Question about 1993 Mitsubishi Montero

1 Answer

Engine not starting replace alot of part and still wont start

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 79 Answers

Need to post what you have replaced to no wear to start. check the fuel pump make sure u can hear it come on.

Posted on Jul 31, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Car cranks but wont start unless starting fluid is sprayed into the throttle body. Once it starts it stays on and runs good.


I would also replace coolant temp sensor, they arent very expensive and cause alot of issues

Oct 05, 2015 | 1991 Toyota Celica

1 Answer

Replaced brain box on 2000 dodge neon but still wont start


did the check engine light tell you there was a pcm fault or something else before you did the swap? Alot of things can cause a no start. A bad crank position sensor(CKP) cam position sensor(CMP) fuel pump. My brother-in-law did that to a dynasty and turned out to be a broken wire on the CKP circuit.

Jun 04, 2013 | Dodge Cars & Trucks

1 Answer

2006 Ford F350 diesel fuel problem will not start all the time.


okay i have the same problem sometimes it will start ok sometime it will not so had to put a rag in the air filter with gas on the rug to starts it but it does alot of hesitating when you're driving it. it just started doing hesitating now its doing this idoling up and down and when you crack it over alot the check engine light come on when it running but eventually it tunes off i was thinking about changing the fuel filters again to see if thats the problem because i think it started when i change the fuel filter i need a little help

May 15, 2012 | 2006 Ford F 350 Super Duty

1 Answer

My engine wont rev when warm


possible engine internal damage from the cold
have a compression test done
try testing the boost pressure from the turbo as it may not be working
excessive smoke and low power indicators
starts and runs cold is not indicated that it is a pump

Apr 06, 2017 | Cars & Trucks

1 Answer

1988 ford f250 302v8 5speed 4wd. truck wont start. has good fuel pressure and compression. i grounded one of the plug wires and got a nice fat orange spark. if left to sit for a day or 2 it will run when...


First of all. you have to line up the rotor to the number one distributor tower with the engine at O" TDC, so your timing probably was initially correct. Sounds like you are getting TOO MUCH FUEL. Could be fuel pressure regulator located on fuel rail. Also your plugs are probably fouled too from all the excess fuel.

Jan 23, 2011 | 1989 Ford F 150

2 Answers

Jaguar xj8 wont start after replacing timing chans


I'm sorry to tell you this, but you are going to have to start from ground zero. Take your timing cover back off. Ensure that your NO. 1 Piston is at TDC (Top Dead Center) and that your cam is aligned properly. Once you've done that, put the timing chain back on and bolt everything back together. If your timing is off a little bit, your engine won't run. If your timing is off alot, then your valves will hit the piston heads and cause ALOT of damage.

Feb 08, 2010 | 2000 Jaguar S-Type

1 Answer

CAR WONT START


If the car fired after pouring gas into the engine, then you should check your fuel pump, listen when you turn on the key, if you hear the fuel pump start and stop, then check your fuel pressure, all fuel injected vehicles have fuel pressure regulators, if your fuel pump isnt pushing enough pressure to the regulator the car will not start, and if it does start it wont operate properly, and may even leave you stranded.. If your fuel pressure is low, check the fuel filter, dirty filters restrict pressure, and are ALOT cheeper to replace than a fuel pump!

Sep 27, 2009 | 2001 Ford Focus

1 Answer

My 1999 f150 wont start


Go back to your battery connections and make sure they are clean. If you recently replaced terminal ends, pull on the wires and see if it cranks.

Sep 20, 2009 | 1999 Ford F150 Regular Cab

1 Answer

Wont start up...


Check for a bad ground from battery to engine. Then check the module inside of the distributor cap. It should be a black crescent shaped unit about three inches long that all the wires plug into.

Jan 19, 2009 | 1998 Chevrolet Blazer

Not finding what you are looking for?
1993 Mitsubishi Montero Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...