiometers. The Memory Mirror Module (MMM) provides these sensors with a 5 volt reference circuit and a low reference circuit. The MMM monitors the horizontal and vertical position sensor signal circuits which change values based on mirror position. These voltage values are used to determine mirror position and can be set into memory. When the MMM receives a memory recall request, the MMM will control the power mirror to the memory position based on the horizontal and vertical position sensor signal values.

Install a scan tool.
Turn ON the ignition, with the engine OFF.
With the scan tool, observe the mirror horizontal and vertical position parameters in the Memory Mirror Module (MMM) data list.
Operate both the left and right mirrors through the full range of movements.
Does the scan tool indicate that the left and right mirror horizontal and vertical position parameters are within the specified range?

Memory Seat System Components
The memory seat system consists of the following components:
• Power seat switch assembly
• Memory recall switch assembly
• Horizontal adjuster motor
• Front vertical adjuster motor
• Rear vertical adjuster motor
• Recline adjuster motor
• Memory seat module
• Memory mirror module
• SEAT 25A circuit breaker
• MIR/LOCK 3A fuse

Your best bet , take it to a qualified repair shop !

May 23, 2017 | 2002 Cadillac Escalade

1 Answer

My right mirror on 325 i 2005 doesn't work. When i change my seat position with the memory, the seats goes on but not the mirrors. I can adjust my left mirror but not the rigth one; it never move.


I would safely assume your right mirror may be inoperable period then by your statement you are leaving the switch for the mirrors in the middle during switching correct and during adjustment are switching to R/L mirror on the switch? Mirrors are on the same circuit so both should be operable. Have the mirror checked for operation before heading any further. I Think you will find during this its unplugged from its source of power or inoperable period and needs replaced. Remember to rate my solution and leave testimonial PS please purchase you a Owners Manual for your car you will thank me later.

Oct 09, 2012 | 2005 BMW 325i Automatic

1 Answer

2004 mercury monterey liftgate latch will not release


2004 mercury monterey liftgate latch will not release.

May 11, 2012 | 2005 Mercury Monterey

1 Answer

2004. What causes erratic radio and CD player operation?


Mercury Monterey Audio - Radio, Speaker, Subwoofer, Stereo

www.crutchfield.com/.../Mercury-Monterey-Ster...

Crutchfield CorporationCrutchfield - Seriously into audio since 1974 ..... Find car audio products that work with your Mercury Monterey ... 2004 - 2007 Mercury Monterey: Best Sellers .... time to talk to you through installation snags, troubleshooting, or everyday use.

Mercury Monterey Car Stereo Removal and Repair 2004-2007

? 2:45
https://www.youtube.com/watch?v=DhSfvjoLGPU
Dec 6, 2012 - Uploaded by Factory Car Stereo Repair
F R E E - R E P A I R - E S T I M A T E S http://www.carstereohelp.com/ford.htm.

Jan 27, 2011 | Mercury Monterey Cars & Trucks

1 Answer

Mercury monterey 2004 rear view mirrow on and off ??


Automatically adjusts the mirror to prevent glare from blinding you if a car with high beams suddenly pops up behind you

Mar 27, 2009 | 2004 Mercury Montery

2 Answers

2005 Mercury Monterey van - fuse location


Hello Kevin I hope I can help you find this fuse and fix this for you.The fuse location number should be 63 it should be a 30 amp fuse.I don't know if your manual will show you this location but I do hope it does.But if not I'll do my best to try and help you find it.In your fuse box look about middle ways in it.I hope you see a line of the standard small size plug-in fuse's a row or 4, just below those should be a row of 2, the row of 2 is what your looking for fuse number 63 is the one on the left if your looking straight at the fuse box, or the one on the driver,s side it should have 30 amp on it.Check that fuse or just replace it.I hope that was helpful Tim

Oct 09, 2008 | 2005 Mercury Monterey

Not finding what you are looking for?
2005 Mercury Monterey Logo

Related Topics:

292 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

fordexpert

Level 3 Expert

5522 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...