Question about 2002 Nissan Sentra

1 Answer

Remove sterio for repair

How do I go about removing the sterio for repair or replacement?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Nissan Master
  • 81,342 Answers

1) Pull bottom trim panel below heat/AC controls. Securing clips will release.
2) Open top pocket above AC vents, grasp inside of pocket and pull assembly toward you. Securing clips will release.
Push emergency flasher switch out through front of panel and disconnect plug.
3) Remove two screws from top of radio, one on each side. Remove two screws from bottom of heat/AC panel, one on each side. Remove two screws from bottom of pocket under this panel.
4) Pull radio and heat/AC control panel from dash and release connectors and antenna. Radio mounts to assembly with two screws on each side.

Posted on Jul 31, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have bought c200 1995 second hand car, after replacing its battery i'm not able to use its sterio system. Any soluton?

go to benz dealer and they will run radio number on some older models the audio unit must be removed to get the numbers to get code info, or go and get aftermarket unit installed.

Jul 31, 2012 | 1995 Mercedes-Benz C-Class

1 Answer

How to reset a sterio on a 2003 ford explore sportyrac

look in the fuse box see if you have one for the radio. i had the same problem when i had a dawoe car. went back to the dealer a and showed me the fuse. just remove and replaced. like reset the car

Dec 14, 2011 | 2003 Ford Explorer Sport Trac

1 Answer

How do you remove the kenwood kdc mp205 sterio from the vehical

there are two little slits behind the front facia cover just slide 2 flat pieces of metal inside an pop out it comes #

Sep 15, 2011 | 2006 Nissan Versa

1 Answer

How do i take out the original sony sterio from my

look closely at dash board you gonna see small screws (around radio area ) take that face off then you see other screws that hold radio in place remove them radio gonna come out ,,,good luck

Mar 03, 2011 | Volkswagen Golf Cars & Trucks

1 Answer

Just bought a 1999 f150 pick up. the guy said he was having a charging problem and replaced the battery and altonator. He had a big sterio in it and removed that so right now it has no sterio. He had it...

Start with having the alternator tested ( out of the truck, not just a meter test like Autozone would do ) and have the battery load tested.

Could be the alternator field fuse is blown, this is the 20A fuse in the same block as the mega fuses on the firewall.
Also check the connector at the alternator to make sure it is in good shape, some times the connector will get gummed up.

Jan 01, 2011 | 1999 Ford F150 Regular Cab

1 Answer

I dont know how to remove the dash to get behind the sterio. how do i remove the dash?



Dec 02, 2010 | 2000 Chevrolet Monte Carlo

2 Answers

Replace factory radio on 2002 yukon xl

all you gotta do is carfully pry the dash panel off (prying from the far left end is easiest) completely remove panel. then there are 2 clips that hold the factory sterio in place. push on the both clips while pulling the radio out. simply disconnect the wiring harness from the back of the radio. using an adapter avaliable at your local radio shop (scosche p/n gm02, mdarb and gm1483b) wiring harness, dash install kit, and antenna adapter. then simply match the colors on the new radio's harness to the adapter harness, crimping each connection with a "but plug". then simply follow the instructions included with the dash install kit to assemble the kit.connect the antenna adapter to radio, plug in all cables. test to see if everything works properly before the final install. install sterio into dash install kit, re installing kit where origional radio was. then simply put the panel back in its place by firmly pushing on it untill it snaps into place. then enjoy your new radio!

Dec 29, 2008 | 2002 GMC Yukon XL

1 Answer

Radio removal

Don't know if the info will be there but
All things Capri are at //
The manuals are there - check them out ...
Maybe radio removal is there ....

Dec 28, 2008 | 1991 Mercury Capri

1 Answer

Need sterio wiring diagram for 1997 1500 gmc p/u ,factory harness

DON'T REMOVE FACTRORY CONNECTORS!!!!!!!!!!!!!! Spend $15 and buy a wiring kit. It plugs right into your vechile wires and the kit tells you what wires are what. Splicing the wires will lead to headaces down the road!!!

Dec 08, 2008 | 1999 GMC Suburban

Not finding what you are looking for?
2002 Nissan Sentra Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

81294 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides